User

On the website it says remote start is only supported for years 2003 and older. Would remote start work on the 2001 using the EVO ONE and the 2003 guide and just hooking up the wires as found on here? 

http://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.aspx

I also researched about the OBD wire and it appears to be the same.

How do I get the EVO ALL to have lock/unlock outputs like on this guide https://cdn02.fortin.ca/download/75151/evo-all_ig_tsa_bi_nis1-m35-m37-m56-q70_pts_a_75151.pdf

I am trying to do this on a 2008 Chevy Silverado without factory lock/unlock and the 642W rf Kit 

Today I tried installing the Evo-All to a 2016 Ram 3500 diesel using the T-harness. I made it to step 7 and could not get past that. 

In step 7 it says “No key = Red” and “Key in= Red and blue”. Whenever i put the key in, the red and blue will stay on for a few seconds then only the blue will stay on. Is this supposed to happen?

I then put it into the RUN position but it will not flash rapidly. If I put it back into OFF, the blue will go back to solid.I checked the CANBUS wires multiple times and made sure they were at the right spot. I even switched them. In step 8 it says “ignition off= red” and “ignition on= red and blue off”. I dont see a red light after step 7 but the blue does turn off when the ignition is on.  One thing I did notice though was that the CAN-HIGH wire Grey/White Pin6 on the guide is a different color on my truck; its sort of a tan color but it is still pin 6. The yellow wire DOES match up. Would this have to do with anything?

I followed the intructions on how to test the CANBUS connection and ignition(https://fortin.ca/en/qa/403/programming-evo-all). The ignition is good but whenever I put it in RUN, the blue light will not flash so im sure its a CANBUS problem i just cannot figure out what it is. I also tried resetting the module and it did not work. I updated  it to the latest firmware and even dropped it down to the one it says on the guide but that did not work either. I also tried waiting in between the steps and no luck. Any help is appreciated.