I have installed the Evo One with a RF641W on a 2011 Nissan Titan SV standard key only thing I cannot figure out is the parking lights i purchased the relay needed just do not know where to get my 12 volts from on the two terminals and would like for horn confirmation when truck is locked otherwise everything else works beautifully. Please help me with the parking lights and horn confirmation for locking the truck thank you for your time.

Damian.

I installed and programmed an EVO-NIST3 on a 2014 Nissan Rogue SL.

The remote start functionality works on the car, and it doesn't bring up any errors, but after installing the system, the car battery keeps going dead within hours.

A parasitic draw test reveled the EVO to be the culprit, adding 600-750mA of load on the battery even after the car has been sitting for 15-20 minutes, locked with all doors closed.

The problem seemed to be fixed after unplugging each harness connector from the BCM and replugging them, as the current was reduced to under 50mA total, and the battery survived nearly 8 hours without losing charge, but the next morning the battery was dead, and after charging, the battery had a parasitic load of nearly 800mA (again confirmed to be mostly from the EVO)

I installed and programmed an EVO-NIST3 on a 2014 Nissan Rogue SL.

The remote start functionality works on the car, and it doesn't bring up any errors, but after installing the system, the car battery keeps going dead within hours.

A parasitic draw test reveled the EVO to be the culprit, adding 600-750mA of load on the battery even after the car has been sitting for 15-20 minutes, locked with all doors closed.

The problem seemed to be fixed after unplugging each harness connector from the BCM and replugging them, as the current was reduced to under 50mA total, and the battery survived nearly 8 hours without losing charge, but the next morning the battery was dead, and after charging, the battery had a parasitic load of nearly 800mA (again confirmed to be mostly from the EVO)

Ive got a 09 nissan altima, when I disabled this option with the flash link. My box doesnt light up an the doors keptd locking an unlocking??? Help :D before changing this option my box would sync the remote/key with the lights just fine but car wouldnt start but everytime I tried to lock the car to start it, the boxs blue light wld flash.

Alright, so changed my lock,lock,lock setting an turned off the lock/unlock/lock thingy an still no start with remote an a blue light flashs on the box everytime you lock car?? also checked all other settings an they look fine. Not really sure where to go from here. I'm pretty sure I followed the wiring diagram pretty well. Taking apart the 40pin green plug took a min but got those three an the PTS wire an parking light wire. an using RL1 an the programing with the key works just fine.?.? hmm let me know thanks. service # 001a06754925

What are the options should I choose when installing an EVO ALL for 2016 Nissan Roque Push Start.? 

Service No: 001A06 546107

Thanks

nissan xtrail 2006 Immobilizer NATS  which evo i can use ?

What is the purpose of connection A2 "arm" and A3 "disarm"  in an empty spot  at this location "Driver kick panel or BCM Green connector Driver kick panel or above the gas pedal"?

This is stated in  Guide # 17743 and it also shows in the "wirecolor" installation pictures and wire connection.

Thank you