Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

08/01/2022

 Hyundai TANBIR SINGH (260Pts.)

0

Hyundai sonata 2017 - diode required to install evo one

Hyundai sonata 2017 - what diode to use in installation of evo one for PTS wires and what side does the cathode/anode go?
Login to reply View 1 answer(s)

17/01/2021

 Hyundai Shawn Binda (180Pts.)

0

EVO-KEY programmed for 2012 Sonata (key with immobilizer) but still not starting?

I purchased an EVO-KEY to work as the bypass on a OEM hyundai remote starter. I installed the remote starter successfully however I needed a bypass. I ourjsed the evo-key and installed and was able to get it programmed as instructed. However, the immobilizer is still not being bypassed. What am I missing here? I don't have a data link so everything is hardwired.
Login to reply View 1 answer(s)

01/11/2020

 Hyundai Tobias Bullert (130Pts.)

0

2008 Hyundai Sonata Evo one cant get to program

EVO-ONE with T-harness THAR-ONE-KHY1 can not get it to program. blue led stays on solid. turn ignition on light goes out. no rapid flashing. turn igniton off, blue LED light come back on and stay on solid, followed the guide with all wires. tried switching can wires with no success. Has no immo wire. also programmed remotes , car will start with exssesive crank time and shuts off after few second. get a 4 flash message no tach. please help thanks
Login to reply View 1 answer(s)

29/10/2020

 Hyundai Rafael Marzocchi (150Pts.)

0

2018 PTS SONATA - EVO-ONE + EVO START 2 - WHICH IGNITION WIRE?

Planning on buying the EVO START 2 to be added to my EVO-ONE on my 2018 PTS SONATA. Evo Start manual shows a yellow wire that needs to be connected to ignition. My install is a high current with 2 wires market as ignition (E1 and E5 on the high current connector). Which one should I use, if any? Is that only to monitor the state of the start sequence to send info back to mobile app? Appreciate the support. Cheers
Login to reply View 1 answer(s)

15/07/2020

 Hyundai Jon Olofson (190Pts.)

0

Wires seem miss-labeled in 2015 Sonata PTS instructions

Wire colors labeled differently on 2 pages for CAN1, description section says blu/wht install illustration has yel/brn
Login to reply View 2 answer(s)

05/12/2019

 Hyundai HARPREET SINGH DHILLON (670Pts.)

0

My Hyundai Sonata cranks but not starting

I checked every wire so many times and programming was done properly but Hyundai Sonata cranks but not start. I am using evo one.
Login to reply View 1 answer(s)

23/11/2018

 Hyundai Josh Ley (500Pts.)

0

2011 Hyundai Sonata attempt to start 3x, cranks, doesnt catch

Have a 2011 Manual transmission Hyundai Sonata. In the morning, customer states that when remote start is activated, it will attemp to start three times, but it will only crank, and not run. Double checked all wiring.Checked output from remote start, IGN and Start have power while cranking, ACC and ACC2 have power while ON but not cranking. Starter is crimestopper rs4-g5. No bypass module (US model-no transponder key)
Login to reply View 1 answer(s)

26/01/2018

 Hyundai Daniel Waslenko (2650Pts.)

0

2017 Hyundai Sonata throwing CEL

I did an install on a 2017 Hyundai Sonata. I did the install and everything worked perfect. Flashed it to the latest firmware. 1 week later the check engine light is on and he is blaming the remote start and is demanding it torn out, which is not going to happen. I know a number of the chryslers need the firmware rolled back because of timing of signals on the can bus. Can this most likely be fixed by changing the firmware setting? I have not checked the CEL codes yet, and the vehicle is an hour away. I also do not have the serial number on hand, It was done with an Evo-All and Viper 4806V. I have done dozens of installs with this unit combination and never had an issue. I would really appreciate any help.
Login to reply View 1 answer(s)

26/10/2017

 Hyundai Carlos Paige (750Pts.)

0

05 Hyundai Sonata will not shut off after starting with key fob.

Hi my Evo One was working great for a year. Now when I start my car with either key fob, it will not shut off by pressing the brake with the key out of the key switch. Or by inserting the key and switching to on postion and back to off. The only way to shut it off is with the key fob. Everything else is function normal.
Login to reply View 1 answer(s)

27/08/2017

 Hyundai Erik Helsinger (170Pts.)

