Utilisateur

I don't like seeing DTC codes as you can tell, and I don't think it's normal to see them ...

This is the description of the fault:

CAN communication line malfunction between start stop unit and PCM

Start stop unit internal malfunction

I'm getting my PCM updated in a couple of days at a Mazda dealer,
can a Fortin enginner verify that this is normal and won't affect the procedure?

Will this issue be corrected with an Evo One firmware update, or
is there some technical issue making this not possible to fix?
 

Hello, 

I have the EVO-One w/ THAR-ONE-SUB1 T-Harness and Fortin RF642W remotes on a 2016 Subaru Legacy.

Everything works including remote start but I would like to get back into the module via Flashlkink Manager and change some settings that are not available via the Valet Switch programming method. (Specially, I would like to increase run time of remote start)

The problem is the flashlink manger does not detect the module. The procedure I've been doing is: 

1) Open Manager

2) Connect Flashlink updater via USB, it is recognized and updated to latest version.

3) Turn key to ON, but not running. 

4) Connect Flashlink updater to cable plugged into module. (All other connectors also still connected)

5) Retry detection, open close program etc... but is never detected.

Is there something I need to do with the programming button perhaps? Or need to remove the other connectors? I didn't want to do anything with the programming button fearing it would lose its decyptor settings or other programming.

The module is secured well and I ran the flashlink cable to my fuse box for easy access, but if I have to remove it I will.

Hello,

I am having an issue with my installation I just completed.

I used the following Guide #  82741 ( https://drive.google.com/file/d/1FB45koxLUjZ1c26G2NwFK3VFuDIthVNs/view?usp=sharing).

I have the EVO-One w/ THAR-ONE-SUB1 T-Harness and Fortin RF642W remotes. Everything went smoothly for the wiring with the exception of the (~)IMO wire which I had to use the secondary location behind the fuse box on the left.

I originally had the Subaru factory installed remote starter I removed as well. (H001SAL003 I believe)

Everything works related to the module (remote starts, unlocks and locks, OEM and RF642W remotes work). Although, I did not wire a relay in for the OEM lock X3 feature, since I had the remotes.

However my windows now do not function at any of the doors. I have verified my wiring and will do again tomorrow but I was wondering if anyone has ran into this or can point me in the right direction.

I also took the car for drive last night and noticed the security light was slightly on... not fully bright but there.

I checked all the fuses in the engine bay and under the steering wheel.

Any ideas?