English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Utilisateur

trevor gorniak

À rejoins en date due:

Sep. 25, 2011

Points

2230

Commentaire(s)

7

Questions votée(s)

2

Réponses votée(s)

1

Votes positifs

0

Votes contre

3

Votes reçus

1

Votes négatifs reçus

1

Activité récente

Questions demandée(s)

7

Question(s) répondue(s)

24

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question
ACTIVITÉ RÉCENTE QUESTION(S) DEMANDÉE(S)" QUESTION(S) RÉPONDU(S)" QUESTION(S) COMMENTÉE(S)"

03/01/2021

 Ford Vincent Viteritto (130Pts.)

0

2005 ford escape does not crank ?

I installed a EVO ONE with a RF 642w . Everything works locks,unlock,alarm.. When i went to actavate the remote start the parking light comes on as if its going to crank but does not ,parking light flashes 4 times then it try's to start again and fails to crank parking lights flash again 4 times . Then it stops . please help me
Connectez-vous pour répondre Voir 1 réponse(s)

31/12/2020

 Honda jatinder girn (160Pts.)

0

Yellow wire on Evo start 2

Hi Where to connect yellow wire for evo start 2 , im using evo one and Hon2 Tharness 2014 honda crv, key start
Connectez-vous pour répondre Voir 1 réponse(s)

31/12/2020

 GMC Tyrell Gray (130Pts.)

0

EVO-ALL won’t switch from yellow light to red light after I start engine during programming.

2018 GMC Terrain using EVO-ALL and thar-gm6, yellow light turns solid but won’t switch to red while programming, tried reset and re flashing but still won’t work, light blue is connected to light blue/black.
Connectez-vous pour répondre Voir 1 réponse(s)

27/12/2020

 Cadillac Brian Pretzer (160Pts.)

0

3x lock on 2006 escalade?

installed evo one into 2006 cadallac escalade but unable to get factory 3x lock to activate the remote start function, is this not an option for this vehicle? Is an RF kit required if not? Is there a possible work around? (external remote start wire on evo one i can use?)
Connectez-vous pour répondre Voir 2 réponse(s)

27/12/2020

 Audi mason maas (130Pts.)

0

Help with programming

Following the steps to install and after i have the t harness installed the new firmware unloaded to the module hold the programming button until blue light plug in all connections press program one time lights should go off and come on on flashing blue and that's where i can't get the light to come back on... any idea what i am doing wrong
Connectez-vous pour répondre Voir 1 réponse(s)

26/12/2020

 Hyundai Eric Woleben (130Pts.)

0

2013 hyundai santa fe ignition on but no crank

Remote start is in and programmed. Evo all is programmed. 2013 hyundai santa fe push to start. Hit lock button 3 times, ignition on vehicle never cranks. I have rechecked all connections and they are good. At the end of the evo-all programming it says the red led should flash 10 times, then blue should flash fast, then red flash fast. Then turn ignition off. The red flash fast never happens. I dont know of that's related or not.
Connectez-vous pour répondre Voir 1 réponse(s)

26/12/2020

 Pontiac Steven Smith2 (130Pts.)

0

is there a t harness for an 2007 pontiac g5

is there a t harness for an 2007 pontiac g5
Connectez-vous pour répondre Voir 1 réponse(s)

20/12/2020

 Hyundai Stephen Renna (260Pts.)

0

What wire to use evo one to connect to clutch bypass. 2019 veloster n push to start

Clutch switch has a white, red and 2 black wires on it.
Connectez-vous pour répondre Voir 1 réponse(s)

18/12/2020

 Volkswagen Brian Sahid (420Pts.)

0

Golf Diesel Support

Loking to do a 2014 VW Golf Diesel. Is this doable using a EVO-ALL and TB-VW?
Connectez-vous pour répondre Voir 1 réponse(s)

18/12/2020

 Jeep Mehmet Corbaci (160Pts.)

0

I have 2006 Grand Cherokee 3.0 CRD.

I have 2006 Grand Cherokee 3.0 CRD. Which module should i buy?
Connectez-vous pour répondre Voir 1 réponse(s)

16/12/2020

 Dodge Dine Smith (130Pts.)

0

Which is the easiest/quickest installation, the EVO-All or EVO-One?

I'm looking for the easiest installation, as I have to do it outside and it's winter. And cold. And snowing. Which is the easiest/quickest installation, the EVO-All or EVO-One? I don't want to wire door or hood switches, I just want to install the remote start. I installed one (unfortunately can't remember which) on my Mom's Ford Taurus and it was very simple, very little wire splicing, etc. Would like to replicate that with the Dodge Ram. Thanks!
Connectez-vous pour répondre Voir 1 réponse(s)

21/11/2020

 Chevrolet trevor gorniak (2230Pts.)

0

radio stays on after remote shutdown

after remote start then shutdown with the remote the radio stays on unless you open the door install went good software level is 70.21 tried 70.18 radio stays on till door is openeded
Connectez-vous pour répondre Voir 1 réponse(s)

07/12/2019

 Subaru trevor gorniak (2230Pts.)

0

install 2020 subaru crosstrek

looking for a install solution for a 2020 crosstrek can you please advise if one will be available soon
Connectez-vous pour répondre Voir 1 réponse(s)

07/12/2019

 FAQ Aleks Gryshchenko (310Pts.)

0

What is recommended wire splicing method?