0

Need help with steps 4-6 programming EVO-ONE for 08 Hyundai Sonata

I purchased an EVO-ONE, RF-ALL-642W, Flashlink 2, and a THAR-ONE-KHY1 ignition T-harness and made the following connections to my US spec 2008 Hyundai Sonata. I have updated Bypass hardware version 2, firmware version 76.34 and Remote starter hardware version 7 firmware 1.21. Flashlink updater hardware version 4, firmware version 4.03 Cut loop for automatic transmission. Plugged 4 pin antenna wire to Blue connector of 4 pin data T-harness of RF-ALL-642W kit and plugged antenna to other end. I have connected the ignition T-harness at ignition pigtail, parallel soldered the 20 pin Yellow wire to the Pink wire of t-harness at EVO-ONE. Ignition T-harness Black wire ring and 4 pin data Black (added crimp ring) to known good dash ground. 4 pin Black data connector Red wire soldered parallel to Red wire of ignition T-harness. Soldered 20 pin Black parallel to Green wire at foot brake switch. Clipped Green PATS wire at driver kick - White connector (chassis) 20 pin Lt. Blue and 6 pin Red connector White/Green to harness side of Green wire at driver kick. 20 pin Lt. Blue/Black and 6 pin Red connector White/Red to connector side of Green wire at driver kick. 5 pin Grey/Black can low soldered parallel to Yellow wire at OBD-II 5 pin Gray can high soldered parallel to White wire at OBD-II When I hold the programming button down and plug in the 6 pin ignition T harness, Release programming button on Yellow and cycle the key from off to on, nothing happens, the light stays solid Yellow. I have confirmed that the yellow wire is getting 12v only on ignition hot. The car starts and runs with the key for several minutes, I switched the green clipped PATS wire connections and no change was observed. Searching the Q&A I found how to test the can bus by plugging the Black connector in while holding the programming button down, releasing on Blue, then plug the rest of the connectors (all of the ones listed above) in and turn the ignition on. When I do this the Blue light goes out. When I turn the key off, the Blue light comes back on. I have 1.89VDC and 2.27VDC on the can bus lines to a known good ground in the door jamb. Please help! Where do I go from here?
Login to reply View 2 answer(s)

30/10/2016

 Hyundai Carlos Paige (750Pts.)

0

Site only show T-Harness installation guide. Is there any additional wiring needed for the 05 Hyundai Sonata?

Wiring diagram came with EVO-ONE. But there is no other installation guides on the site other than the T-Harness installation. Does the 05 Hyundai Sonata only require the T-Harness and no other wires connected.
Login to reply View 1 answer(s)

03/12/2014

 Hyundai joel stith (350Pts.)

2

12 sonata pts various issues, programming?

I am installing an evoall in standalone mode on a 12 hyundai sonata pts. The unit programs fine. If I have "lock unlock lock" checked in settings, the unit will flash blue when hitting lock or unlock buttons, but wont actually try to start the vehicle, no leds lit, nothing" I called tech support and I couldnt completely understand but I understood it as set to lock, lock, lock, reset unit and reflash. I reset the unit, and checked no under "lock unlock lock" The vehicle will start now, however it will start with one press of lock, therefore starting the car if you even try to lock the doors. Also, I do not have the setting checked to shut the car down when the door opens, however the vehicle shuts down when the door is opened. I checked the keysense wire and I am getting ~5v that goes to 0 when the key is in the holder. Is this just something to live with with evo-all in standalone mode or do I have an incorrect setting? Thanks
Login to reply View 2 answer(s)

11/02/2014

 Hyundai Denis Galway (140Pts.)

1

engine light on 2013 hyn sonata push start evoall and autostart installed

scan 2 erase engine light
Login to reply View 0 answer(s)

27/01/2014

 Hyundai mike law (140Pts.)

1

Can I install a remote start on a 2011 hyundai sonata push button start with just the evo all module

I have had several different answers from installers that I may need a remote start kit. wondering if the evo all is all I need including the interface module
Login to reply View 1 answer(s)

10/01/2014

 Hyundai leo kim (840Pts.)

1

2012 Sonata PTS - Compustar, Keep car running?

With key start, when car is running, I can press and hold remote start button, and car will keep run. This is a convinient feature when i just need to go grab something quick and want to have car keeps running. But with this PTS, while car is running, sit inside, and press and hold remote start button, 2way remote gets confirmation that remote started and shows countdown of 15minutes. Car keeps running. But as soon as go out and close door, I hear a constant beep and shows "key is not detected" on display. Lock the door using remote. Car is still running. Then few minutes later, unlock door using remote, get inside of car, step on brake, car shuts down. It car won't take over. Other than that, remote starts fine and takes over fine. This extra feature is not really neccessary but would like to know why. Is this a firmware issue or is this normal for PTS? I am using hardware 6 and 76.02, hardwired.
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue