Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

2022 Nissan Armada restarts on its own after 5 seconds after turning off!

The car starts fine now with the remote start. But after turning the car off using the button on the dash, the car restarts on it's own after about 5 seconds. Then will turn off and stay off after pushing the dash button again. And now I also have a key fob error on my screen.

0

shut off when I press the brake

I am writing to report an issue with my car’s remote start and shutdown process. When I press the lock button on the car key three times, the car starts remotely, as expected. However, after entering the car by pressing the unlock button, I encounter a problem: when I press the ‘Press to Start’ button twice in succession and then press the brake, the engine shuts off immediately, and the message ‘Wegfahrsperre’ appears. Could you please help me understand and resolve this issue?” FORTIN EVO-ONE-MIT2 EVO-ONE + T-KABELBAUM Mitsubishi Outlander 2016 SN:002B04 291538 On the first press, the blue light blinks. On the second press, the blue light also blinks. On the third press, the blue light blinks, followed by the red and yellow lights. The blue light then turns off, leaving only the red and yellow lights on. My issue is that I want the engine to keep running so I can drive immediately, rather than having the engine shut off when I press the brake pedal and then needing to restart it to get going.

0

Engine shut off

“I am writing to report an issue with my car’s remote start and shutdown process. When I press the lock button on the car key three times, the car starts remotely, as expected. However, after entering the car by pressing the unlock button, I encounter a problem: when I press the ‘Press to Start’ button twice in succession and then press the brake, the engine shuts off immediately, and the message ‘Wegfahrsperre’ appears. Could you please help me understand and resolve this issue?”

FORTIN EVO-ONE-MIT2 EVO-ONE + T-KABELBAUM

Mitsubishi Outlander 2016 

0

2006 Lexus RX400h hybryd. Evo one. Dash comes on for 10-12 seconds than shuts down. Parking lights 4 flash

2006 Lexus RX400h hybryd. Evo one with rf642. Dash comes on for 10-12 seconds after remote starting than shuts down. Parking lights 4 flash. I tripple checked ignition harness wiring, correct by the guide. I flased an other module but does the same thing. SN:002b04 106970 Any idea?

1

2023 - 2024 Toyota Camry shutdown when door opened

Many users complained about this issue " engine shutdown when door opened ". The question: 1- did you update the firmware to resolve this issue for evo rs toy13 kit ? 2- did you add more options for engine shutdown duration (for example 10 minutes)? 3- does your device have security to protect against stealing the car without key - for example engine will shutdown when gear shifted and key not detected?

0

EVO-One for 2011 Mazdaspeed 3 - Remote start starts the vehicle but immediately shutsdown after 1 second.

After I put my vehicle in ready-mode for my manual, push-to-start vehicle, my car will remote start properly, however, it immediately shuts off after about 2 seconds. Parking lights don't show any indication on why it shutdowns either. What could be the issue? I also noticed that the wiring diagram for installation have flipped wiring colors for 7A (Back Clutch Switch 2) and 7B (Front clutch switch 1). It says the Back clutch switch should have 2 cables, a WHITE and a BLACK cable, however, in reality it has a GREY and BLACK cable. Same thing with the Front clutch switch; diagram says it should have a GREY and BLACK cable but it they're WHITE and BLACK in my car... I have tried both of these wirings actually, and the problem still persists. Even if this is not the cause of the problem, which one is correct?

0

2015 NISSAN ROUGE PTS ALARM SETS OFF AFTER STARTER SHUTS DOWN

T-HARNESS was used with an EVO-ALL. After 15min run time the vehicle shuts down and the factory alarm sets off. Is there a setting that can avoid the factory alarm triggering?

0

Evo-All Door Open Shutdown

I recently installed an Evo-ALL on a 2016 MAZDA 3. I haven't been able to get the engine to not shut down when I unlock and open the door. I have Parameter D3 'door open shutdown" OFF. I've tried switching D3 to ON and then OFF again, didn't work. Is there a way to get this to work?

0

Evo-one runs 45 seconds then shuts off

Corolla h/b 2020 push-to-start manuel. Je viens de remplacer tout le filage et le evo-one. Decryptor et programmation se passent bien. Moteur démarre et fonctionne pendant 45 secondes, s'éteint, puis redémarre et fonctionne encore 45 secondes. Problème de tach en data link? Pourtant l'ancien kit a fonctionné 3 ans avec les mêmes branchements. 70.66 les door locks ne fonctionnent plus et le evo-one devient défectueux .. 70.70 roule 45 secondes et door lock ok. 1.25 ok. 1.24 pas de door lock fonctionnels. 1.26 decryptor impossible. En tachless ne démarre pas.

0

Evo-one runs 45 seconds then shuts off

Corolla h/b 2020 push-to-start manuel. Je viens de remplacer tout le filage et le evo-one. Decryptor et programmation se passent bien. Moteur démarre et fonctionne pendant 45 secondes, s'éteint, puis redémarre et fonctionne encore 45 secondes. Problème de tach en data link? Pourtant l'ancien kit a fonctionné 3 ans avec les mêmes branchements. 70.66 les door locks ne fonctionnent plus et le evo-one devient défectueux .. 70.70 roule 45 secondes et door lock ok. 1.25 ok. 1.24 pas de door lock fonctionnels. 1.26 decryptor impossible. En tachless ne démarre pas.

0

Evo-one runs 45 seconds then shuts off

Corolla h/b 2020 push-to-start manuel. Je viens de remplacer tout le filage et le evo-one. Decryptor et programmation se passent bien. Moteur démarre et fonctionne pendant 45 secondes, s'éteint, puis redémarre et fonctionne encore 45 secondes. Problème de tach en data link? Pourtant l'ancien kit a fonctionné 3 ans avec les mêmes branchements. 70.66 les door locks ne fonctionnent plus et le evo-one devient défectueux .. 70.70 roule 45 secondes et door lock ok. 1.25 ok. 1.24 pas de door lock fonctionnels. 1.26 decryptor impossible. En tachless ne démarre pas.

0

Evo-one runs 45 seconds then shuts off

Corolla h/b 2020 push-to-start manuel. Je viens de remplacer tout le filage et le evo-one. Decryptor et programmation se passent bien. Moteur démarre et fonctionne pendant 45 secondes, s'éteint, puis redémarre et fonctionne encore 45 secondes. Problème de tach en data link? Pourtant l'ancien kit a fonctionné 3 ans avec les mêmes branchements. 70.66 les door locks ne fonctionnent plus et le evo-one devient défectueux .. 70.70 roule 45 secondes et door lock ok. 1.25 ok. 1.24 pas de door lock fonctionnels. 1.26 decryptor impossible. En tachless ne démarre pas.

0

Evo-one runs 45 seconds then shuts off

Corolla h/b 2020 push-to-start manuel. Je viens de remplacer tout le filage et le evo-one. Decryptor et programmation se passent bien. Moteur démarre et fonctionne pendant 45 secondes, s'éteint, puis redémarre et fonctionne encore 45 secondes. Problème de tach en data link? Pourtant l'ancien kit a fonctionné 3 ans avec les mêmes branchements. 70.66 les door locks ne fonctionnent plus et le evo-one devient défectueux .. 70.70 roule 45 secondes et door lock ok. 1.25 ok. 1.24 pas de door lock fonctionnels. 1.26 decryptor impossible. En tachless ne démarre pas.