Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

EVO-One starts then shuts off after 2 seconds

2017 Promaster gas standard key. After remote starting successfully, vehicle shuts off after 2 to 3 seconds. If it matters, the parking lights flash four times after it shuts down. Engine supervision selection is the recommended Tach Data-Link only selection. I've tried all other tachless, etc. settings in section 20 and none of them even start the vehicle. Remote start is lock/unlock/lock if that matters.

0

Is evo-one compatible with gasoline 2023 Ram 2500?

Install instructions only list diesel pushbutton start.

0

2014 ram 3500 will not remote start. Manual transmission

I followed the instructions for the thar-chr7 what else am I missing? flash link does not have an option for manual transmission I did not cut the yellow wire

0

cant get a steady blue light on evo one ram promaster

evo one ram promaster 2020 no solid blue light. checked all wires for connectios they are good. Looking at the wire color info and it shows that there is a second 12+(2) connection but the install guide ony show to 2017. Are there two 12+ connections or not.

0

cant get a steady blue light on evo one ram promaster

evo one ram promaster 2020 no solid blue light. checked all wires for connectios they are good. Looking at the wire color info and it shows that there is a second 12+(2) connection but the install guide ony show to 2017. Are there two 12+ connections or not.

0

'19 Ram promaster

Hello, I am looking to get remote start only for my '19 Ram 1500 promaster. It does not have remote start or alarm now. It uses a standard turn key. According to the website it says I can use the EVO-ONE. Looking at the install instructions on page 5, it shows what looks to be a remote starter module of some sort?

Am I looking at the right instructions for this setup?

If so, do I need another part?

 

Also, is there a t-harness made for this yet?

 

Thanks!

1

Promaster Horn

I have an EVO-One installed and just installed the RFK912. 2018 Ram Promaster 1500 Gas. Two things: 1. Honk on remote start (after lock unlock lock) horn beeps then starts. I want to eliminate the horn beep! It will wake the dead it's so loud, I wish it would just chirp. I think I have everything I can find turned off or to lowest setting but nothing's changed 2. Horn confirmation on unlock? I'm used to a horn chirp on cars when locking but the RFK912 makes no confirmation chirp on lock, but it does on unlocking. I want this to be reverse and a chirp honk rather than blaring horn (see above) I don't really want to disable the horn altogether so wanted to check to see if I'm missing something in the module setups

0

Does EVO-ONE need a clutch wire for 2014 Ram 3500 diesel manual transmission?

After researching my options for a manual transmission I've determined the EVO-ONE coupled with the THAR-CHR6 was the best configuration for a stand alone system retaining original smart tip key. (Please correct if there is another option) According to another Q&A discussion regarding a RAM 3500 manual diesel, it was mentioned by Antoine Marion that a "clutch switch wire" has to be connected. After referring to Guide # 98581 for the EVO-ONE I did not find any information regarding the clutch switch. Shouldn't this be handled through CAN bus or does it need the clutch wire bonded with an output on the EVO-ONE?

1

Key take over has suddenly stopped working?

I've had fortin remote start for about 8 months, while I was driving it suddenly the dash went flashing. And I stoped turn off the truck and started it again normally. Then when I went to try to remote start it everything worked until the key take over. When i pressed on the brake its just shuts off now. Normally what I do is remote start x3Lock, then unlock and close door, insert key and turn to run position, and then wait 5 seconds and then press brake pedal and shift and go. But it has suddenly stopped working. Has anyone else had a similar situation. The parking lights come on, I have all the recommended settings for my truck. I have updated it to its recomended. 2016 ram 1500 ecodisel. tip key

0

2016 ram 3500 manuel evo-one 8 seconde cranking ne fonctionne pas

j'ai tenté a plusieur reprisede configurer , le evo-one pour qu'il crank plus longtemps , parlé deja a une personne au telephone me disant de selectionner le mode 20.5 8 second cranking , mais selectionner ou pas , le crank est d'environ 2 seconde et arrete , parfois 1 sur 5 le moteur parvient a demarrer, comment je fais pour pouvoir avoir au moin 5 seconde de cranking , tout le cablage est ok , le ready go est ok juste la programmation qui bug , comme si meme je change les parametre ca fait rien quoi faire ?

0

evo one module won't power up

Hi.. i'm trying to use compustar rf kit to evo one and i modified the antenna wire of compustar according to evo protocol but i plug in to evo one antenna port and i realized that is should use the datalink port instead compustar antenna is not responding so i tried plug the evo one to flashlink if i can change the rf setting but the module won't get any light that power indicating. is there any posible to reset the evo one?

0

2015 Ram starting but not staying running

2015 Ram starts For about 2 seconds and shuts right down and then tries to restart and then shuts down again. Somebody please help. I have tried reprogramming and nothing. I have 12 volts at the ignition wire. Please help.

0

Truck shuts off after pressing push start button

When using the remote start the truck turns over fine, but when pressing the push-start button nothing happens and as soon as I touch the breaks to change gears it shuts off.

04/07/2019