Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage



Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question


Question about diagram in 73971

Hi all, Looking at the install for a 2020 Kona, diagram 73971. On page 6, lower left corner on the steering wheel, there are a couple of "7" dots. Based on what I'm reading, the top 7 should be removed and the bottom one should be changed to 8 because it refers to the location of the horn. If not, can you clarify? Thanks, Josh


honda hrv 2022 push to start, evo all takeover

hi... i have installed a evo all with a crimestopper remote start in a honda hrv 2022 push to start (takeover mode) I have flashed multiple evo all trying to understand the problem as I have checked all the connections and they are perfect as indicated by the installation guide. The problem is that when I enter the vehicle and press once the button turns off (taking into account that it does recognize the smart key) but if I press it twice in a row it does not turn off and I can drive it normally, but a message comes out that says Keyless Start System Problem, And if I turn the vehicle off and turn it on normally, the message still appears. Any solution for this problem or a special software version for it. Thank you for your help.


D2D or W2W Fortin EVO All with FORT1 T-Harness and AVITAL 4105L for 2011 F-150

Hi, I purchased the THAR-FORT1 Kit which comes with the EVO ALL and FORT1 T-Harness. I also purchased the FlashLink updater and will set the EVO ALL to D2D. I would like to pair all of this with an Avital 4015L remote starter for my 2011 F-150 (I do not want to use the factory remote start protocol as my truck doesn't have power locks). I would like to only use the D2D cable to connect to the Avital 4015L in order to cut down on wire clutter. I would like to know if the D2D cable is the only cable I need to connect between the these two. I was looking at the wiring diagram for the EVO ALL with the FORT1 T-Harness and on the left side of the remote starter every cable is optional if D2D is used but on the right side there is parking lights which I don't care for so I wont be hooking up and Ignition. Doesn't the ignition communicate through D2D? https://fortin.ca/download/94881/EVO-ALL_IG_RTA_BI_FOR-FSERIES-2011-2016_KEY80bits_D_94881.pdf Wanted to know if I am on the right track here before I start the install. Thanks!


2020 Chevy Silverado 3500 Standard key?

Is there available products for a 2020 standard key chevy silverado 3500? i have an evo-all and a gmt-7 harness but cant find any literature?


2014 Silverado unlocks twice & locks 3 times

2014 Silverado 1500. Standard key, with Onstar. Programmed properly. Starts, runs, confirmation from remote on lock & unlock. The issue I'm having is with single press of lock button, truck locks 3 times and single press of unlock button, truck unlocks twice.





compatibility of EVO -All with 2007 NIssan Pathfinder with regular key

According to your Site it shows as an option to use the EVO rs4 with Evo-All module. is that correct ? and can i use it as a remtote start or will i need to use the other Version which i think is a EVO ONE?? i also purchashed the T harness NIS5


Kia Mike Wes (160Pts.)


Remote Programming RFK441 to Evo One

I installed Evo-One with THAR-ONE-KHY1 Harness on 2009 Kia Borrego. No immobilizer. Used FlashLink to update, configured the EVO One and all seemed to go well. I dont have any factory remotes so I bought the RFK441 remote kit and RF-A2A Harness. When I plug the anntannae wire into EVO one I get one LED flash on the anntanae end. Then nothing. Turn key on and anntanae LED does not light up, Hit brake pedal 4 times and no LED lights up on anntanae dongle. I have anntane wire plugged into the evo one (blue plug). Im not using the RF-A2A harness. Am I supposed to use the harness? None of the RFK441 remotes do anything when buttons pressed. It appears the unit wont go into programming mode to allow me to connect the remotes to the unit. Any ideas? Thanks,.


I would like to get my Evo-All module reset please SN:001A07349178. please thank

please reset evo all SN 001A07349178


Does Fortin EVO-ALL work with Easyguard PKE systems

I see that the EVO-ALL works with many aftermarket alarm and PKE systems but does it work with the Easyguard systems?


2020 Trax

2020 trax, using the GMT-1 All hooked up, All programed, reconnected to the car and will not work. No lights come on, Red,Yellow, or Blue. Turn the ignition on with the key and get a yellow light.


Ford G M (12070Pts.)



There was a broken wire in the underwing connector going to the underhood button. We fixed it and the remote start worked. Thanks for support.


Will the Evo-All work with easyguard EC002 in a 2012 Ram 1500?

I have been using the EVO-ALL for remote start, on my 2012 Ram 1500, but wanted to add the Easyguard EC002-F02-NS, are these compatible and if so can I get the required wiring to connect the two?


Toyota DMPNJ (130Pts.)


2007 Toyota RAV4- No immobilizer

I’m installing an Evo One in a 2007 Toyota Rav4. The car does not have an immobilizer. What are the steps to program the module? I’m not finding it anywhere. Thanks