Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

29/11/2024

 Subaru G M (15380Pts.)

0

subaru crosstrek and take over

Hello. I installed evo-one (3x lock) on 2018 Subaru Crosstrek. When opening the door the engine stalls... What could be the reason?
Login to reply View 1 answer(s)

23/10/2024

 Jeep G Trob (130Pts.)

0

EVO-All and CHRT4 - no connection type option

Greetings, Programming an EVO-ALL for install in a 2012 Grand Cherokee PTS, planning to use a CHRT4 T-harness for install. When programming the unit with the FLASH-LINK, firmware 59.02 in the section for selecting 'Connection Type', it only presents 'Wire-to-wire' option...is that correct?
Login to reply View 1 answer(s)

20/10/2024

 Volkswagen Fatbadcat (130Pts.)

0

EVO-ALL will no longer go into Solid Blue Key programming mode after programming button is released?

After an almost successful key programming where the Decryptor completed successfully with the EVO-ALL, Unfortunately, I did not replace the R-LINK with the TB-VW first before I reconnected the EVO-ALL. When I replaced it after it did not successfully start and gave 5 Red Flashes/Beeps. So I am trying to start over at key programming step 1. When the programming button on the EVO-ALL is released on the Blue LED flash, the Blue LED just goes out instead of staying ON solid. After reconnecting the remaining connectors to the EVO-ALL and pressing start button the yellow LED comes on. It seems like the EVO-ALL is damaged if it will not go into key programming mode or perhaps the RLINK is no longer functioning, This is not a wiring problem since key programming worked the first time. I have no way forward can someone please help?
Login to reply View 0 answer(s)

27/09/2024

 Ram Ramy Fathi (230Pts.)

0

Does CHRT7 require any splicing or tapping for a 2024 Ram?

Considering buying a CHRT7 or CHRT6 for my 2024 Ramy 1500 Rebel with OEM remote start and keyless entry. I looked at the install guide, but its not quiet clear whether it requires splicing/tapping into any wires. (especially the parking lights, ignition, CAN low and High). Thanks
Login to reply View 1 answer(s)

23/09/2024

 Fiat G M (15380Pts.)

0

FIAT 500 A5 and A6

I set A5 and A6 to OFF...Wouldn't that be the culprit?
Login to reply View 1 answer(s)

15/07/2024

 Infiniti G M (15380Pts.)

0

infiniti evo-all---evo-key

Hello. Is there a diagram (better if it is standalone) for evo-all such a connection on 2015 infinity Q50, like evo-key? By RX-TX
Login to reply View 1 answer(s)

11/06/2024

 GMC Tomaso DiCarlo (160Pts.)

0

how much parisitic drain does the EVO-START LTE add to Evo All or Evo One and does it goe into sleep mode to minimize it

2019 gmc savana 2500 standard key
Login to reply View 1 answer(s)

21/05/2024

 Jeep G M (15380Pts.)

1

2022 wrangler

Hello. I installed evo-all on a 2022 Wrangler. When registering, the decryptor wrote: "DCRYPTORS LIMIT HAS BEEN REACHED FOR THIS CAR...What should I do?
Login to reply View 1 answer(s)

05/12/2016

 Mazda David Dankanyin (130Pts.)

0

After step 13 of programing, all three lights are flashing not just yellow and red.

While programing the Evo All, stand alone starter, with mazda t-harness, I'm not getting the yellow and red flashing lights after step 13. Instead all three lights flash at the same time. If I hook it up to the flash link to use the Dcryptor, it's says there is incomplete key information. I don't know what to do from here. Any suggestions. I did try a factory refresh but am getting the same thing. Everything seams to go right up to step 13.
Login to reply View 2 answer(s)

15/05/2024

 Fiat marvin mcmurray (130Pts.)

0

will an evo all operate as a stand alone oem key remote start in a 2016 fiat 500

2016 fiat 500 highline 2 door coupe with a 1.4L none turbo, automatic. I wish to install the evo one as a low power stand alone remote start operated by the oem keyfob . will this work?
Login to reply View 1 answer(s)

03/05/2024

 Mitsubishi G M (15380Pts.)

0

2015 outlander euro

Hello. I also tried the master reset as you told me. I tried another device, which I tried on Ford before (001A07391859), but "take over" is not possible... it says on the monitor that the immobilizer system needs service.
Login to reply View 1 answer(s)

01/05/2024

 Mitsubishi G M (15380Pts.)

0

2015 outlander take over

Hello. I installed Evo-Al for 2015 Outlander (PTS) Standalone. After remote start-up, we go in the car, I click 2 times on the Start-Stop button and he writes that he does not see the immobilizer (like this), and the engine turns off when pressing the brake.
Login to reply View 1 answer(s)

29/01/2024

 Dodge ffbuddyhughes (190Pts.)

