Car = 2022 Subaru WRX, Manual Transmission, Push-to-start
I have programmed, decrypted, and installed an EVO-One using the THAR-SUB4 Harness and an RFK3641 rf kit. When I try to enable the ready mode, the car is not remote starting. I have been following the procedure to activate:
Car is running, put in neutral, press foot brake, pull hand brake, release foot brake, here is where it gets weird. According to the instructions I should now press and hold the start button for 3 seconds, but before I get a chance to do that the car flashes the lights 3 times. When I press and hold the start button for 3 seconds nothing happens. I leave the car running, get out, the car automatically shuts off and locks the doors. When I go to remote start it, the lights flash 3 times and nothing happens.
I have tried doing this same thing with and without holding the start button for 3 seconds before exiting. I have also tried pushing the start button on the car before exiting (similar to "removing" the key), but the car immediately shuts off.
Looking for some assistance, thanks!