Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

Will the evo-vwt3 work on my VW Passat 2018 standard key and where can I find install instructions

0

Evo Start 2

Bonjour J'ai un Toyota Avalon 2019 avec un evo start 2 et le démarreur fortin evo one. Le tout fonctionne bien. Je peu barré et débarré via l'application également. Mon problème est avec le Statut du véhicule dans l'application. La demande statut ne fonctionne pas souvent et les informations de température sont erronées. Par exemple, il fait -10 mais il indique 20 degré dans l'habitacle alors qu'il n'a pas fonctionné de la nuit et on ai le matin au réveil. Le voltage lui me semble plausible. Je sais qu'il y a une façon de réinitialisé l'antenne evo start 2 mais je ne me souviens plus de la fonction et de la bonne procédure. J'ai tout de même essayer de débrancher l'antenne, de rebrancher en maintenant le bouton sur l'antenne jusqu'à ce qu'elle clignote orange rapidement puis jai essayé chaqu'un des mode de clignote bleu 1 a 5. Il y a un mode que je crois que c'est pour vérifier le signal ignition. J'ai réussi a refaire fonctionné le démarreur en mode 2 flash bleu puis appuyez sur le bouton. Jai pas tenté de redémarrer le moteur mais les door lock fonctionne. Cependant maintenant j'ai 8 volt de batterie et -37 degré donc j'ai empiré ma situation car la même le voltage est erronée (batterie sur la charge et en santé). Qu'elle est la procédure de réinitialisation factory reset de l'antenne evo start 2 que je puisse enfin avoir une bonne communication avec l'application et de bonne donné? Merci

0

please reset evo all SN 001A04 068596

0

Unable to Connect Module to Flashlink Updater

In Flashlink Manager, I am able to connect the Flashlink Updater (red LED on device solid and status shows "Connected"), but when I plug the Updater into my EVO-ONE the module will not connect to the Updater. Using Flashlink Manager v4.62, and Flashlink Updater has firmware v4.08.

0

Audi Q7 dizel 2016

Привет. Как подключить EVO Q7 TDI 2016 Cтандартний ключ и есть кнопка . Каким руководством рользоватся ? Спасива.

0

HI I connected IVO LL Toyota Avalon 2021 GUIDE # 80741 Avalon 2019.

Авалон 2019 соместима с 2021 годомю.THAR-EVO-TOT13 Запрограмировалось хорошо.Только есть одна проблема:Неработают парковочний свет. Нет вихода А14 когда работает RS.Пожалоста помогите мне.Ето проблема прошивки? Или проблема модуль EVO ALL? Или есьть другие варианты решени етой проблемы? Спасибо.

1

2005 Toyota Camry Starts but factory alarm gose off

Hello Everone We installed a EVO One Sin# 002B04690023 with 411 RF kit on this 05 Camry with installation guide # 84961 we folowed it to a T the vehicle starts fine but when the factory alarm sets it gose off with it running. Do we forget or need to set something in the evo one to disable or bypass the alarm we can't find any setings for this Please help. Thanks,

0

THAR-ONE-SUB3 compatible with a 2012 Subaru Forester Keyed ignition ?

Documentation goes from 2014, but compatible vehicles list just states Subaru. Looking to pair with evo-one.

0

Hood pin installed but not functioning properly.

We installed the supplied hood pin and is not functioning properly. Starts with hood open and does not kill when started and popping the hood. Not sending trigger to EvoAll. Programming seems to be correct. Everything else works just fine.

0

Evoall no longer starts car

Hello, I have been using an Evo One Fortin kit to start my car for the last 3.5 years. I have a 2020 Honda Accord with manual transmission. It just recently started to fail to remote start my car. When I start it manually, it works and doesn't struggle to start. I noticed that all the functions like heated seats, blower fan, rear defroster all work and the engine turns over, but the engine does not start when I attempt to start it remotely. It does this three times before shutting down. It seems like the module is not giving the car the bypass code. I am using the 3X lock function with the OEM fob and not an RF kit with stand alone fob. Any suggestions will be greatly appreciated. Thanks

0

Mazda 3, 2018

The unit does not read the key, when the ignition is turned on nothing happens, the blue indicator continues to light Mazda 3, BN, 2018

0

Program help for RFK411 2015 Infiniti Q50 push to start

I purchased a 'Start-X Remote Starter Plug N Play for Infiniti Q50 14–20' on amazon, I was not satisfied with the oem key fob range so I bought the 'Fortin RFK411 1-way Rf Kit' to help out, but I have no instructions to get it work or programmed. I do have my flasher. Can somebody help me get Fortin RFK411 1-way Rf Kit working for my 2015 Infiniti q50 push to start! I need intrustions!

0

I want to add shock sensor & siren to evo-all on 2018 Malibu using GM6, how do i go about wiring?

Using Evo-All w/GM6 harness; OEM factory fob 3x Lock to remote start;

06/02/2025