Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

03/11/2024

Nissan Tu Le (390Pts.)

0

what is the option to set for the car to locked and shutoff the parking lights after the remote start timeout (15mins).

Vehicle: 2018 Nissan Rogue Sport SN: 001a07 531903 Problem: remote start the vehicle (3x locks), car started with no issue. However if I don't make it to the car after 15mins, vehicle shutoff as expected, but the vehicle has unlock and parking light kept stay on and kill the battery. Is there setting on this unit to prevent this 2 issues. (locked after shutoff and turn off the parking light) Appreciated your help!!!

0

intermittent crank no start 3 parking light flashes Mitsubishi Eclipse 2012 with oem alarm

This is driving me crazy... It works and then it does not... Need some help please.

Everything is connected per instructions (Guide # 24871), except; I had to disconnect the (A8 dk. blue) to Driver Door pin, as it left the Door ajar on constantly. 

The Yellow loop has been cut on the fortin unit.

Fortin unit SN: 002B04 251304

Crank no start and 3 parking light flashes. 

When Press lock from OEM keyfob nothing flashes in the fortin unit.

 Setup in Flash link:

Bypass

Firmware 86.05

Hardware inside 4.0

A1 on

A2 off

A3 on

A4 on

A5 on

A6 on

A7 on

A8 off

A9 on

A10 off

A11 on

B1 on

C1 on

D2 on

D3 off

D4 off

D5 on

D6 off

E4 off

E5 off

 

Remote start

Firmware 1.26

Hardware inside 7.0

2 off

3 1

4.1

6.1

7.1

8.1

9.1

10.1

11.1

11.4

12.1

13.2

14.1

15.1

16.5

18.1

19.1

20.8

21.1

24.1

25.6

26.1

29.1

30.1

31.4

32.5

33.1

35.2

36.2

37.1

38.1

39.2

0

Late 2023 Durango Headlight Switch Connector FYI

The later Durango (mine is 8/2023) has a different headlight switch connector than earlier models as shown in install guide. It does have a white/brown wire that does change with switch position. Will the Evo-All have any problems with this connector change?

0

intermittent crank no start 3 parking light flashes Mitsubishi Eclipse 2012 with oem alarm

This is driving me crazy... It works and then it does not... Need some help please.

Everything is connected per instructions (Guide # 24871), except; I had to disconnect the (A8 dk. blue) to Driver Door pin, as it left the Door ajar on constantly. 

The Yellow loop has been cut on the fortin unit.

Fortin unit SN: 002B04 251304

Crank no start and 3 parking light flashes. 

When Press lock from OEM keyfob nothing flashes in the fortin unit.

 Setup in Flash link:

Bypass

Firmware 86.05

Hardware inside 4.0

A1 on

A2 off

A3 on

A4 on

A5 on

A6 on

A7 on

A8 off

A9 on

A10 off

A11 on

B1 on

C1 on

D2 on

D3 off

D4 off

D5 on

D6 off

E4 off

E5 off

 

Remote start

Firmware 1.26

Hardware inside 7.0

2 off

3 1

4.1

6.1

7.1

8.1

9.1

10.1

11.1

11.4

12.1

13.2

14.1

15.1

16.5

18.1

19.1

20.8

21.1

24.1

25.6

26.1

29.1

30.1

31.4

32.5

33.1

35.2

36.2

37.1

38.1

39.2

0

How do I keep my parking headlights on when using EVO ONE with THAR-MAZ03

How do I keep my parking headlights on when using the factory remote starter via EVO ONE. Using THAR-MAZ03 for EVO One on Mazda CX5 2019 GS Push to start automatic? Installed remote starter: EVO ONE MAZ3 with THAR ONE MAZ3 Running on latest firmware Car model and Make: Mazda CX5 2019 GS 4DR Push to start Automatic

0

Tundra parking lights

I have a evo one on my tundra. Is there a way to not have the parking lights come on? It flashes the parking and tail lights after I un lock or lock the door.

0

Signals, headlamps, etc not working after remote start.

2019 Elantra GT manual with EVO ALL, Compustar CMX. Vehicle starts properly, but after a remote start sequence the signal, headlamps and a few other accessories related to steering wheel mounted controls do not work. Only way to regain operation of these functions in to remove cars battery for a few minutes. Happens only after 5-8 remote start sequences. Removed parking light control from EVO and hard wired directly to Compustar with appropriate resistor with no change.

0

How do I set my parking lights to come on after remote start? 2015 Subaru Outback

I installed the Evo One kit w/ T-harness in my 2015 Subaru Outback. Works fine but I'd like to have my parking-lights on after it's started remotely. How do I do this?

0

Why is my new Fortin Key W642 lock&unlock are backwards drivers door saying ajar some interior lights staying on?

I have a 2012 F150 that i installed a EVO-All with the Fort1 t harness as standalone remote start and W642 RF kit add on, also wanted to use alarm feature on it. I contacted suport and they set it for me as far as the option go that were uploaded tio the EVO-All from my computer. So truck will remote start with OEM fob and aslo Fortin W642 foib. OEM will unlock and lock like it should but the Fortin W642 whn i press lock it send a unlock comand and when i press unlock it does nothing. Parking lights do not flash but i hear the relay clicking like it has a issue. i Need some help ive been going over wire that ive connected and it looks correct. I double checked the direction the ! amp diode is istalled and it aslo seems right. I went to the store today and grabbed a few ne diodes to try that......Ok so i went out to truck to check somthing and i cut the wire for the door pin when i 1st installed as stated i wanted to use the alarm feature but when checking it with my meter. even though the wires are cut its showing 0.0 ohms like it is still connected or grounded out somwhere. Please ask me anythying i dont care how stupid you think the question is i just need to get this thing fiuxed. My wife is starting to hit me with the "I told You, You shouldn't put that on your truck!" 

 

0

Parking lights flashing even when remote start isn’t activated

Installed a evo all in a 2012 Dodge Avenger 2 years ago and it's works flawlessly until recently. Now anytime you unlock the car the parking lights flash as if the remote start has been activated. Any ideas?

0

EVO-ONE FLASHES PARKING LIGHTS 3 TIMES

i've installed the Evo-one with the factory fob on my 2009 Toyota Matrix, but when i press 3 times lock on the factory fob after that parking light flash 3 times and car not start. SN:002B04248953 i have 2008 Honda Osdysse installed the Evo-one with factory fob 3 times lock it work ok. Can you please Thank you.

0

Starter has worked prefect for 2 years-suddenly Tail light /marker lights will not turn off; Remote start not working

0

How to connect D4 D6 , 2006 Nissan Altima

I'm using evo-one with niss2 harness for my 2006 Nissan Altima I am confused about the connection D4 and D6 showing guide #78211. I also don't know where to connect the pin 30 from the relay for parking lights . A picture would be great, or can I leave the parking light unconnected? The last question, do I have to have a RF module to remote start? Because when I put my key at on position, the blue lights went off.

0

2021 rav4 xle evo all before start parking lights flashes 3 times then 5 or 6 then starts

installed evo all with alarn enabled on 2021 rav4 .works good .why the parking light before start blinks 3 times then little pause 5 times more and then car start ok?S/N is x002ds97f7

0

Turn off park lights while running on remote starter - EVO-ONE

Hello. Curious if there's a configuration option in the EVO-ONE to disable park lights being turned on while running on remote starter. While I could just disconnect the trigger wire for the park lights I'd prefer to leave it connected so it can still blink out any error/issue codes down the road. Vehicle is a 2016 Hyundai Veloster Turbo, using the EVO-ONE on recommended firmware version. Thanks.

0

How do I get the parking lights to stay on when RS is activated and vehicle light switch is set to auto?

Hello Support, I completed a remote start on a 2014 Lexus LS460. The parking lights turn on when the RS is activated but only when the vehicle's light switch is set to off. If the light switch is set to auto the parking lights do not turn on with the RS active. Is there a way to leave the parking lights on auto and have them work with the RS active?

0

Starter has worked prefect for 2 years-suddenly Tail light /marker lights will not turn off; Remote start not working

0

Parking lights stay on intermittently on Veloster

2019 Veloster, PTS, using EVO-ALL and Compustar CMX. Parking lights stay on intermittently after locking the vehicle. Is there somewhere else I can hook up positive lights to instead? Tried different module and remote starter.

0

2016 CR-V Push-Start Thar-one-hon3 - what is horn/parking lights wires used for?

Got everything working without needing routing and taping into the factory harness for the horn and parking lights wires that are shown in the instructions. What are they actually used for ? It's for a remote start only with the factory key fob. I don't mind wiring them if needed in my case but would rather leave the factory harness intact if possible. Thanks

0

Parking light out put on fortin evo all

I'm looking at doing parking lights for my focus but i cant seem to find which wire is for the parking lights output for the fortin evo all. I can see on the diagram parking lights in but not out

0

Resistor required for parking lights at BCM on 2015 RAM

Per the instructions for 2015 RAM it says to tap into the connector at the headlight switch for the parking lights output and add a 1k ohm resistor. I previously had a different remote start module where i tapped into the parking lights output at the BCM and it didnt require a resistor. Can i tap into the bcm for the parking lights output with the EVO-ALL and if so do i still need to add the resistor?

0

PARKING LIGHTS NOT COMING ON WHEN THE REMOTE START IS RUNNING

2016 Mitsubichi Outlander Sport Key start, remote start operating with OEM Key after pressing the lock button 3x Remote start installation with T-connectors When pressed 3x, all the parking lights flashing and rhe cars start, then just passenger side still on.

0

PARKING LIGHTS NOT COMING ON WHEN THE REMOTE START IS RUNNING

2016 Mitsubichi Outlander Sport Key start, remote start operating with OEM Key after pressing the lock button 3x Remote start installation with T-connectors When pressed 3x, all the parking lights flashing and rhe cars start, then just passenger side still on.

0

2015 Toyota Tacoma EVO-One, parking lights always on when running, and stay on after time out.

I have the EVO-One wired in with RFK942 RF Kit and everything functions, but I have three issues. First the parking lights are always on when running. Is there a way to fix that? Second, when the remote start times out the parking lights did stay on until the drivers door was opened, so I wired the blue wire to the door pin switch wire Green w/ yellow, and programmed Option 32 mode 3. Now the door open dash light is on all the time, acting like a dead short insted of pulsing. Did I program this wrong? I was following the advice of two other posts I found. Three, the lights never flash when I lock or unluck the doors. Any idea why? Please advise, thanks.

0

2016 Juke parking light wire resets car features

I have 2 2016 Nissan Jukes, yes, his and hers. My starter works fine and turns on the parking lights (brown wire to purple wire of green pin1 at BCM connector), when I put the brown to purple in my wifes car, the lights don't turn on and it resets the radio/time to factory, every time. Again, identical 2016 Jukes. I am NOT pulling the starter out of her car as where I have it tucked in takes a long time to get at. Verified 12v at purple wire with manually turning on the parking lights but when remote started the Fortin brown wire has nothing. Ideas?

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer