Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

2005 Honda Pilot EVO-ONE Omega OL-RF-15-SST no remote start

Hello,

Ive installed an EVO-ONE with Omega OL-RF-15-SST RF Kit into my 2005 Honda Pilot and i have been unable to get the remote start feature to work. Lock/Unlock functionality work using the Omega remote and when i initiate the remote start function, the remote chimes to indicate it transmitted the remote start signal and the lights on my car flash 3 times and the red led on the EVO unit lights up for a second or 2 then goes out but nothing at all happens after that.

Update: After switching from bypass firmware 73.39 and 73.28 the remotes no longer work and the valet switch no longer works either, so i can try to reconfigure the rf kit. I dunno if my unit has a bug and needs to be master reset or what. I also have no rf kit options other than Fortin RF Kits, if that makes any difference. I have tried the suggested remote starter firmware and the OM 0.44 formware for Omega RF kits to no avail. any help would be appreciated.

 

Bypass service # 002B04253114

Remote Starter Service # 002B07253114 

0

Evo-all not compatible with 2005 Honda pilot

Why does it show that the evo-all remote start function is not available on the 2005 pilot but is available as a function on the evo-one? Is the comparison chart labelled in error? Not sure how the evo-all cannot be used as a standalone remote starter when wanting to use the factory remote

0

US vs CA Model?

2019 Honda Pilot PTS EVO-ONE THAR-HON8 T Harness Install with takeover. Telling me to plug the grey 12 pin connector on the T Harness to Plug that is located at steering lock module under steering column. I looked this up and only the CA and Mexican built versions of the pilot have this Steering lock module installed. This is not on my Pilot. Can I get a picture of where I am supposed to plug this in if I dont have that module under my steering wheel as I cant find it for the life of me.Im assuming that with the wire thats coming from the EVO-ONE saying its a bypass and it being connected to a steering lock module on the other model, maybe some sort of immobelizer or something? Any help would be super appreciated! Thanks in advance!

0

US vs CA Model?

2019 Honda Pilot PTS EVO-ONE THAR-HON8 T Harness Install with takeover. Telling me to plug the grey 12 pin connector on the T Harness to Plug that is located at steering lock module under steering column. I looked this up and only the CA and Mexican built versions of the pilot have this Steering lock module installed. This is not on my Pilot. Can I get a picture of where I am supposed to plug this in if I dont have that module under my steering wheel as I cant find it for the life of me.Im assuming that with the wire thats coming from the EVO-ONE saying its a bypass and it being connected to a steering lock module on the other model, maybe some sort of immobelizer or something? Any help would be super appreciated! Thanks in advance!

0

2007 Honda Pilot security light flashes after remote start

Using KEY-OVERRIDE-ALL. Programmed fine and remote starts fine, but green key light in dash flashes and stays flashing even after key take-over. Wondering if i missed something.

0

Enable heated seat on 2012 Pilot

While programming the unit, I found the option to turn on the rear defrost and heated mirros. I did not notice an option for the heated seats. Since the feature is controlled by multiple pushes on a button instead of a hard on/off, it can't be pre-set when exiting the vehicle. Is there a way to control this feature for the driver seat?

11/12/2019

Honda N/A (130Pts.)

0

Which to purchase for 2014 Honda Pilot EXL?

I'm looking for clarifiction on the installation and requirement differences between using the evo-all with standard installation and the evo-one with standard installation.

0

2008 Honda Pilot cranks but not starting.

I installed a Viper 4806V and Evo-All Unit on the 2008 Honda Pilot. Followed all the wiring diagrams and instruction. All works except to the part the its cranks only. I followed the Guide # 82931 and flashed the unit before installing. Im using d2d connections and connected only A1, A10 D4 and D6 wires. I followed the programming procedures till step 5 the red light will flash rapidly then leds turns off before i do step 6 the red led is off already before i turn the key to off position.

0

2005 Honda Pilot w/Evo-One not locking/arming after start

I have installed the Evo-One along with a Crimestopper RFALL642W RF kit. I initially was having an issue where the OEM alarm would go off when I remote started the vehicle. I followed the guide and enabled option D 2 and connected the Purple and Purple/Wht wires along with the Orange Disarm wires.Everything is working as expected, the RF key fob will lock/ulock doors and ulocks/disarms the OEM alarm before start but it will not lock/arm after remote starting. I seen in another thread somone was having a similar issue and you said they could connect the Purple wire with 2 diodes to the LOCK and ARM wires at the same time. Can you please explain exactly how to wire them, where to put the diodes and what direction? And also why you would use them? Thank you!

0

Honda-SL3 & Compustar CS800s connection

I'm hooking up a CS800s in a 2007 Honda Pilot. I will be using a Honda-SL3. There is a wire that I'm supposed to connect to the remote start unit, but I cannot figure out where to connect it.

0

how to do decryption with evo-one and 2005 honda pilot

2005 honda pilot. followed fortin documents CONNECTION2 and PROGRAM2 remotes are working. program procedure worked as expected on page 8/10 in fortin docs. when attempting to start the engine just cranks but wont start. i suspect its a decryption thing but there is no such option in the FLU software . unless it has something to do with the "toggle" button? i dont know what that does but when i click it my EVO-one goes offline and the software says its disconnected.

01/06/2017