Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

SN: 002B04 671964 PLEASE RESET DEVICE

Dcryptor limit has been reached EVO-ONE SN:002B04 671964. When connecting via Flash Link 4, there is a failure and then it reconnects again.

0

2012 Civic starts then stops three times

Hello, I have had a remote start on my 2012 Honda Civic for 5+ years. It has quit working. It is a EVO-ALL and CrimeStopper RS00-G5. From following the troubleshooting I think it has to do with the tach signal but not sure what to check. The car will start for about 3 seconds then shut off. It does this three times and then nothing. While it is running the starter is engaged the entire time.

0

2013 CX-5 Cranks But Won't Start M/T

EVO-ONE. I have the THAR-ONE-MAZ3 harness. White cable for clutch bypass is connected. Not sure what's going on. I've tried changing the programmable output from 2.1 (default) to 2.2 (I think it should be this one?) and still no luck. It will try to crank for a few seconds, then shut off then tries again for a few seconds but won't start. Yellow jumper was cut when I received it, but it is currently twisted together until I verify what the issue is then I'll do a more rigid connection. I don't have the hood pin switch connected, my kit didn't come with it. Not sure if this is preventing it from starting or not. I have tried enabling and disabling A11 for this but still no luck with remote start. SN: 002B04 643579

03/12/2024

Toyota G M (15170Pts.)

0

2024 Prado

Hello. I installed evo-one (002B04683100) on 2024 Prado. Programming and decryptor were successful, but when I connect the 6-pin connector, all the LEDs blink

0

I want firmware vision 0.80 for remote starter and I want rest limit sn; 002B04 676425

I want firmware vision 0.80 for remote starter and I want rest limit sn; 002B04 676425 For Mazda 6 2016 and how can I make doors close when I put driver mode and when I put parking mode doors open

0

where I can find an older version of FlashLink Updater / Manager ? v3 or v2

where I can find an older version of FlashLink Updater / Manager ? v3 or v2? Please advise Thanks

0

solid orange and red light after 1st decryptor

Trying to get my remote start in my 12 Passat TDI working. When I get to the decryptor stage 2 it just has solid orange and red light on when you reinstall and turn on the key, it stops there, just those 2 lights.

its t harness VW_T6 so there isn't really much to hook up, all plug an play except i had to wire in the key reader.  car doesn't need the brake pressed, and i didn't wire in the hazzard wire as it was listed as optional.  seams like it read the key fine, and the app seemed to program the unit after. 

any ideas what i can try, i have all ready hit the flash/decryptor limit. the last thing i was trying was to use the firmware in the instructions instead of the recommended in the app. however i could not do the decryptor step as i hit the limit. 

0

need reset

need reset evo all 001A06557862 sticker's faded dont know the year manufactured...i used the module as 3x lock option, but now bought a 2way rfk422 ,rf kit programmed module response but not running...thank you....

0

flash device limit

helllo can you reset my divice 001A06426026

-1

Decryptor limit, Decryptor issue, 2012 Passat tdi

Trying to get my remote start in my 12 Passat TDI working. When I get to the decryptor stage 2 it just has solid orange and red light on when you turn on the key, and stops there, After multiple attempts I am locked out. Sn 001A07 071025

0

solid orange and red light after 1st decryptor

Trying to get my remote start in my 12 Passat TDI working. When I get to the decryptor stage 2 it just has solid orange and red light on when you reinstall and turn on the key, it stops there, just those 2 lights.

its t harness VW_T6 so there isn't really much to hook up, all plug an play except i had to wire in the key reader.  car doesn't need the brake pressed, and i didn't wire in the hazzard wire as it was listed as optional.  seams like it read the key fine, and the app seemed to program the unit after. 

any ideas what i can try, i have all ready hit the flash/decryptor limit. the last thing i was trying was to use the firmware in the instructions instead of the recommended in the app. however i could not do the decryptor step as i hit the limit. 

0

parking light flash 3 times , and no more action ....any idea..? evo one

 start but se check your question was not asked already:

    with  corolla 2019 automatic , with yellow wire cut,receive signal to start , no cranking , juste flash 3 times parking light , i wipe with other evo one module and every thing goes
any idea?

0

receive signal to start but parking light flash 3 times , and no more action ....any idea..?

my evo one on corolla 2019 , receive signal to start but parking light flash 3 times , and no more action ....any idea..?

02/12/2024

Mazda