Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

14/07/2024

Subaru ReLyt (210Pts.)

0

2009 Subaru Manual unable to Lock/Unlock during remote start

Good evening, I am trying to get a 2009 Subaru Forester manual transmission functioning with an EVO-ONE and an Excaliber RF kit (listed under compatible remotes). Reference: https://fortin.ca/download/25141/Audiovox%20%20EVO-ONE.pdf First of all, the option for RFLF remote within Unit Options does not exist on any of the remote start firmware options (tried 0.44, 1.26, 1.16 and several others to check). I did attempt to pair the remotes and had mild success with the default RF kit setting. Lock and Unlock seem to work intermittently depending on the state of the vehicle, remote start does work with reserve mode for the manual transmission as long as a lock command is accepted to turn off the engine (configured option to keep engine running until door lock). Currently running remote start firmware 1.16, but had similar results with 1.26 and 0.44 as well. Primary issues: 1) Unable to use factory or Excaliber remotes to lock or unlock the vehicle after a remote start command was sent from Excaliber remotes (regardless if the vehicle was able to successfully remote start or not). What options exist to resolve this? What firmware should be used? Are there any option settings to adjust? 2) Flash limit was reached while trying to test different remote start firmware versions. Can this please be reset? (EVO-ONE, 04/2022, SN: 002B04 271047) Secondary issue: 3) Sometimes when a door is opened after an unlock command, the alarm is triggered and can only reset when unlock is pressed twice on the factory fob (not tested with Excaliber remotes). This was not tested thoroughly so I do not have clear steps to reproduce this case. It did seem to happen more often after any action was made relative to remote-starting (either attempting to enter reserve mode with engine running or after attempting remote-start).

0

2012 Ram 2500 Diesel Manual Transmission Remote Start

I have a 2012 Ram 2500 Diesel that I want to intall a remote start in using 3X lock function. Im going to use an evo one but I saw on the forum there is an additional clutch wire that needs to be installed? also it has to be programmed to manual mode and a sequence has to be followed in order to put it in ready mode. Is there any documenation covering the additional clutch bypass wiring because it is not mentioned in the installation manual of the truck. Will putting it in ready mode need me to press the lock button 3x instead of just one because I wont have an rf kit installed? Any other relevant information that is different from a automatic transmission install would be helpful as well. Thank you

0

2014 ram 3500 will not remote start. Manual transmission

I followed the instructions for the thar-chr7 what else am I missing? flash link does not have an option for manual transmission I did not cut the yellow wire

0

2008 dodge ram 3500 diesel standard transmission

2008 dodge ram 3500 6.7 cummins with a manual transmission, I've installed the evo one with a t harness. The module programs properly, but when I press the lock button 3 times to start the module clicks a few times but does nothing.

0

Ready mode not fully working

Just installed evo one with a toy5 harness on a 2020 tacoma trd sport..everything works except i have to press the clutch then lock 3 times to start engine. Why wont clutch overide activate Edit based on the non harnes schematics looks like i need to re route one of the wires from ignition line from remote starter to the clutch can somemone confirm Thanks

0

Extra connections needed for 2022 Civic Si Manual?

Looking to install an Evo-One remote starter in a 2022 Civic Si manual, and I am wondering what extra connections need to be made when compared to to the automatic instructions. Thanks!

0

Civic 16' (Manual) w/FTX64 2W - Ready mode no longer saving my dashboard preferences

Hi, I Have a Honda Civic 2016 (Manual). I bought an aftermarket remote starter in 2019. The controller is an FTX64 2W. I used it without issues up until this winter. I would stop the car, leav it in neutral put the park brake on, and then press the ON button on the controller to start the Ready Mode. With the exception of the rear-window defroster which never worked, any preferences that I had on my dashboard would turn on when I activated the remote start later on (seat heaters, front window defroster, temperature, etc). This winter I noticed that when I get out of the car after activating my ready mode (after about 3-5s) the remote emits a red light and makes the descending noise (same on as if I remote stopped the car). When I then remote start the car, it will turn on, but none of the preferences on my dashboard will be on (cold seats, no defroster, no temperature, etc). The only thing that has changed is that one of the remotes (I have two) is dead. I will be replacing the batteries this week and trying that one out too. Anyone know what could be causing this? As I said, it worked well up until this winter and then stopped out of nowhere.

15/11/2021

Jeep G M (15020Pts.)

0

2017 jeep compass

Hello. In the manual № 98391, in the programming procedure, in the 7th step, it is written that press the start-stop to turn ON the ignition. Then it is written again, press the start-stop to turn ON the ignition ... And when did we turn it off?

0

Car attempts to start but does not crank

2015 Honda Accord coupe ex. It has been programmed correctly. Using a T-harness the Thar-one-hon3. It's a manual transmission with push to start and I put the car in ready mode using foot brake and E-brake. Both red and yellow led on module come on when there are supposed to but after pressing my OEM remote 3 times it appears to start but will not crank. I'm about to return this and seek another option. Any help is appreciated.

0

Compatible w/ Manual Honda

Please advise which remote start product is most compatible with a 2019 Honda Civic Sport Hatcback, manual transmission, standard key. Can this product A) bypass the safety on the clutch without additional splices and B) Implement a safety requiring the transmission to be in neutral prior to starting?

0

Ford Focus 2007 Manual without Can Bus

I am working on a Ford Focus Manul 2007. The guide for evo one, only list Automatic transmission and it says automatic Tranmission only.

Is there a way I can make it to work regardless. I can wire the cluth wires and find the ebrake as well. 

how about manual tach, running it to the injectors?

How do I set the evo one module and any work around it please.

Thanks,

0

2007 Ram 2500 Diesel Manual Transmission nothing happens

i have a 2007 2500 diesel with a manual transmission, i have the OEM key programmed but when i go to Remote start, all i hear is a relay click 3 times...also everytime i press the lock button on the key, the blue light is lighting up.... i have to make the comment, that when i program the EVO-ONE on flashlink, the "settings" that are saved on the EVO-ONE shows different than the ones i have programmed/saved. is there a "lockout" or something that i must do? for instance: i saved the turbo timer to be on for 4 minutes on the fortin flashlink, when i check to see "current settings," it shows that it is off. and so forth.

0

Manual 3x lock stops working after car sits but drone mobile still works.

Two manual cars was noticed that the 3x lock stops working after short time. If you enable ready mode then try the three lock start right after you get out of the car It works. If you wait 30 minutes or more it does not work with the 3x lock feature anymore. Lights flash three times which means the car is not in ready mode. Cars also have drone mobile installed. The app starts cars with no issues. One is a Honda Civic 2009 the other is a Subaru crosstrek 2019. Has this issue before seen before? Why does it work when you get out of the car for a short time but then it doesn't after the cars sets for awhile but still works with drone mobile.