Hi all! I'd like to know recommended wire splicing method. I'm electrician and just got Evo-All and Flash-link plus separate remote starter to go into my wife's 2010 RAV4 (it has a dot on the key so no Evo-One for me...) Is soldering the best way? And then heat shrink? Or there is a better way? Thanks!!!
Connectez-vous pour répondre Voir 1 réponse(s)

23/11/2019

 Toyota Sam Howell (130Pts.)

0

2014 Toyota Rav4 with THAR-ONE-TOY8 Installation EVO ONE

I'm having trouble reading the diagram on the online installation guide. Could you simplify this for me please?
Connectez-vous pour répondre Voir 1 réponse(s)

16/11/2019

 Audi Brandon Talaski (130Pts.)

0

EVO ALL will not start vehicle

everything should be hooked up correctly and also programmed correctly. when i go to start the vehicle with the lock button it will not start. Everytime i press the lock button the blue light flashes on the evo, so it blinks 3 times when i try to start the vehicle because i am pressing the lock button three times and the vehicle does not start. The vehicle will however start when started normally with the key.
Connectez-vous pour répondre Voir 1 réponse(s)

16/11/2019

 Jeep william perks (130Pts.)

0

2018 wrangler light stays solid blue through all steps, so it wont program

unit will not proceed past 1ST step light stays solid blue
Connectez-vous pour répondre Voir 1 réponse(s)

12/11/2019

 Honda Xavier Bolivar-Hazboun (160Pts.)

0

No way to remote start 2005 civic via fortin products?

Hey, To my knowledge, the EVO-ALL and EVO-ONE only work as an immobilizers on 2005 civics. I'm a bit confused as to what products I would need to remote start my civic as there doesn't seem to be anything in the fortin lineup capable of doing it. My whole plan was to install an evo start 2 but that doesn't seem possible. Can anyone confirm?
Connectez-vous pour répondre Voir 2 réponse(s)

03/11/2019

 Jeep Levi Kudrna (240Pts.)

0

What firmware for 2015 Jeep Cherokee?

I have an EVO-ALL with T-harness for a 2015 Jeep Cherokee. I'm having problems programming it to the vehicle. The lights on the unit aren't flashing per the instructions. I have firmware 68.01 as this was recommended in FlashLink. While troubleshooting, I noticed the website said minimum firmware is 74.24. Should I flash it to the latest 74.xx firmware instead?
Connectez-vous pour répondre Voir 2 réponse(s)

03/11/2019

 Ram Danny Mennerick (170Pts.)

0

Red light will not change to blue during programming

Light will not change from red to blue during key programming
Connectez-vous pour répondre Voir 1 réponse(s)

03/11/2019

 Ram Danny Mennerick (170Pts.)

0

step 4 light stays yellow when key is inserted 2015 ram 1500 tip-key

when i insert the key, yellow light stays on and doesn't change
Connectez-vous pour répondre Voir 2 réponse(s)

02/11/2019

 Ford trevor gorniak (2230Pts.)

0

2012 Ford Explorer PTS

installed evoall stand alone with solace RF kit remote start works fine door locks wont work i tried grounding the purple wire on the evo all and still dont work the blue light on the evo all flashes when the remote is pressed but wont unlock the factory remotes work to lock and unlock the doors when remote started and the evo all blue light flashes when the oem remote is used guide 88721 software is .57 evoall service number is 001A06814763
Connectez-vous pour répondre Voir 1 réponse(s)

27/10/2019

 Ram trevor gorniak (2230Pts.)

0

Evo all programming 20019 ram 1500 push start

Install complete and verified go to program evo all and at step 5 instead of the blue light coming on the blue and red comes on checked everything twice called tech support and they said don't worry about it. i ignored the red being on and carried on to next step and all was ok. Has anyone else seen this issue i hope they repair this in the guides so installers dont have these issues
Connectez-vous pour répondre Voir 1 réponse(s)

09/02/2019

 Honda Raymond Brantman (130Pts.)

0

2009 Honda Accord remote start will not work

I used the suggested settings using flash manager and followed instructions on connecting to vehicle and car will not remote start with OEM key (3x). Red light blinking when car is armed and blue lights blink when i hit the lock key each time and nothing starts.
Connectez-vous pour répondre Voir 1 réponse(s)

02/02/2019

 Dodge Todd Karlen (130Pts.)

0

Blue light shuts off when turning key to on position

2008 Dodge ram the blue light shuts off when I turn the key to the on position.
Connectez-vous pour répondre Voir 1 réponse(s)

No results

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question

Support Technique

Recherchez parmi nos produits les plus populaires et les sujets d'installation disponibles dans notre section Questions et réponses.

En savoir plus
Téléchargez notre application de guides de dépannage étape par étape disponible pour iOS et Android ou parcourez notre version de bureau.

En savoir plus
Accédez à la plus grande base de données de schémas de câblage et de photos en ligne de l'industrie. Un jeton gratuit est fourni dans chaque boîte EVO-SERIES.

En savoir plus
Vous n'avez pas trouvé l'information que vous cherchiez ? Posez-nous une question en remplissant le formulaire de demande de support technique. Un spécialiste produit vous répondra sous peu.

En savoir plus
Des solutions de contrôle à distance et de connectivité à la fine pointe de la technologie au soutien technique haut de gamme, découvrez pourquoi vous devriez choisir les produits Fortin.

En savoir plus

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer