English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

03/02/2023

 Jeep Nev (130Pts.)

0

Jeep has power but does not crank?

I have programmed the unit sn: 001A07 415854 Evo All. Installed with wiring harness THAR-CHR4 (Both Yellow wires on the harness are connected together). Programmed the unit. All these went according to the documentation, correct leds and all.

My vehicle is a 2011 Jeep Grand Cherokee 3.0CRD Limited with Start Button

I do the 3x Lock Blue Led comes on every time I press the lock button. Then all power comes on, a few seconds later the red and yellow led is solid and the radio shuts off just like it does while it cranks but no crank??

What could I be doing wrong?

Many Thanks!!

Connectez-vous pour répondre Voir 1 réponse(s)

23/10/2022

 Ford Trevor Voitik2 (130Pts.)

0

Ignition turns on but won’t crank

I just my oem remote and the trucks ignition turns on but it won't start the hood pin is disabled as I don't have one on my truck 2009 f150
Connectez-vous pour répondre Voir 1 réponse(s)

22/02/2022

 Ford Clay Smith2 (130Pts.)

0

removed this kit now car wont start with key

ok i am an installer at 12 volt solutions in tulsa oklahoma, and we installed one of your evo all kits in a 2016 ford escape, and couldnt get any power to the module so we removed the kit and plugged it all back up factory and now as soon as you turn the key to accessory it tried to start, and when you try to crank it over it does nothing. All the lights and the radio come on but wont start.
Connectez-vous pour répondre Voir 1 réponse(s)

16/01/2022

 Jeep Andy Sicard (200Pts.)

0

2005 Jeep Grand Cherokee, Turns on but no crank, no start.

Installing Evo All, stand alone with Thar-CHR5 harness. Ignition and MUX wires are connected, module is programmed, key is programmed. Dash lights up, fuel pump buzzes but not start. 

With the harness, I connected the yellow-yellow (ignition), green/red-purple (MUX), and white/red-pink/orange (starter) wires. is there something I'm missing?

Connectez-vous pour répondre Voir 2 réponse(s)

16/01/2022

 Jeep Andy Sicard (200Pts.)

0

2005 Jeep Grand Cherokee, Turns on but no crank, no start.

Installing Evo All, stand alone with Thar-CHR5 harness. Ignition and MUX wires are connected, module is programmed, key is programmed. Dash lights up, fuel pump buzzes but not start. 

With the harness, I connected the yellow-yellow (ignition), green/red-purple (MUX), and white/red-pink/orange (starter) wires. is there something I'm missing?

Connectez-vous pour répondre Voir 2 réponse(s)

21/12/2021

 Chevrolet Victor Burisch (130Pts.)

0

2014 Tahoe EVO-ALL no crank

Have the EVO-ALL installed with T-Harness in a 2014 Tahoe. After car is shut off with the key and remote start is attempted vehicle will start as it should. Any other time you attempt to remote start the vehicle it will go through the motions and power on ignition but will not crank. it makes two attempts and then shuts down with the 3 light flash. the ignition powers on and then goes out as if it was going to attempt to start but it does nothing. if i restart the vehicle with the key, turn it off and attempt again it will rempote start one time
Connectez-vous pour répondre Voir 1 réponse(s)

08/12/2021

 Jeep Shane Benjie (220Pts.)

0

2007 Jeep Compass, turns on but no crank no start.

installing Evo All, stand alone with Thar-CHR5 ignition and MUX wires are connected module is programmed, key is programmed bit no start. Dash lights up, fuel pump buzzes but not start. HELP?
Connectez-vous pour répondre Voir 1 réponse(s)

20/11/2021

 Ford Cory Schwarz2 (200Pts.)

0

2018 Ford Edge will not crank.

Installed Evo-All with Thar-3 into a 2018 Ford Edge push to start, using guide 68921. Module # 001A07 017412, no RF kit installed. Using the OE remote on the lock-unlock-lock, the dash will power up and park lamps will turn on like it wants to start. Unit will not crank, after the second attempt, the lights will flash 3 times indicating. Changed setting D4 to hybrid on/tachless mode, and the vehicle will act like it turns on and park lights will stay illuminated. Still does not crank. Have the black 4 pin, white 20 pin, white 5 pin, red 6 pin connecters all attached. I believe I have all the required wiring connected. Installation shows one end of the black 4 pin going to a remote starter with AVEC Data-Link? Does this need to be connected to something? Tried to tie it into the diag connector temporarily as shown without data-link with no change. Will this Evo-All not act as a remote starter? What am I missing?
Connectez-vous pour répondre Voir 1 réponse(s)

19/01/2020

 Honda Andrew Cordeiro (320Pts.)

0

Remote start not working and door chimes with lights off!?

Everything was working after Rob helped me out programming the remote start side of the unit for manual transmission. Was cleaning up the install and must have unplugged the unit the wrong way. Now the car won’t crank again, and ready mode works up until the last step which is relocking the car after door closes and car shuts down. I have relock enabled on both sides of the unit, tried reflashing and changing different options with no luck. On top of that now my door chimes with the parking lights hooked up and it didn’t do that before and all my lights are off. The headlights don’t give any diagnostic flashes either. Using t-harness and correct guide. 

 

Thanks

Connectez-vous pour répondre Voir 0 réponse(s)

15/01/2020

 Honda Andrew Cordeiro (320Pts.)

1

Car won't remote start, no headlight indication

2013 Honda Accord PTS Manual transmission with Evo One and HON 3. Used guide 57151 with no luck. Tried putting car in ready mode not working. tried remote starting with 3x OEM remote nothing, no crank. No led lights turn on when trying to remote start and headlights arent flashing. Even tried connecting the pink wire to a test light to see if maybe i had the incorrect headlight wire. The vehicle will start normally and the yellow led will turn on on the unit. I was able to program the unit and decrypt it with no issues, Ive also tryed this twice with no luck. Please help!
Connectez-vous pour répondre Voir 2 réponse(s)

15/01/2020

 Honda Andrew Cordeiro (320Pts.)

1

Car won't remote start, no headlight indication

2013 Honda Accord PTS Manual transmission with Evo One and HON 3. Used guide 57151 with no luck. Tried putting car in ready mode not working. tried remote starting with 3x OEM remote nothing, no crank. No led lights turn on when trying to remote start and headlights arent flashing. Even tried connecting the pink wire to a test light to see if maybe i had the incorrect headlight wire. The vehicle will start normally and the yellow led will turn on on the unit. I was able to program the unit and decrypt it with no issues, Ive also tryed this twice with no luck. Please help!
Connectez-vous pour répondre Voir 2 réponse(s)

01/01/2020

 Kia brian judge (130Pts.)

0

No dash power no crank

2014 Kia Optima pts no dash lights no crank on rs. Unit blinks blue when I press lock 3x remote starter clicks 2x and I get 2 led flash error on rs saying hood pin switch but it isn't even hooked up yet. Me evo all came pre programmed with c1,d6,program lock checked off with a version of 76 46 is this the correct programming?
Connectez-vous pour répondre Voir 1 réponse(s)

04/01/2020

 Chevrolet DAVID BARNES (250Pts.)

0

2015 malibu no crank no start

I installed an evo all gmt1 in a 2015 malibu flip key. I used a flash link to update firmware and do the key dcryptor. I also have a 2 way lora 9 rf kit. The install and all programming of the unit went as it should. ( all lights and flashes correct ) However the vehicle wont start. It doesnt even attempt too. When using the 3x lock the evo all sees it ( flashes when the lock button is pressed ) then nothing. Also with the 2 way rf transmitter the evo all and antenna see it and the transmitter responds with green light and audible tune but the same result occurs after that. The car does not attempt to start. I have installed an evo all before so this is not my first install and I went over the programming of the unit and the keys / transmitter numerous times. Any ideas on what could be the hang up would be greatly appreciated. Thanks

Connectez-vous pour répondre Voir 1 réponse(s)

01/01/2020