Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

Chevrolet colorado 2006

 

 

I have programed a evo all )1a07248861) for colorado 2006 standard key, using it with a remote start crimestopper rsg4, everithing is fine with de programation, the door  lock and unlock is working fine.

 

but the problem is when i want to start it, the lighs turn on , the inition , accesory, etc. but the car never run with de starter and it doesnt starte,  the evo all stay whith de lihgs yellow and red solid and the lights never turn off.

 

i tried programing diferents evo all and the same thing happened with them.

votes

 

I have programed a evo all )1a07248861) for colorado 2006 standard key, using it with a remote start crimestopper rsg4, everithing is fine with de programation, the door  lock and unlock is working fine.

 

but the problem is when i want to start it, the lighs turn on , the inition , accesory, etc. but the car never run with de starter and it doesnt starte,  the evo all stay whith de lihgs yellow and red solid and the lights never turn off.

 

i tried programing diferents evo all and the same thing happened with th

 

0

2005 Colorado Evo-One - Lights Flash 4x and sometimes Passlock

Been using an EVO One for 2 years now with little issue.

From time to time the passlock light comes on if I've had the remote start running for over 10 minutes. Sometimes while driving too. Doesn't seem to cause any problems though. Any thoughts?

Now, out of nowhere, I tried to auto start and it runs for 3 seconds and then turns off and flashes the parking lights 4x. Any thoughts or solutions for this one?

 

Unit SN: 002B04033936

70.18 bypass firmware 4.0 hardware

1.24 remote firmware 7.0 hardware

 

Thanks!

0

2020 Colorado RF Kit disrupts Daytime Running Lights

I have a suuccessful installation. Everything works: remote start, lock/unlock, with the OEM key fob (x3 lock remote start) and the RF442 Kit. The only isssue is that when the RF442 is used to either unlock or remote start the vehicle, the DRL's do not function as OEM intended. The DRL's are the low beams with low poer output. With the OEM remote, everything act's normal, however, with the RF Kit, the low beams simply turn on to full brightness (not low power like it should). I have set the parking lights control in the firmware to both on and off, both with the same issue. In addition, the RF Kit does not 'flash' the vehicle lights to confirm lock or unlock and does not turn on parking lights to indicat the vehicle is running (under remote start conditions).

0

EVO-ONE Enables 4wd whenever I use the start command

Successfully installed the Evo-One in my 2005 Chevy Colorado. Prior to install did a master reset, updated to FW ver. 70.18 and then loaded the suggested settings in the Flash Link manager v4. Using the CRIMESTOPPER RFALL642W kit from Amazon for remotes. Whether it is a fresh start with an empty vehicle or a start command to put my truck in idle mode. Upon giving the command, the 2wd indicator turns off and 4wd goes on in the center console. Note: This vehicle uses pushbuttons to switch from one to the other. Not a clue what is going on here and any help is much appreciated. Thanks!

0

2008 Chevy Colorado

As in the Evo All wiring guide for this vehicle it states it needs to be 4.06 firmware. Under that firmeware there is no way to change the Evo from Fortin protocall to D2D is there??????

0

firmware version and D2D for python system

2011 Chevy Colarado do I use 4.06 fw or the latest recomended version... I set up for 4.06 but I cant change the data protocal for D2D to comunicate with my Python Remote start

0

colorado 2011

Sur votre site il marque que le passlock-sl2 v.2 est compatible avec le Chevrolet colorado 2011. Mais sur la plan du passlock-sl2 v.2 il y a seulement le plan pour un colorado 2004 a 2009. Est-il vraiment compatible avec le 2011 ? Si oui es-ce le m

0

Programming issue 2010 Colorado

Alright. Since the tech support number is busy again I'll try on here. 2010 Colorado installing an Ultrastart 3295. I've double and triple checked the connections to ensure I'm on the proper wires but it absolutely will not program properly (wiring style 8 program style 3). Steps 1 & 2 work (pretty hard to mess them up) but step 3 when I turn ignition to the on/run position the Blue LED turns off (so far so good), the Red LED turns on (also so far so good) but then the red LED never flashes, the blue one does however. I've tried just going to the next step (start and hold crank for 3 seconds) but the yellow LED never comes on to signal programming is complete. FWIW, this is a very stripped down version of the colorado (work truck basically) w/ no power locks/windows/etc. Chuck

1

No start 2009 Chevy colorado

As 2471 TW FM + Evo all connection 8 guide 12281 Le evo a programmer ok je crois car meme les door lock marche ( unlock only ) meme si pas equiper. En remote start il y a une sequence de led sur le evo all ensuite le Autostart crois que ca tourne car le timer fonctionne. Le evo as les 3 led fonctionne, bleu clignote, rouge et jaune semble solid.

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer