2019 Ford Explorer Base key start, no hood pin, auto trans
I can get the CAN bus to program(I get the proper lights) Can bus voltages checked at 5 pin connector.
key on. Key off
CAN 2 HIGH 2.76V. 2.08V
CAN 2 LOW. 2.24V. 2.08V
CAN 1 HIGH. 2.72V. 0V
CAN 1 LOW. 2.27V. 0V
Firmware is 71.49 as flash link suggests Toggle switch instead of hood pin has good, verified ground EVO ALL won't program my key information. I have gone through the steps prescribed(old method) with putting key in ignition, wait 6 seconds, then putting second key in for 3 seconds. Ignition comes on, but stays on. No blue LED flashing and have to unplug module to turn off. Also tried new method of folding the key in, and placing in front of the ignition, then pressing button on EVO ALL, but nothing happens. Blue and red LEDs stay lit. I am at my wits end. I have been searching all over this forum for the answer, but here I am asking the question. I am not sure which harness I have, but there is a t harness that goes to the ignition barrel, and the 4 CAN hi/lo wires that I stripped wrapped and spliced, and are on the correct wires behind the OBD2 connector. Car was bought new in 2019 with 2 factory keys..
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
