Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

2

If your Cadillac SRX 2010-2016 suddenly stops starting

I searched and searched for similar cases on the Internet and found this one, written 4 years ago... I tightened these 3 bolts on the fuse board and everything was fixed...                                                                                                                                                                                                                                                                                "The exact same thing happened to my SRX changed my headlight bulbs and put new battery in. Took the fuse box cover off and the relay out at front of fuse box as there is no room for my big hand to fit in. I figured that if i just removed the screws in the fuse box i could get some extra room so my hand would fit in to get the headlight bulb put everything back together. Went to start car dash lights came on would not start at all spent 3 hours trying to figure out what was wrong. My buddy came over as he worked at a GM dealer told me to push down on fuse box and the car started up the screws in fuse box where not tight as there is a wire harness under the fuse box ."

0

2014 Cadillac SRX

Hello.The 2014 Cadillac SRX had an aftermarket remote start and evo-all installed. The owner wanted to install a GPS tracker and he removed the ground of the evo-all to connect it to the ground of the tracker.Since then, the car does not start. The ignition opens, but the engine does not start. The remote start elso has no feeling.

13/01/2025

Ford Munito (1530Pts.)

0

2014 Ford Fusion HVAC doesn't turn on.

Hi there! I have already installed an evo one in a 2014 ford fusion, but the HVAC does not work. When the car is started by remote, only the blower starts working but it does not heat up. The HVAC only heats up when you insert the key and turn it to ignition. I have been reading some articles related to this topic and it is that the 2013 and 2014 Ford Fusions need a reprogramming so that the HVAC works with the aftermarket remote starters. Here is the information and the vin number of the car. Can you help me with a solution? Thanks in advance. 3FA6POG74ER381308

0

2014 Hyundai Sante Fe Evo One Lte. factory remote

Hello, I installed Evo One Lte in my 2014 Hyundai Santa Fe Sport PTS. The Evo start works great via the Cell app but i cant get the factory remote to start the car. Also, the cell app WILL NOT operate the door lock/ unlock. The list says 3 locks will start and stop remote start, but i cant get it to work. Not sure if its my fault or If factory fobs will not work on this vehicle Any help is greatly welcome !!!! THANK YOU ALL VERY VERY MUCH

0

MODULE LED'S DON'T DO ANYTHING WHEN PLUGGED INTO VEHICLE

USED FLASHLINK, MODULE HAS CORRECT FIRMWARE, PLUGGED INTO VEHICLE CORRECTLY, HELD DOWN BUTTON AND ATTATCHED 4 PIN CONNECTOR TO MODULE, NOTHING HAPPENS. NO LED'S LIGHT UP AT ALL. evo-all standalone

18/12/2023

Honda G M (16110Pts.)

1

2014 Honda civik

Hello. I installed evo-one on a 2014 Honda Civic. I indicated a hybrid - D4... The car switches to a hybrid only when braking. Should I keep this D4 or delete it? 002B04337437

0

2014 Mitsubishi Outlander Evo-all with evo-start lte and rf642 kit

Hello there guys, i have a 2014 mitsubishi outlander with evo-all and rf442 kit. All works fine and well. And then i added an evo-start lte module. I was able to program it with the rf442 kit. RF kit works fine as before. Then the app for the evo-start works fine as well except for the remote stop/engine off function. Lock, unlock, and remote start/engine on function works. But when i try to do and remote stop/engine off. It doesnt work. Is this a bug on the app? Or is there a programming issue? Again. Lock, unlock, and remote start/engine on works. Its just the remote stop/engine off function that is not working. any help will be appreciated. Thanks in advance. Btw im using it on ios device.

09/07/2023

Honda G M (16110Pts.)

0

2014 honda accord

Hello. I installed evo-all(001A07473343)+remote start, on a 2014 accord(hybrid-pts). Remote start opens doors and then doesn't close.

29/06/2023

Ford smrick2 (190Pts.)

0

Why does it only honk now when I remote start

Installed evo all with my car telematics with 944 rf kit and has worked beautifully since 2019 with the occasional horn honking when I remote start but I had to remove module and wiring from dash for some audio upgrades now all it does is honk the horn when I try to remote start. Does not try to crank everything powers up as it should then nothing. Thats on first attempt 2nd attempt does even do that. I have since go in and tried to reprogram module as t

29/06/2023

Ford smrick2 (190Pts.)

0

Why does it only honk now when I remote start

Installed evo all with my car telematics with 944 rf kit and has worked beautifully since 2019 with the occasional horn honking when I remote start but I had to remove module and wiring from dash for some audio upgrades now all it does is honk the horn when I try to remote start. Does not try to crank everything powers up as it should then nothing. Thats on first attempt 2nd attempt does even do that. I have since go in and tried to reprogram module as t

0

2104 Honda Accord Remote Start does not work after programming and Installation

I have all the wires in place, have a toggle kill switch, programmed correctly and did the Flashlink Dcryptor. When I attempt to remote start, it does not start. I see a blue led light the controller when I hit lock on my key fob, but that's it. I have a 2014 Honda Acord Push Start. With the remote start in place, the car still operates as normal.

0

How to connect Evo-all build in alarm to 2014 camry pts

Install evo-all with optional mycar module to 2014 camry pts, remote start work but i also want to hardwire shock sensor to evo-all built in alarm. How do i make that happen, thanks

0

How to connect Evo-all build in alarm to 2014 camry pts

Install evo-all with optional mycar module to 2014 camry pts, remote start work but i also want to hardwire shock sensor to evo-all built in alarm. How do i make that happen, thanks

29/12/2021

Ram joe tom (410Pts.)

0

Can bus faults after 3 trouble free years

Is there any warranty on a the evo device that stopped working out of the blue? My 2014 ram broke down a couple of nights ago and the dtcs state the can bus was not ok. U0001 I removed the can high wire from evo and all issues went away and cleared. I love my remote starter and fob, is there anyway to get this module repaired or replaced ?

0

Can you help program my 2014 Ford Fusion with fort3 t-harness?

2014 Ford Fusion with evo-all and fort3 t-harness wont program as standalone. I turn the key to the on/run position and the light just stays solid blue and never flashes.

0

Remote start shutdown trigger OEM alarm 2014 Toyota Camry PTS

I have installed an evo-all (s/n # 001AO7065000) in a 2014 toyota camry pts, its work as expected except its will trigger oem alarm either by my or timer. I have turn on the disenable alarm prior to start/enable after shutdown option too but its still trigger alarm, every morning the oem trigger right after remote start shutdown getting very annoying. Also i have installed mycar module with the evo-all, mycar module have an option that will detect the alarm (alarm input detection) and push notifications on the phone but i dont see that the evo-all (harness) have any output to horn that i can tap into for the (alarm input detection) to work. Please advise, thank you so much. This is a repeated question and im apologize for that, because its getting very annoying that the oem alarm trigger at 6 am. Im desperately need help

0

No response from OEM Lock on EVO All with all T-harness

2014 Dodge challenger After successful Programing including DCryptor process. EVO-ALL does not respond to OEM Lock and doesn't start engine. Installed with T-harnesses for ODB2 and Push Start Button. Any help is appricated.

0

2014 ram 3500 will not remote start. Manual transmission

I followed the instructions for the thar-chr7 what else am I missing? flash link does not have an option for manual transmission I did not cut the yellow wire

0

cranks will not start - programming ok

I have a FIAT 500L installed Evo-All and all connections installed as per installation guide, using wire to wire method as remote starter was not listed in options. Performed programming and all lights illuminated and extinguished as described in programming procedure. connected to flash link and decryptor transfer of information was successful. installed bypass to vehicle and all functions are working, however when attempting to remote start vehicle will just crank(as if secret key information is not present) confirmed this was the case if i place the key into the ignition and remote start the vehicle all functions are operating correctly. Notes: when performing lock/unlock and trunk functions the blue light will flash and function will perform. When i attempt remote start function ONLY the yellow light will illuminate on the Evo. Any and all information greatly appreciated!

0

cranks will not start - programming ok

I have a FIAT 500L installed Evo-All and all connections installed as per installation guide, using wire to wire method as remote starter was not listed in options. Performed programming and all lights illuminated and extinguished as described in programming procedure. connected to flash link and decryptor transfer of information was successful. installed bypass to vehicle and all functions are working, however when attempting to remote start vehicle will just crank(as if secret key information is not present) confirmed this was the case if i place the key into the ignition and remote start the vehicle all functions are operating correctly. Notes: when performing lock/unlock and trunk functions the blue light will flash and function will perform. When i attempt remote start function ONLY the yellow light will illuminate on the Evo. Any and all information greatly appreciated!

0

Hello! Which EVO kit and T-HARNESS will fit my car? Nissan Teana L33 2014 Europe.

Эта машина на платформе Altima! Но только европейской сборки. Мне интересно, куплю ли я комплект EVO All NIST4. Подойдет ли распиновка проводки и жгута для моего автомобиля?

1

EVO-All do I need to order the harness and also do i need flash updater or the existing firmware will support my car.

X-Trail 2014 (Euro) Intelligent Key Push Start EVO-All T-Harness Flash Updater

1

EVO-All do I need to order the harness and also do i need flash updater or the existing firmware will support my car.

X-Trail 2014 (Euro) Intelligent Key Push Start EVO-All T-Harness Flash Updater

1

Outlander 2014 - Remote starts works but no Takeover

Hi i managed to get the remote start to work on an outlander 2014 mk3 2.2 diesel. I had to use the OBD for CAN1 Hi/Lo as the guide wires did not work, it was after this that I was able to program the evo all correctly and remote start the car. if I remote start the car, unlock doors with key and then press brake, the car turns off and I manually start it again. This works perfectly and there are no errors. however, when I press the push to start button to takeover It doesn't work and I get an immobilizer error and electrical system service error on the cluster. Why could this be?

29/12/2021

Ram joe tom (410Pts.)

0

Can bus faults after 3 trouble free years

Is there any warranty on a the evo device that stopped working out of the blue? My 2014 ram broke down a couple of nights ago and the dtcs state the can bus was not ok. U0001 I removed the can high wire from evo and all issues went away and cleared. I love my remote starter and fob, is there anyway to get this module repaired or replaced ?

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer