Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

Dcryptor

Need a Dcryptor reset please and flasher aswell, Also cant get my evo one to get pass step 4. Any help will be much appreciated. Can bus connected, do i need to connect anything else? SN=002B04 013259

1

Dcyrptor not working, also cannot get pass step 3 programming

Error transmission failed check usb cable, cable has good connection, but it still gives me Receive ERROR after trying again Also cannot get pass step 3 after blue light is on, then i turn the ignition to the on position, with no indication of rapid blue lights, please help! Can bus is connected and good.

0

(evo one,2004 infiniti g35x,AT,regular key,no Thar) remote starts but dies after 8 sec

evo-one installed in my 2004 infiniti g35x, auto trans, regular key, using a start 2 ant. car starts on the first try but then dies after 8 sec. on second try, cranks only. after a bit if i send a fresh start signal it will do the same thing. Starts, runs 8sec, dies, cranks.

0

2008 g35x no longer needs OEM keyfob?

I just installed the EVO-NIST1 standalone with the Fortin RF642W RF Kit on a 2008 Infiniti G35x according to Guide 24031 and have a couple comments & questions after playing around with it:

1) LOCK x3 works with the OEM fob, however it cannot remote stop the car with LOCK x3 again. This is known, so it is not a problem.

2) After remote starting the car and unlocking it (either with door button or with either of the fobs), I can open the door, step on the brake, and I am able drive away. That works as intended, but the problem is I can drive away without having the OEM key fob around. The instrument cluster screen does not say NO KEY like it normally would if the key has left the car. In other words, one would be able to drive off without having any remote on them as long as the car gets remote started followed by an UNLOCK signal. Are remote starts intended to bypass the need to have the OEM Intelligent keyfob for the take-over?

3) While the engine is off, the LOCK signal from either the RF fob or OEM fob will lock the doors and prompt the RF antenna's LED to start flashing (blue) and will not stop unless I press the UNLOCK botton on either remote. What is this flashing for? Can this be disabled? I do not need or want any alarms or extra security features. I am more concerned about it draining the car battery. Please advise.

4) After remote starting, the first press of UNLOCK with the RF fob ONLY turns off the Antenna's flashing. I have to press unlock a second time to unlock the car, however it would unlock all four doors at once. I had configured it through Flash Link (B1 on) to unlock driver door on first press, and lock all on second press but that isn't the case. What exactly happens on the first UNLOCK that stops the antenna's LED flashes? Can I get the unlock button to unlock the doors on first press?

5) How does IDLE mode pertain to push-to-starts where the key does not need to be in the ignition? I'm guessing it is not needed but just want to be sure.

6) I had to use the RL2 connector to get remote starter to work, although the guide says RL1 for G35. This might be the issue with folks who cannot get their '07 - '08's  to remote start.

0

2008 Infiniti G35x - Car will start but cannot turn off with remote

I installed the EVO-NIST1 (standalone with T-Harness), and it is working fine. However, I cannot turn off the car with either remote (RF kit or OEM keyfob). I had installed the Fortin RF kit , because the manual states that 3x start is not compatible with the 2008 G35. For whatever reason, it actually works fine! When I press the lock button, I see a blue flash on the EVO unit. Why would I be able to start the car but not turn it off? Is there something specific that I need to do? I'm not sure how to troubleshoot the problem. I appreciate any suggestions.

1

Can I use the EVO-ALL as a stand-alone remote start for a 2006 Infiniti using the factory remote?

I was wondering if it was possible to use the EVO-ALL module as a stand-alone remote start for a 2006 Infiniti G35x with Intelligent Key? I have looked for the a guide for making the module stand-alone without an aftermarket remote starter, but have no had any luck. Additionally, I do have the Fortin Flash-Link. Thank you.

0

07 G35x Remote starts but cannot remote stop

I just bought the unit with the t harness which is ver 6 with preloaded 72.16 (tried both and 72.14 but currently using 72.17) for standalone operation. The car will remote start with lock unlock lock but if 3x lock is used it will start with one push. I've read about this problem and I'm okay with lock unlock lock. The car remote starts fine and will shutoff when timing out but I cannot remote stop it. The blue led will flash for each OEM remote press when the car is off but when on, it only detects unlock.

1

2008 nissan altama pts sometime says no key when you try to remote start

Don't no really what's going on I have done a lot of Nissan Altima pts and Infiniti g35 with wire guide 5a when I remote start sometimes it will not work one the first try it will say on dash no key ,then retry and start I believe it may be a software issue this week I have installed 6 remote starters on these type of cars and today have used a different bypass because it seems intermittent when using an evo all would like to no if I should down grade software thanks

1

2008 nissan altama pts sometime says no key when you try to remote start

Don't no really what's going on I have done a lot of Nissan Altima pts and Infiniti g35 with wire guide 5a when I remote start sometimes it will not work one the first try it will say on dash no key ,then retry and start I believe it may be a software issue this week I have installed 6 remote starters on these type of cars and today have used a different bypass because it seems intermittent when using an evo all would like to no if I should down grade software thanks

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer