Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

flashlink wont connect to evo all s# 001A06 682920

I think I reached the flash limit as the lights come on the evo all with the flash link but it will not detect oit. In bypass its a solid red light and in remote start its all the flashing at once. Any way to fix this? I tried the reaet procedure, but didnt work. Its for a 2013 silverado.

0

EvoCHRT5 on 2006 dodge ram 5.9

2006 dodge ram 2500 5.9 diesel I have evo chrt5 and updater only thing I’ve done is connect yellow on 20 pin to yellow on t-harness and green/red on 20 pin to purple on t-harness and my truck is still the same but the evo has no power can anybody help me

0

Audi Q7 dizel 2016

Привет. Как подключить EVO Q7 TDI 2016 Cтандартний ключ и есть кнопка . Каким руководством рользоватся ? Спасива.

0

Will the evo-vwt3 work on my VW Passat 2018 standard key and where can I find install instructions

0

Evo Start 2

Bonjour J'ai un Toyota Avalon 2019 avec un evo start 2 et le démarreur fortin evo one. Le tout fonctionne bien. Je peu barré et débarré via l'application également. Mon problème est avec le Statut du véhicule dans l'application. La demande statut ne fonctionne pas souvent et les informations de température sont erronées. Par exemple, il fait -10 mais il indique 20 degré dans l'habitacle alors qu'il n'a pas fonctionné de la nuit et on ai le matin au réveil. Le voltage lui me semble plausible. Je sais qu'il y a une façon de réinitialisé l'antenne evo start 2 mais je ne me souviens plus de la fonction et de la bonne procédure. J'ai tout de même essayer de débrancher l'antenne, de rebrancher en maintenant le bouton sur l'antenne jusqu'à ce qu'elle clignote orange rapidement puis jai essayé chaqu'un des mode de clignote bleu 1 a 5. Il y a un mode que je crois que c'est pour vérifier le signal ignition. J'ai réussi a refaire fonctionné le démarreur en mode 2 flash bleu puis appuyez sur le bouton. Jai pas tenté de redémarrer le moteur mais les door lock fonctionne. Cependant maintenant j'ai 8 volt de batterie et -37 degré donc j'ai empiré ma situation car la même le voltage est erronée (batterie sur la charge et en santé). Qu'elle est la procédure de réinitialisation factory reset de l'antenne evo start 2 que je puisse enfin avoir une bonne communication avec l'application et de bonne donné? Merci

0

please reset evo all SN 001A04 068596

0

Unable to Connect Module to Flashlink Updater

In Flashlink Manager, I am able to connect the Flashlink Updater (red LED on device solid and status shows "Connected"), but when I plug the Updater into my EVO-ONE the module will not connect to the Updater. Using Flashlink Manager v4.62, and Flashlink Updater has firmware v4.08.

0

HI I connected IVO LL Toyota Avalon 2021 GUIDE # 80741 Avalon 2019.

Авалон 2019 соместима с 2021 годомю.THAR-EVO-TOT13 Запрограмировалось хорошо.Только есть одна проблема:Неработают парковочний свет. Нет вихода А14 когда работает RS.Пожалоста помогите мне.Ето проблема прошивки? Или проблема модуль EVO ALL? Или есьть другие варианты решени етой проблемы? Спасибо.

1

2005 Toyota Camry Starts but factory alarm gose off

Hello Everone We installed a EVO One Sin# 002B04690023 with 411 RF kit on this 05 Camry with installation guide # 84961 we folowed it to a T the vehicle starts fine but when the factory alarm sets it gose off with it running. Do we forget or need to set something in the evo one to disable or bypass the alarm we can't find any setings for this Please help. Thanks,

0

THAR-ONE-SUB3 compatible with a 2012 Subaru Forester Keyed ignition ?

Documentation goes from 2014, but compatible vehicles list just states Subaru. Looking to pair with evo-one.

0

Hood pin installed but not functioning properly.

We installed the supplied hood pin and is not functioning properly. Starts with hood open and does not kill when started and popping the hood. Not sending trigger to EvoAll. Programming seems to be correct. Everything else works just fine.

0

Evoall no longer starts car

Hello, I have been using an Evo One Fortin kit to start my car for the last 3.5 years. I have a 2020 Honda Accord with manual transmission. It just recently started to fail to remote start my car. When I start it manually, it works and doesn't struggle to start. I noticed that all the functions like heated seats, blower fan, rear defroster all work and the engine turns over, but the engine does not start when I attempt to start it remotely. It does this three times before shutting down. It seems like the module is not giving the car the bypass code. I am using the 3X lock function with the OEM fob and not an RF kit with stand alone fob. Any suggestions will be greatly appreciated. Thanks

0

Mazda 3, 2018

The unit does not read the key, when the ignition is turned on nothing happens, the blue indicator continues to light Mazda 3, BN, 2018

05/02/2025