Installed Evo-All with Thar-3 into a 2018 Ford Edge push to start, using guide 68921. Module # 001A07 017412, no RF kit installed. Using the OE remote on the lock-unlock-lock, the dash will power up and park lamps will turn on like it wants to start.
Unit will not crank, after the second attempt, the lights will flash 3 times indicating. Changed setting D4 to hybrid on/tachless mode, and the vehicle will act like it turns on and park lights will stay illuminated. Still does not crank.
Have the black 4 pin, white 20 pin, white 5 pin, red 6 pin connecters all attached. I believe I have all the required wiring connected.
Installation shows one end of the black 4 pin going to a remote starter with AVEC Data-Link? Does this need to be connected to something? Tried to tie it into the diag connector temporarily as shown without data-link with no change. Will this Evo-All not act as a remote starter? What am I missing?
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
