Utilisateur

Hello everyone, 

Looking to install this evo all with this radiostar generation remote starter (https://policeauctionscanada.com/Listing/Details/49897032/Radiostar-2-Way-LCD-Vehicle-Security-System-Remote-Start-240093B) As my buddy is insisting to use it. It wouldve been a lot easier if i do it with fortin RF kits. Anyway. My question is according to the this diagram on the fortin website (https://cdn02.fortin.ca/download/66011/EVO-ALL_IG_SAL_BI_FOR-EDGE_2015-2017_C_66011.pdf)

Where should i connect all those dotted lines going to the remote starter? There is no datalink on this remote starter. Unlock and lock to the remote starter side? Specifically the “start/stop external” and the “convenient ignition out” from evo all going to the remote starter side? Im confused. Please help. I appreciate it. Thanks in advance

2018 Kia Niro PTS Hybrid guide using EVO-ALL shows Ignition 1 goes to Ignition 2 and ignition 2 goes to ignition 1, Is this right or Wrong?

I have a 2017 Kia Sedona (automatic transmission) that got broken into. The criminal trashed the ignition system. Rather than replace it, I converted it using the Ghost Key by JDI. The button works as follows: wave the key fob over the antenna, then push the start button once. This turns on the radio. Pushing the start button a second time turns on the gauges. A third press will turn everything off. To start the vehicle, wave the key fob over the antenna, put your foot on the brake, and press the start button. I have everything installed according to the install guide (here), but when I get to the programming section on page 5 (program 2 without EMS com wire) I get stuck on number 4. I've tried pushing the start button (single and double push) and starting the vehicle, but the light never flashes. I just stays solid blue or turns off completely. Should I use the program sequence for the push to start model or is there another way of programming the module?

Any help is greatly appreciated.

Hello. Tell me, I have EVO-NITS1, what else do I need to do or buy to connect the evo-start app?

EVO ONE NEEDS A DECRYPTOR RESET. SN#002B04108420

Hi i have evo one and i change in settings on my flashlink 4 the number 6 option it says door lock before and after remote-start it was no so I chose Look after remote-start 8.3 after that when i run my car by the remote my wheels don't turn full only half but when i turn my car by the button it's work fine so I do the reset bypass side and return to the flashlink 4 and the same option number 6 door lock before and after remote-start and I put it back to no like it was and i did decryptor but nothing change the opinion didn't work when i turn the car by remote didn't happend like before it was like door open the closing then the car run 

My evo one SN#002B04108420

Flashlink 4 SN#002505 085445