0

no blue lights when programming oem key

programmed and wired correct, no blue lights comes on during final step of turning ignition on with oem key 2008 dodge ram 2500 diesel
Login to reply View 0 answer(s)

17/01/2024

 Audi darwin medrano (160Pts.)

0

Evo-all stand alone

Can I use viper remotes on the evo-all stand alone with the xl202 and if possible is there instructions for this Thank you
Login to reply View 1 answer(s)

09/12/2023

 Nissan mobilesolutionsar (280Pts.)

0

Does the lock and unlock wires go into the listed empty slots on a 2019 Nissan Armada using the Evo-Nist1?

The guide says that the lock and unlock wires go into an empty slot.
Login to reply View 1 answer(s)

30/11/2023

 Toyota G M (15380Pts.)

1

2022 PRADO

For the 2022 Prado I indicated the 2018 LC150(euro). I connected CAN in the middle BCM connector. Blue is high, white is low. + and - I connected to the OBD. The parking lights turned on themselves...Even the position of the auto light lever did not interfere. The steering wheel did not close at all and did not have SLP either.
Login to reply View 1 answer(s)

22/11/2023

 Nissan Ramiro86 (300Pts.)

0

2022 Nissan Rogue remote start push start

I am installing a remote start to a 2022 Nissan Rogue, the installation guide says that 1 key will be sacrificed in the installation and the key in a box, I don't understand what that means, nor about sacrificing the key, nor about the key in the box, I need if someone could help me with that, thank you very much
Login to reply View 1 answer(s)

21/10/2023

 Chevrolet mervin dulce (510Pts.)

0

2006 chevrolet impala using evo-all stand alone install - no lock/unlock and accessory connection

Hello all, good day. Just wanna ask if i do the evo-all stand alone install with rf642 on this 2006 chevy impala, will the lock and unlock and accessory work through the vdata cable? Without physical connection? i experienced this with a 2007 nissan xtrail, it has a data connection but lock/unlock doesnt work. I had to physically find and connect them. (Using. Evo-one) thanks in advance.
Login to reply View 1 answer(s)

07/07/2023

 Toyota G M (15380Pts.)

0

LC200 EURO

I install fortin evo-all on LC200 (EURO) (standalone--408261). I release the programming button to blue. I connect the rest of the connectors. I turn on the ignition, the blue goes out and after a while the red starts flashing. Wire colors don't match either.
Login to reply View 1 answer(s)

04/07/2023

 Infiniti G M (15380Pts.)

0

2004 QX56

Will 3x-lock remote start work on a 2004 infiniti QX56? (evo-one)
Login to reply View 1 answer(s)

11/06/2023

 Skoda G M (15380Pts.)

0

2022 Skoda

I wanted to install on 2022 Skoda Octavia (PTS) evo-all... ...470681 I reflashed it 4 times, but didn't program it (CAN doesn't see it). Is there any variation?
Login to reply View 1 answer(s)

25/12/2019

 Infiniti Dzyanis Brynkevich (130Pts.)

0

EVO-ALL THAR-NIS1 (when the engine is running, the standard keychain does not work)

I have Infiniti G37S coupe 2009 on the European market, everything is connected by the manual, but when the engine is running, the standard key fob does not work, you can open the car only with a metal key, just when you open the door, does the engine stall, what did I do wrong?
Login to reply View 1 answer(s)

15/05/2023

 Chevrolet jaber awadh (340Pts.)

0

Silverado 2022 push to start

I have silverado 2022 limited edition push to start.. In fortin page they said to buy gmt6 i bought it but the bcm connectors are different than the t harness connector.. Any suggestions?
Login to reply View 1 answer(s)

20/02/2023

 Audi G M (15380Pts.)

0

Audi A6 standalone remote start

GUIDE # 79791 How does this manual provide remote start?.. With an OEM remote control or an aftermarket one? (Not specified 38.2) I want a standalone (as a last resort, an impulse trigger or an aftermarket remote start).
Login to reply View 1 answer(s)

18/02/2023

 Mazda Ben Jacobus (130Pts.)

0

2017 CX-5 Doesn't Get Yellow Light When Ignition Turned On

Installing Evo-All & THAR-MAZ1 on 2017 Mazda CX-5. Followed the guide (62391/66311... different guides if going through troubleshooter vs Flash Link guide) for firmware & options (tried firmware 85.12 & 85.11) THAR-MAZ1 only has Start/Stop 2nd connector (24 pin) & no 32 pin connector. So I am using the recommended wiring connections minus Data Key & Door Lock Data (A10 & A20) When programming I cannot get the module to recognize a key (blue LED, no yellow LED illuminated when ignition is turned on). Is the Data Key (A10) required? It is not in the THAR-MAZ1 harness nor is it populated in the OEM female connector. One of the keys to this vehicle was lost previously & only have 1. Is it possible to program with only one key? (the Flash Link Manager notes that 2 keys are required. I don't quite understand why)
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue