Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

User

derek g

Joined on the:

Oct. 13, 2015

Score

346250

Comment(s)

2607

Voted question(s)

137

Voted answer(s)

297

Votes up

11

Votes down

429

Votes up received

26

Votes down received

0

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

0

Should my Fortin Evo one be able to run car without key in vehicle?

Strange thing happened to me today, I left for work this morning after remote starting my vehicle. My keys are usually in my backpack so I unlocked the doors from the app since my phone was in my hand. When I got to work I tried to lock my door by touching the Handle but they didn't work. I realized I had left my keys at home. Is the car supposed to run without keys inside or do I have an issue. My install was the no key install and seems to be working properly apart from that. Any help would be appreciated. Thanks.

0

Sold vehicle with Remote start installed.

How do I transfer ownership of the remote start if I don't have the security key? Recently sold my truck and it had the Evo one remote start system installed but I have lost the security key. How do I give the new owner the ability to use the system?

0

04.5 dodge ram 3500 5.9 Cummings

What do I need to install remote start on my truck and is there a t-harness that will work with my truck for easy installation?

1

Remote start of the 2023 Outlander

The start-stop button is given a minus twice, with an interval of 3-4 seconds. We have to move the instrument panel frame to get to the button connector. There was a whitish line. I fitted a 12-ring loop to the rear cylinder of the start-stop button. I removed the battery from the key and attached a 2 cm diameter 12-ring loop to the logo. I cut the gray wire on the brake connector with the relay contacts and gave a plus to the light blue wire. To turn off the engine, it takes 3-4 seconds to give a minus to the start-stop button, and then a minus impulse to the door button... Behind the kick panel there was a light blue wire. The door lock-unlock lines were also there...purple and beige.

0

2022 Elantra N Manual. When in ready mode, press ignition once, then brake and car will lock after closing door.

Accidentally locked self out of car once. What setting is causing this? Go to neutral, and pull ebrake. Press ingition once, then brake, car turns off. When the door is opened and then closed it locks even if key is inside.

0

Remote start doesn’t pair with the car Audi SQ7

Hello, I purchased an remote starter kit from Romania - Autoextra partner, after 3 days of working on it I had no clue how to make it work, maybe it will be easier to talk directly to you as support and not make a 3 way conversation. Update how I’m now : everything is wired corectly (measured with voltmeter), made the connection to can high and can low in the left side of driver side next to the fuse box (2,6V can high; 2,4V can low) all wired up exactly how instructions are (green, orange/brown with the grey and grey/black from the module connector) and no success, ignition on and the blue led from module goes off and stays off till I turn the ignition off again, then solid blue led shows again. Software version is 61.28 (recommended from the windows program), I refuse to think that it can’t be a solution to make it work together. Maybe someone from tehnical support or software can discuss with me to find a solution, it will be faster via whatsapp if available or by email (I think that there is only 5-6 hours difference between us). Kind regards, Andrei Neacsu

0

What color is the + starter in 2007 Dodge Caliber

I already installed a remote starter in 2008 dodge caliber with evo all. Right now im trying to install a remote starter into a 2007 dodge caliber which this one doesnt have a + starter wire. Even in the instruction given it says that "if present". I connect all the wire correctly but it doesnt work. The dashboard is light up when i press the lock 3 times but its doesnt start up the car. Do i need to connect the + starter? Can someone please help 2007 dodge caliber Automatic Evo all with thar-chr5

0

2024 Nissan Sentra manual transmission, suddenly can't put starter in ready mode

I had an EVO-START LTE system installed by a reputable local installer at the end of October. The system has been working well, other than having to take it back once to get a setting changed so the doors wouldn't stay open after arming the starter. It is getting pretty cold here in Saskatchewan, but everything was working as expected up until yesterday. This morning when I came to work the car would not go into ready mode using the normal arming procedure and it won't respond to any lock or unlock commands from the app. I have also noticed that the GPS tracking is not working as it was previously, and is only updating periodically and not logging any trip info today. When I got to work, for example, it still said that my car was in my garage and the location had not updated in something like an hour. I have tried numerous times to get the system to go into ready mode and nothing is happening. Normally when I engage the brake and parking brake at the same time I can hear some clicks, the locks cycle, and I can arm the starter by locking the doors once I am out of the car. Now nothing is happening. I contacted the installer and they want me to bring the car in and leave it there all day for them to check it out. He has suggested that the battery voltage dropped too low the last time it remote started and it messed up the software / programming somehow. While it did get very cold last night, the car is brand new and I kind of doubt that the voltage is dropping very low. Any assistance is appreciated. Keep in mind that I do not have access to a flash programmer, as I did not personally install the unit. I would just like to get as much information as possible and ensure that there is not something wrong with my system, as it is only a few months old.

0

2023 OUTLANDER

Hello. 2023 Outlander (Euro) does not have a standard remote start. Is there another option for remote start?

0

buying to use it in kuwait for LandCruiser 2024 (Prado)

Hello there

i want to buy the System to Remote start my LandCruiser 2024 (Prado) via mobile app. my car specification already has Remote start from the oem keyfob originally from Toyota but no Toyota connect feature . so i want to Remote start via the mobile so do i need to buy EVO all in one module and EVOSTART LTE to get it work ? or only EVOSTART LTE will be enough? also will it work in kuwait network for EVOSTART LTE if i put simcard internet coverage plan from kuwait?.

Thank You 

0

Why headlights stay for minutes after pressing lock?

2011 mitsubishi eclipse standard key has Evo one installed n works fine. Only 1 thing bothers me n that is using the rf kit 411 n pressing lock n unlock headlights stay on for a few minutes which I think can drain battery,is there anyway around this? Especially hitting lock n walking away. Another thing is the connection required for headlights from 6 pin plug if those lights r automatic n come on with ignition.?

0

Step 11 key programing

2016 audi a3 push to start evo all serial number: 001A07 016953 I flashed the correct software on to unit with the flashlink. I get to step 11 of key bypass-program with r-link, and it says to wait up to 5 mins with solid red light. Then it's supposed to flash yellow, and the flah yellow and red, but the red light just stays lit and never goes past that point. I've tried reseting evo reprogramming to a different firmware, then back to the recommended firmware, but I can never get past that point and have waited up to 15mins. What should I do at this point?

0

Does the NISSAN NIST4 wiring harness require an RF-A2A adapter for a 942 remote kit?

It looks like the NIST4 harness is already rigged up for the Fortin remote kits based on the blue plug that is present? Or does it still require the RFa2A adapter cable to properly split the serial data?

0

Please confirm which t-harness is required for 2019 Volkswagen Jetta

2019 VW Jetta. Push-to-start

Want to buy Evo-All for remote start using OEM key fob. 

    Which t-harness don’t need? THAR-VW 1.2.3. Or 6?Does this require sacrifice of a key?

0

RM-411 works only at a distance of two meters or closer, what can it be?

RM-411 works only at a distance of two meters or closer, what can it be?

0

Dead unit or gremlins?

2004 Suburban LT Evo-One with Fortin 4 button 1 way remotes. Reset the unit several times. Here's some more interesting info...the valet button doesn't do anything. I've replaced the valet button as well as just touched the wires together and still nothing. So doing a complete 23 reset is not possible. Today I figured I would rewire the 6 pin harness, to eliminate the t connectors. No change. It goes thru the start sequence, clicks once and then just like the key was turned off. It will act like it does a remote take over as well. When running, if I press to "leave" the vehicle but have it stay running, it clicks like it's ready. As soon as I turn the key it shuts down. It's getting cold and dark and I have maybe a few hours on weekends to try to figure this all out. I have uploaded a video on YouTube. https://youtube.com/shorts/85TdkOkl8Y4?si=04Yf5ICgBzh9n734

1

2023 Mazda CX30 - Evo One with T-Harness - Push Button Start Malfunction

Good Day. Need assistance with the "Push Button Start Malfunction. Have the Vehicle Inspected.". I get this immediately after I enter the vehicle and push the start/stop button of the vehicle. I tried multiple times and get the same results. As soon as I press the brakes, engine stop. It that the Evo One is not recognizing when I press the start/stop button. The vehicle remote start (3x lock) sequence works and the lock/unlock on the OE remote works as normal. I've installed the Evo-One multiple times (in all my vehicles, past and present). This is the first time I am getting this. Could it be a firmware issue? I recall, last year, when I installed the Evo One in my 2019 Mazda CX5, I was getting a message on the display and I had to use a different firmware to correct that. Evo One Unit (date: 05/2019) is currently on: bypass firmware 90.06 | remote starter firmware 1.26 Looking forward to your assistance.

0

Can i get by evo bypass key reset resched my vehicles lemit

0

I want rest limit sn; 002B04 676425

0

2017 Ram 1500 Start briefly then shut off

Installed the fortin evo all with THAR-CHR7 and a 5706v w2w. Programmed according to instructions. Everything is working properly except I can't get the vehicle to remote start every single time. It starts and shuts off right after starting. Sometimes the truck will remote start and stay running like it should but not everytime. What could be wrong? Is it the firmware version?

0

Dcryptor reset

EVO one sn 002B04 651595 dcryptor limit reached needs to have limit reset.

0

SN: 002B04 671964 PLEASE RESET DEVICE

Dcryptor limit has been reached EVO-ONE SN:002B04 671964. When connecting via Flash Link 4, there is a failure and then it reconnects again.

0

I want firmware vision 0.80 for remote starter and I want rest limit sn; 002B04 676425

I want firmware vision 0.80 for remote starter and I want rest limit sn; 002B04 676425 For Mazda 6 2016 and how can I make doors close when I put driver mode and when I put parking mode doors open

03/12/2024

Toyota G M (15380Pts.)

0

2024 Prado

Hello. I installed evo-one (002B04683100) on 2024 Prado. Programming and decryptor were successful, but when I connect the 6-pin connector, all the LEDs blink

0

where I can find an older version of FlashLink Updater / Manager ? v3 or v2

where I can find an older version of FlashLink Updater / Manager ? v3 or v2? Please advise Thanks

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue