Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

User

Robert T

Joined on the:

Sep. 9, 2011

Score

301140

Comment(s)

2484

Voted question(s)

1040

Voted answer(s)

876

Votes up

37

Votes down

1891

Votes up received

28

Votes down received

0

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

0

2018 RVR LED & headights light Flash continusuly after Remote Started

Hello everyone We installed an Evo-One on this RVR 2018 with factory HID headlights and LED Fog light using 23101 guide. We followed the guide to a T, the issue we are have is that as you remote start the vehicle using 3X lock the vehicle starts properly, but if the lights are set on automatic, the headlights and LED lights flash continuously as well if you turn off the lights and remote started the Vehicle the LED fog lights flash continuously both will flash until you take over the vehicle. Has anybody come across this? We think it might be a faulty EVO one module any thoughts please help.

0

Can i get by evo bypass key reset resched my vehicles lemit

0

2012 Civic starts then stops three times

Hello, I have had a remote start on my 2012 Honda Civic for 5+ years. It has quit working. It is a EVO-ALL and CrimeStopper RS00-G5. From following the troubleshooting I think it has to do with the tach signal but not sure what to check. The car will start for about 3 seconds then shut off. It does this three times and then nothing. While it is running the starter is engaged the entire time.

0

solid orange and red light after 1st decryptor

Trying to get my remote start in my 12 Passat TDI working. When I get to the decryptor stage 2 it just has solid orange and red light on when you reinstall and turn on the key, it stops there, just those 2 lights.

its t harness VW_T6 so there isn't really much to hook up, all plug an play except i had to wire in the key reader.  car doesn't need the brake pressed, and i didn't wire in the hazzard wire as it was listed as optional.  seams like it read the key fine, and the app seemed to program the unit after. 

any ideas what i can try, i have all ready hit the flash/decryptor limit. the last thing i was trying was to use the firmware in the instructions instead of the recommended in the app. however i could not do the decryptor step as i hit the limit. 

0

Fortin Evo one flash

I cannot find the configuration button to chose Fortin 2 I think it was under H to set my remote start to be used by LinkR compatible for mobile app use any help on this topic

29/11/2024

Subaru G M (15380Pts.)

0

subaru crosstrek and take over

Hello. I installed evo-one (3x lock) on 2018 Subaru Crosstrek. When opening the door the engine stalls... What could be the reason?

0

2022 Nissan Armada restarts on its own after 5 seconds after turning off!

The car starts fine now with the remote start. But after turning the car off using the button on the dash, the car restarts on it's own after about 5 seconds. Then will turn off and stay off after pushing the dash button again. And now I also have a key fob error on my screen.

0

2015 jeep grand Cherokee PTS using evo all climate shuts off with remote start

Installed an evo all a while ago but customer noticed the climate is off when she starts with evo all 3x lock and start 2 When she uses factory remote start or manual start climate turns on no problem It’s turning the climate off the screen says climate off even though she turns it all on before she shuts Jeep off 2015 jeep grand Cherokee diesel PTS

0

VW Jetta 2015 - No Key even after Decrypt seems to have worked fine

I have installed a EVO ALL on a Jetta 2015 TDI (Push Start - Automatic).  I have the EVO ALL, THAR-VW1 and TB-VW installed as per instructions (I decided to skip the trunk release wiring as I didn't find the feature useful for me case).   The EVO All is programmed with Diesel Option enabled and it went through the Decryptor without any issues.  

When I press the 3 lock sequence,  the dash lights up (I had a previous problem that now brought me up to this point) but the dash says 'NO KEY'.   The car starts if I get the key in the car,  but not if the key is not in the car.   I was wondering what could be the problem.  The only item that I was wondering is that I reprogrammed (changed options) on the EVO ALL but didn't run the decript after,  would this cause this issue?   The car is store off site so I will drive in the morning and try this.   But what other issues could this be?

0

2012 A7 key not recognized.

I've read the other answers and unfortunately haven't found the fix. Setting up Evo one in 2012 a7 will not start without key inside car even though setup as no key required setting. When I set it up using a sacrificial key it works without issue so I assume the problem is with my IMMO link somehow. Has anyone figured out the fix? Im kind of stuck with this unit and don't really want to spend $400 on a new spare key. Does the wire to the black/purple have to be a certain gauge? Thanks to anyone with some pointers. Much appreciated.

0

Signs of a decryption issue (Bypass) on a VW Jetta 2015

I have installed a EVO ALL on a Jetta 2015 TDI (Push Start - Automatic). I have the EVO ALL, THAR-VW1 and TB-VW installed as per instructions (I decided to skip the trunk release wiring as I didn't find the feature useful for me case). The EVO All is programmed with Diesel Option enabled and it went through the Decryptor without any issues. But when I press the 3 lock sequence. It doesn't start or crank. I see the red light turns on, and then the yellow light turn on... and it repeats this procedure twice (as per the options programmed). The dash of the car doesnt come on (as expected) during the sequence. I will check the brake lights when I have time but I was wondering if there is possibly something wrong with the bypass. Thanks

0

Please reset evo-all

Please reset sn#001a07181908 reached limit for decryptor

0

evo one lte aux functions

Hi i have evo one lte installed in my 2014 Honda Accord pts, there's 4 functions aux1, aux2, aux5, aux6, showing up. May i know what those are functions are for, i tried one by one but nothing worked. Couldn't find anything about it in manuals.

0

Orange light blink 2 time

My starter was working very well with phone and by key. Now, only key works. The orange light of the FMH antenna blink 2 time. It's impossible to connect by phone to the car. I see in Manuel if amber light blink 2 time to disconnect and reconnect the antenna. When I do it, orange light blink 7 time. Then start again 2 time. Do you know what I have to do to reuse my phone to start the car ?

03/11/2024

GMC FABRICE (130Pts.)

0

GMC regular cab WT 2024

Bonjour, je viens d'acheter un GMC regular cab WT 2024 push strat, et souhaiterai mettre un demarrage à distance qui fonctionnerai avec la téléommande d'origine, merci de votre réponse. Fabrice

0

EVO One with THAR-GM1 V2 in 2016 Chevy Cruze Limited Manual Transmission

Hello all, I am getting ready to install an EVO One Module as a remote starter only, with a THAR-GM1 V.2 Harness in my 2016 Chevy Cruze Limited, with Flip Key and manual transmission. The wiring diagram only shows the Pink wire from the High Power (6 Wire) Harness being used. Does that mean I don't have to hookup the other 5 High Power Wires, or are they required for the unit to function? I haven't been able to find any wiring schematic for where the wires (aside from power and ground) hook up in my car. I guess I am unlcear on whether or not the GM Harness renders those other 5 wires unnecessary. Thank you in advance.

0

Flash link 4 sn# 002504061140 gets unknown module error.

I tried 2 computers uninstalled and reinstalled drivers and software. The flash link 4 worked fine prior to this. The led are lit properly shows connected at the bottom

0

is it possible to upgrade EVO Start from Otodata

I live in New Brunswick half the year and I am unable to use the EVO Start APP for my car when here, when I am in Quebec it's not an issue.

0

aucune module detecte

I Have an EVO ONE and I am trying to link my Flashlink Mobile, I get the pairing with bluetooth but when it tries to detect the module it cannot? This is my first attempt at using the flashlink mobile as I programmed the EVO ONE years ago with the Flashlink updater

-1

I can fix evo-all 2007 to IG Push start for toyota land cruiser prado 2022

Good day , I have Evo ALL (PATENTS PENDING US: 2007-0228827- A1) But without plugs. My question. I can fix this device to my car for Ignition start My car is toyota land cruiser prado 150 model 2022. Push start.. If I can fix which ( Fortin THAR-toyt#. T-Harness for Select 2022 Push-to-Start toyota Vehicles Thanks Basel

0

NEED TO RESET 002B04 328428

I need help to reset my DCRYPTOR'S . because it is DCRYPTOR'S LIMIT HAS BEEN REACHED with my car 002B04 328428 THANK YOU

0

rfk411 will not program

I have a 2011 silverado 2500hd standard key with a t harness and a evo all. i installed the rfk411 and i can not get the remotes to program. On the rf support do i need to be in h1 fortin or h2 fortin 2. I had these work on this truck before and i had to get a new igntion and i ahve not been abel to get them to reprogram since.

23/09/2024

Fiat G M (15380Pts.)

0

FIAT 500 A5 and A6

I set A5 and A6 to OFF...Wouldn't that be the culprit?

0

2015 Forester (push to start) , shut down immidiately after remote started.

2015 Forester (push to start) , shut down immidiately after remote started (after 1 or 2 second), what im missing here?

1

Is it necessary to connect the 3 wires at the BCM if I dont plan on using an RF Kit on a 2013 Infiniti G37?

Is it necessary to connect the 3 wires at the BCM (green 40 pin connector) if I dont plan on using, or have an RF Kit, on a 2013 Infiniti G37? Just wondering if these connections are for added features or they are necessary for the basic stand alone install.

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue