Utilisateur

I have programed a evo all )1a07248861) for colorado 2006 standard key, using it with a remote start crimestopper rsg4, everithing is fine with de programation, the door  lock and unlock is working fine.

but the problem is when i want to start it, the lighs turn on , the inition , accesory, etc. but the car never run with de starter and it doesnt starte,  the evo all stay whith de lihgs yellow and red solid and the lights never turn off.

i tried programing diferents evo all and the same thing happened with them.

votes

I have programed a evo all )1a07248861) for colorado 2006 standard key, using it with a remote start crimestopper rsg4, everithing is fine with de programation, the door  lock and unlock is working fine.

but the problem is when i want to start it, the lighs turn on , the inition , accesory, etc. but the car never run with de starter and it doesnt starte,  the evo all stay whith de lihgs yellow and red solid and the lights never turn off.

i tried programing diferents evo all and the same thing happened with th

I was trying to install a remote starter with an evo-key, for a kia forte 2018 automatic transmission and I found that this model has no data wire and this is the only wire that says the installation guide that should be used for the evo- key, then what do I do in this case. thank you .

Toyota Sequoia 2015, EVO All, I made the corresponding installation following the instructions, I did the programming of the module at the end and everything went well until i tryed to start the car and does not turn on, I checked  the ground connection of the remote start and it's all right, and follow the instructions of connection for the Evo all for the Toyoya Sequoia 2015 and the instructions say that with the connection of data link, do not need to give ground to the Evo all (dark blue cable , ground when the remote start is running) the only function that is doing is the unlock of doors, when I give this order the blue LED get on, but when I give the ignition order only the yellow led get on and when I give the option to lock doors No LEDs are turned on. You think it's better to make connections directly from the EVO all status output wires to the remote starter input wires.

(the module have been flashed FIRMWARE VERSION 79.[43] )

I have a 2011 nissan rogue intelligent key, I installed an evo one, everything works perfect, except the trigger of the driver's door (auto lights shut down ) dark blue cable, connect this cable to the negative of the door trigger, exactly as the instructions say , but I have the problem that when starting the remote start the vehicle turns on but after 2 seconds it turns off, check the problem and I find that when the remote starter start the dark blue wire  gives a constant negative discharge and the sensor of the door trigger shows as if the door were open, I do not really understand what this dark blue wire is for and what function it has, disable it and the car lights normal, my question is what should I do or what is the problem, or I must configure thanks.