Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

User

Sean

Joined on the:

Jan. 7, 2020

Score

750

Comment(s)

7

Voted question(s)

0

Voted answer(s)

0

Votes up

0

Votes down

0

Votes up received

2

Votes down received

0

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

0

2007 City Golf evo one 411 install

I am going to be installing an evo one 441 into a 2007 City Golf manual, for the handbrake reading another question I am on my own for the clutch bypass which is easy enough, however the guide says that lock/unlock/arm/disarm/foot brake are not supported, I was under the impression this car is electrically identical to a 2002-04 mk4 Golf which has those features supported. I don't mind making the extra connections if need be however obviously rather have it all done via CAN So does the City Golf support lock/unlock/arm/disarm via CAN like the earlier 02-04 Golf or no? Thanks

28/12/2022

FAQ Sean (750Pts.)

0

Adding 2 way remote to one way starter

I have an Evo one with rfk441 installed, I would like a 2 way remote, looking at the parts list the rfk442 uses the same antenna, can I simply buy a rm442 remote and have 1 2 way remote and 1 1 way remote with my starter?

10/01/2022

Ford Sean (750Pts.)

0

2006 F150 door locks inop after remote start timeout

2006 F150 5.4 FX4 with EVO ONE and RFK 441. The unit works fine however after the 15min run time out or if you shut the vehicle off with the remote the doors won't unlock with fob or the keypad on drivers door, lock still functions. If you open and close the door then it begins to work again The only way to remedy this is to use the key to open the door or to remote start the truck and unlock the doors. This is very much a truck issue not a remote start issue as this vehicle is all analog connections. Is there a wire that I can have pulse the door pin to shut the radio down and simulate the door opening as I believe that would fix it. There was nothing mentioned in the install guide.

0

2013 Touareg no crank 3x lock Thar-AUD1/Evo all

2013 Touareg 3.0 TDI, unit programs fine however when 3x lock the vehicle dash lights up but no crank. I triple checked PIN2 of the BCM connector for the brake lights as directly across in PIN18 is the same color wire, also with a test light at the module it lights up with ign on and pressing the brake pedal. I assume its an option in the module that needs changing. Module S/N is 001A07217040 Thanks

0

2014 Golf SportWagen push to start wont start with 3x lock

Using 3x lock hazards flash, doors unlock, then re lock starter engages for a split second and stops and I can see the dash illuminating steering lock fault and have codes in the steering lock module for terminal 50 short to B+. Using evoall with vw tharvw1 so very minimal connections. Latest firmware flashed and using the selected options for the vehicle in flash link.

0

2011 Tiguan starts and stops and says key not in range. Starts fine with key

Helping a friend install evo all and T harness vw2 and TBVW, installed and programmed fine, key starts car no issue but when remote starting car shuts off right away and says key not in range. TBVW is soldered in if that connection was bad then I would think I would have issues key starting it. What should I look at first? replacing the TBVW? I would assume the wiring back to the module is good since it programmed no problem. Immobilizer bypass is enabled in programming as well.

31/10/2020

Audi Sean (750Pts.)

0

2004 Audi A4 manual transmission

Looking at installing evo one in my manual trans A4 the wiring diagram does not incude manual cars. Should I be running the starter wire up inside the ecu box and connecting it after the clutch lockout or should I just run pin5 of the evo one 20 pin connector to the grey/black wire coming out of the clutch switch under the dash so the clutch switch relay functions like it should?

18/10/2020

Audi Sean (750Pts.)

0

2002 Audi A4 starts and shuts off Evo one

Car starts and runs for 10 or so seconds and shuts off. I don't hear any clicking relays flashing a parking light code. Has 3 codes for ignition switch 00576 00844 01744 in the steering module, swapped ignition switch, same issue. In wire color it lists the small gage blue wire on the IGN switch as starter 2, I've double checked all the wiring I feel as if there's a missed connection, the locks/trunk all work flawlessly.

13/01/2020

Audi Sean (750Pts.)

2

After remote start can press brake and drive vehicle for remote start run time without key

2013 Audi q5 with Keyport and no push to start Evo all module with t harness. Works flawlessly otherwise latest firmware is 60.08 but install guide says 60.02. I assume it's just a matter of pulling the module back out and selecting an option I just don't know which one.

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue