Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

2005 Toyota Tacoma without Transponder key amplifier

I have a 2005 toyota tacoma without a transponder key amplifier, the installation guide said that I should connect the A10 terminal to Rx and the T20 terminal to Tx, but I do not have these cables, because I do not have the 7-pin connector of the transponder, where I should connect them ? What I see is that the guide for a 2010 Toyota Tacoma with type G key is very similar to the 2005 that I have, even down to the ignition cable colors. what should I do? With which diagram should I connect my remote starter?

0

2005 Toyota Tacoma without Transponder key amplifier

I have a 2005 toyota tacoma without a transponder key amplifier, the installation guide said that I should connect the A10 terminal to Rx and the T20 terminal to Tx, but I do not have these cables, because I do not have the 7-pin connector of the transponder, where I should connect them ? What I see is that the guide for a 2010 Toyota Tacoma with type G key is very similar to the 2005 that I have, even down to the ignition cable colors. what should I do? With which diagram should I connect my remote starter?

0

Tacoma 2005 4Cyl AWD Manuel

Bonjours J'ai un démarreur à distance à installer sur un Tacoma 2005 4Cyl Manuel AWD avec le module Fortin Evo. J'ai analyser les plans et je voulais savoir si ma facon de le brancher serait correct. Bref je brancherais le tout comme les plan fournie pour transmission automatique mais le fil ST2 (Blanc) du module fortin je le metterais sur le fil Noir/Jaune de la clutch. Vous en pensez quoi? Merci beaucoup!

0

2015 Toyota Tacoma EVO-One, parking lights always on when running, and stay on after time out.

I have the EVO-One wired in with RFK942 RF Kit and everything functions, but I have three issues. First the parking lights are always on when running. Is there a way to fix that? Second, when the remote start times out the parking lights did stay on until the drivers door was opened, so I wired the blue wire to the door pin switch wire Green w/ yellow, and programmed Option 32 mode 3. Now the door open dash light is on all the time, acting like a dead short insted of pulsing. Did I program this wrong? I was following the advice of two other posts I found. Three, the lights never flash when I lock or unluck the doors. Any idea why? Please advise, thanks.

0

2014 Toyota Tacoma manual tranny support

Is there a support for 2014 Toyota Tacoma manual transmission for evo one? G key

0

2018 Toyota Tacoma EVO ALL or EVO ONE

I apologize if this is a repeat question but I couldn't find an existing answer. I have a 2018 Toyota Tacoma with PTS. I don't intend to install any 3rd party remote starter. Will the EVO ALL work for remote start on its own or will I need to install the EVO ONE?

0

Three Wiring harness for 2013 Toyota tacoma g key?

I just want to make sure that the 2013 tacoma with the g key only needs one wiring harness for the igintion and that harness as well comes with the obd included in fortins evo on kit that they sell

29/03/2021

Toyota Jim (850Pts.)

0

Hardwired EVO-ONE in 2001 Tacoma with RFK411 unable to send two unlock pulses to unlock all doors.

My EVO-ONE is hardwired into a 2001 Tacoma. I seem to be unable to send two quick unlock pulses with the RFK411 remote to unlock all doors. There has to be a slight pause between presses in order to get two unlock signals. Unfortunately, if you wait too long, you will not unlock all the doors. Consequently, it is hit or miss to get all doors unlocked. Is this a property of the remote to have this refractory period or a property of the EVO-ONE. If it is the remote kit, is there another one you recommend that does not have this refractory period. If it is a property of the EVO-ONE, can new firmware correct this or is there an older firmware that corrects this. I have tapped into the driver side key switch that will open all doors when the key is turned twice. My plan was to put a relay to control the actuator so that the first press opens the driver door and the second press opens all doors. Before I install the relay, I wanted to see if the two press unlock will work.

0

EVO-One and Viper VSM550 2020 Toyota Tacoma H-Key

2020 Toyota Tacoma Auto, No factory alarm, H Key. Evo-One No RF kits Viper VSM550 Cellular Tried following the guides, remote start works fine, but the vsm550 did not have a green light and would not communcate with the evo-one. May have used the wrong remote start side firmware at first, i used the "recommended firmware" that flashlink told me. I think 1.25 Used the latest Bypass firmware flashlink recommended, cant remember at the moment what it was. Installed the unit with the t harnesses, made the tmps cut etc, all seemed to work as it should, realized the cell was not working, so i pulled the unit to bring inside and was going to drop it down to 0.83 which i did. However when i went to check the options for the rf kit, xl202 option was missing but checked, it show N/A along with several other options that way. Tried to flash to a different firmware and back, even tried uninstalling flash link and reinstall, didnt work. decided to flash it to my honda pilot and then go back to my tacoma but apparently at this point i am told i can no longer flash the unit. That being said, i can now see the option for xl202 again, note the option was there when i first flashed it all and took to the truck, it was only gone when i tried to drop down to .83 My main question now is: 1. can someone please unlock my unit so i can flash it back to my truck. - 002B04 008976 2. what is the correct combination of firmwares / latest firmwares for my setup, bypass side and remote start side.

0

2009 Toyota Tacoma Evo One Programming successful, but wont start

After successful programming, we couldn't figure what exactly is wrong. Continuity was checked on every single wire configuration and all tested properly wired. Hood pin, lock/unlock/lock Unit S/N 002B04 107018 Is there anything else needed that we are missing? Thanks in advance

0

Remote start what model to buy for 2019 Tacoma H-Key

2019 Toyota tacoma Extended Cab 4 cyl automatic 2 WDR truck with H key with keyless door entry fob. Want to install remote start that works with H-key fob. Not 100% sure, what model works.. Appreciate. Also looking for same for 1. 2013 Honda Odyssey EX automatic 2. 2011 Acura RDX 4 cyl. turbo automatic Base model.

0

No horn chirp evo one 442 rf kit with a 2017 Tacoma H key ?

Everything works great on this evo one 442 kit, the rf remotes give an audible signal at lock, unlock, and start, and it works very well...but there is no audible horn chirp from the Tacoma at all, just the normal flashing parking lights , but no horn chirp. Is there a setting I'm missing on the bypass or remote side ?

0

2016 Tacoma Automatic - Push button - EVO-ONE w. MYCAR Telematics

Hi, I had succesfully installed the EVO-ONE and using factory fob for remote start; The MyCar unit arrived with instructions. install-guide-64631. Everything works per instructions until step 8; when I press brake and release and then turn off, I get several blinks of lights and Evo unit, not the "Once" that is expected. Mycar is online and I can see the unit, car voltage etc. It will just not learn to the EVO-ONE... I cannot seem to get past this step. STEP 8. LEARN THE TELEMATICS DEVICE TO THE EVO-ONE In order to communicate with the remote starter, the MyCar must be learned to the EVO-ONE. 1 - Cycle the ignition to the ON position. 2 - The YELLOW LED on top of the EVO-ONE should come ON. 3 - Press and Hold the EVO-ONE push button for 5 seconds. 4 - The parking lights and the RED LED on the side of the EVO-ONE will turn ON. 5 - Release the push button. 6 - Press and Release the push button 5x times. Everytime the push button is pressed the parking lights and the RED Led on the side of the EVO-ONE will blink. 7 - Then Press and Release the Brake pedal. 8 - Seconds later the RED LED on the side of the EVO-ONE will blink once to confirm that the MyCar ID has been learned to the EVO-ONE.

0

2013 Tacoma Evo one lights won't turn off after time out until doors are opened

Everything work except when remote starter times out the lights stay on and wind go off unless the door is opened

0

connect evo one to 2018 tacoma manual transmission

hey there ,, purchased an Evo one for my 2018 Tacoma with h-key manual transmission,,, need to know to how to wire it in for clutch cancel ?!?!?!?!?!?!? thanks in advance

0

EVO one on 07 Tacoma and Fortin RF641W RF Remote Kit

I installed the rf remote according to the instrucions siclucing the t-harnes which is not applicable to my application. In the RF remote box there were instrucions on how to connect the antenna to the EVO- All but nothing about the EVO-one. The only place that the black 4-pin data connector for the antenna kit plugs into the same one as the flash link. Is this correct? 

When ateempting to follow the instrucions for programming i get to step 5 where you press the botton for the blue and red lights to come on. then when I inseret the keys nothing happens. the yellow light never comes on and the antenna never flashes. i have double checked the wires and nothing seems to be out of place?

0

07 Tacoma with evo one rf remote compatibility.

I installed the Evo one using the instructions. When I was done programming and I removed the key from the ignition. The red light disappears and then no lights will reappear again. I have tried to re program and have checked every wire 5 times. The truck does not attempt to start when the button sequence completed, it acts normal. I am unsure what to do at this point. I posted this comment and your team pointed me in the direction of purchasing an rd remote. My new question is will this remote of amazon work or am I required to purchase one of your remotes off your website. https://www.amazon.com/dp/B077RK1721/?coliid=I1W0760N16V5W1&colid=3IM9C51TEGW1Z&psc=1&ref_=lv_ov_lig_dp_it

0

Toyota Tacoma Evo one installed but will not start or blink after being programmed.

I installed the Evo one using the instructions. When I was done programming and I removed the key from the ignition. The red light disappears and then no lights will reappear again. I have tried to re program and have checked every wire 5 times. The truck does not attempt to start when the button sequence completed, it acts normal. I am unsure what to do at this point.

0

Evo-One will not program to a 2012 Tacoma

2012 Tacoma, G key. Guide # 78271. Service #002B07340061. Good up to step 4. Step 5; Turn ingition to on/run no fast flashing red / blue lights. Goes to a slow flasing red. I tried CAN bus removed with 20.2 enabled.

0

remote start doesnt work

Function C1 programmed. 38.1 and 2.1 programmed. but remote start doesnt work.

0

remote start doesnt work

Function C1 programmed. 38.1 and 2.1 programmed. but remote start doesnt work.

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer