Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

13/11/2024

 Ford mobilesolutionsar (280Pts.)

0

2017 F350 Super Duty Evo all 1 key programmed successfully but won't remote start

Upon trying to remote start the red and yellow come on and blue blinks 1 time but not start. Stick key and turn forward, yellow light comes on. What am I missing?
Login to reply View 1 answer(s)

13/11/2024

 Mitsubishi Walid Al Shabib (280Pts.)

0

Engine shut off

“I am writing to report an issue with my car’s remote start and shutdown process. When I press the lock button on the car key three times, the car starts remotely, as expected. However, after entering the car by pressing the unlock button, I encounter a problem: when I press the ‘Press to Start’ button twice in succession and then press the brake, the engine shuts off immediately, and the message ‘Wegfahrsperre’ appears. Could you please help me understand and resolve this issue?”

FORTIN EVO-ONE-MIT2 EVO-ONE + T-KABELBAUM

Mitsubishi Outlander 2016 

Login to reply View 1 answer(s)

13/11/2024

 Volkswagen Dennis.daraphone (130Pts.)

0

Fortin Evo-ALL will not program

2018 VW Tiguan Standard Key, Automatic Trans, no Heated steering wheel I have the THAR-VW6 installed correctly. The EVO-ALL will not program. When trying to program, I hold down the programming button and connect the data link cable, light goes to blue, I release, all 3 light flash. I have an R-link and a Flashlink. I've flashed the EVO-ALL with the correct firmware. Service# 001A07 367521 Please help.
Login to reply View 1 answer(s)

13/11/2024

 Nissan Green (130Pts.)

0

Could this remote start make body control module failures?

I had this remote start since 2018, Last week I went to local nissan dealer for a extra key and key programming, after they attempted, the technician told me the body control module was failure because the after market fortin remote start, so I needed replace BCM, were they correct? And can I put remote start module back?
Login to reply View 1 answer(s)

12/11/2024

 Hyundai Christopher Barrow (130Pts.)

0

2013 Hyundai Genesis Coupe auto- Alarm going off after remote starting

Had the EVO ONE installed for about a year with all the functions working. The engine locked up and after the dealer replaced it everything still works except when you remote start about 20ish seconds past and the car alarm will go off. I've tried changing some settings, the master reset ( plug in the big connector and let the button go when its red then hold again until it cycles) then flashing it again still no change. I checked the wiring and found no breakage or cuts. 2 things I've noticed is that if I'm trying to do the KEY BYPASS PROGRAMMING PROCEDURE after I get solid yellow and I plug in the rest of the connectors and turn the car on the light does not change, tried about 4 times, but when I do the PROGRAMMING VEHICLE WITHOUT PATS DATA WIRE (even thought I did the PATS wiring like the diagram said) I get through all the steps no problem and end up with the original issue. 2nd thing is when I remote start it unlocks then locks and starts (like it should) then after a couple of seconds it locks again which I feel like its arming the alarm because I tested unlocking the car after that second lock and around the time the alarm would normally go off it doesn't but what happens is the car relocks its self then after some seconds the alarm goes off again. Also note if I turn the alarm off the cycle of the car locking itself again then the alarm going off will continue forever until I either disable the remote start or put my key and turn it to the on position To me its sounding like the EVO one isn't acting like the "key" which points to the key bypass Issue and I cannot seem to find a forum about the problem I am having
Login to reply View 1 answer(s)

12/11/2024

 Chevrolet Kurt Wilson (130Pts.)

0

2013 Chevrolet 2500 HD -Starts once then won’t crank

I have installed Evo All SN 001A07 468692 with T-Harness THAR-GM4 withRM942 remotes and MYCAR using hrn-11rs-01. The factory remotes work as well as the 942. The truck will start once using the remote start and then just light up and “click”. If I unplug the module it will work again. From reading through the messages here I believe the issue is that I have flashed it too many times. Any help would be great
Login to reply View 1 answer(s)

12/11/2024

 Toyota Max (130Pts.)

0

Remote start works but can’t unlock/lock the doors

Hi, on my 2014 toyota yaris, everything was working fine up to a few months ago, but now once remote started , the doors won’t lock/unlock and the lights are flashing on the dash but nothing happens. When engine shut down door lock/unlock fine without engine running. I think it is a fsa-206.
Login to reply View 1 answer(s)

12/11/2024

 Scion Isaiah Byrd (130Pts.)

0

Will the EVO ONE work on my 2016 Scion tC with push button start?

Hi, I see the EVO ONE should work for my 2016 Scion tC but the trim level states standard key. The 2016 model only came with Push to start. No manual key option. Will this work? If so, which T harness should I use? Car is also manual if that matters. Thanks
Login to reply View 1 answer(s)

09/11/2024

 Lexus G M (14910Pts.)

0

2017 LS460

Hello. 2017 LS460 not on the list?
Login to reply View 1 answer(s)

09/11/2024

 Volkswagen Billy Skarpas (130Pts.)

0

Dcryptor limit reached while programming

hi i was programmig my newly bought EVO-VWT3 system, and both times programming it would stuck on yellow and red flashing... now i have reached the dcryptor limit... can we reset this please, SN: 001A07 367315
Login to reply View 1 answer(s)

09/11/2024

 Hyundai Inno Laur (130Pts.)

0

EVO One RFK441 2010 Hyundai Tuscon, regular key. Remotes only work every so often.

Everything programmed correctly as per the guide, no issues there. The remotes, even though they are one way, seem like they are acting as a 2 way remote. Both remotes programmed correctly on initial setup. Sometimes one of the remotes will work correctly to lock and unlock the doors, the LED on the remote giving one initial flash, then 5 quick flashes and the function works on the car. Other times, you push the lock or unlock, and all you get is a single flash, and no response from the car. It is very random, sometimes it's one remote, sometimes it's the other. Sometimes when I pick up one of the remotes, I see the LED give a single flash, but I haven't pushed a button. After a period of time, they both seem to start working properly to lock and unlock the car. Once that happens, you can remote start it once. Sometimes you can shut it down with the remote, sometimes you cannot. After that, neither one of the remotes will work at all. They go back to a single LED flash when the lock or unlock is pressed. Eventually one of them will start to work, then the other.........This has to be the strangest behavior I've seen from an RF remote.
Login to reply View 1 answer(s)

08/11/2024

 Nissan mobilesolutionsar (280Pts.)

0

2016 Nissan Altima PCM humming sound and park lights staying on

Installed compustar alarm with remote start using a EVO-NIST4 and diagram75491, d2d cable being used. For some reason the PCM is humming and the park lights are on, what can be the issue? Do I change out the power wire fuse to a 1 amp since it comes with a 30 but I am not using those, just the D2D as the diagram says.
Login to reply View 1 answer(s)

08/11/2024

 Chrysler Oleg Kalan (130Pts.)

0

Chrysler Pacifica & int-sl+ problem

Hello! I have a few questions about installing int-sl+ in Chrysler Pacifica 2004. 1. Should I do step 5 when programming if I don't use data link? (hardwire connection) 2. What does the note "Can be proggrammed 5 times max." mean in the instructions (at step 7) and what happens after more 5 attempts on the same machine? 3. In programming process on step 7 the LED flash a few times and turn off. I think the interface is programming. The engine is running by remote start, but stopping after 1-2 seconds. The immobilizer LED flashes, indicating that the key is missing. The diode on the INT-SL+ is constantly off at startup. If i put the key near barrel, the engine running correctly without stopping. What do i incorrectly ?
Login to reply View 1 answer(s)

05/11/2024

 Infiniti Vadim Rudnitskiy (130Pts.)

0

2012 Infiniti EX35 Heater Not Blowing Hot Air

I have Linkr LTX LT3 paired with Evo All NIST1, everything is connected correct vehicle starts with 3x lock or using App. My question is where in the flash settings do I got to enable heater to work. Because when starting the car all i get is air but heater not working until i press the brake pedal then you can feel hot air coming. Please advise thanks!
Login to reply View 1 answer(s)

05/11/2024

 Skoda G M (14910Pts.)

0

Function D2

Hello. I installed evo-all on a 2022 Skoda Superb... (I specified a 2021 Golf... I connected the CAN under the steering wheel, orange-green and orange-brown... the start-stop wires were blue and purple) I did not enable the D2 function... After all, we still open it with remote start... Lock-Unlock-Lock... It is possible not to turn it on, right?
Login to reply View 1 answer(s)

03/11/2024

 Nissan Tu Le (390Pts.)

0

what is the option to set for the car to locked and shutoff the parking lights after the remote start timeout (15mins).

Vehicle: 2018 Nissan Rogue Sport SN: 001a07 531903 Problem: remote start the vehicle (3x locks), car started with no issue. However if I don't make it to the car after 15mins, vehicle shutoff as expected, but the vehicle has unlock and parking light kept stay on and kill the battery. Is there setting on this unit to prevent this 2 issues. (locked after shutoff and turn off the parking light) Appreciated your help!!!
Login to reply View 1 answer(s)

03/11/2024

 Chevrolet Francisco Romero (130Pts.)

0

Can't find lock/unlock wiring

Working on a 2010 Chevy Traverse, photos show the pink and orange wire at the Bcm but it this situation those wires aren't there, I try to find some others but can't yet.. Evo RS4
Login to reply View 1 answer(s)

04/11/2024

 FAQ ALEX Garbuzenko (600Pts.)

0

Flash limit

Hi! Could you please reset flash limit sn 001A06 520354. Lost keys of car, make new keys, now we need flash module. Thanks
Login to reply View 1 answer(s)

03/11/2024

 Mazda Engomar (180Pts.)

0

Please reset EVO-ONE Programming reach limit: SN : 002B04 676425 and i cant start by remote like when i buy it

Mazda 6 2016 Thank you
Login to reply View 2 answer(s)

03/11/2024

 GMC FABRICE (130Pts.)

0

GMC regular cab WT 2024

Bonjour, je viens d'acheter un GMC regular cab WT 2024 push strat, et souhaiterai mettre un demarrage à distance qui fonctionnerai avec la téléommande d'origine, merci de votre réponse. Fabrice
Login to reply View 1 answer(s)

03/11/2024

 Mazda Engomar (180Pts.)

0

Please reset EVO-ONE Programming reach limit: SN : 002B04 676425 and i cant start by remote like when i buy it

Mazda 6 2016 Thank you
Login to reply View 2 answer(s)

31/10/2024

 Chevrolet Jeff Cates (290Pts.)

0

Where to start?

Ok, fighting this thing for months. I bought a new module, programmed it, installed it, get the same no start as I did with old unit. I took the new one and reset. Reprogram and tried again and still nothing. I can't even get it to allow me to program the remotes to test the start function. So pulled it out, put the old one in and it tried to start after I pulled the OBD wire. Plugged it in and it started and ran for a few minutes and I tested everything. Great it works again...next morning, doesn't work. Single light flash and nothing. I started it with the key, did a remote start transfer and it took over. I pulled the key out and it stayed running for about a minute, then stopped. I tried again, nothing. So after 8 hours, I tried to remote start and it did, ran for about 10 seconds and shutdown. What's going on? Do I have a wire gremlin on the vehicle side? I disconnected all the harnesses wires, plugged them all back in and still nothing. Is there an alternative wiring?
Login to reply View 1 answer(s)

01/11/2024

 Audi vitaliy khomenko (160Pts.)

0

001A06503255

001A06503255 doesn't work
Login to reply View 1 answer(s)

31/10/2024

 Toyota G M (14910Pts.)

0

2022 Hilux

Hello. Is there a manual for installing evo-one on 2022 Hilux? Key.
Login to reply View 1 answer(s)

30/10/2024

 FAQ crystal o'connor (160Pts.)

0

Getting the Evo start app to use km instead of miles

Hi, Is there a way to change the settings in the EVO app (for android phones) to use KM instead miles? I can't seem to figure out how to get the mileage display changed to use KM (in Canada) Thanks
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue