Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

31/10/2024

 Chevrolet Jeff Cates (290Pts.)

0

Where to start?

Ok, fighting this thing for months. I bought a new module, programmed it, installed it, get the same no start as I did with old unit. I took the new one and reset. Reprogram and tried again and still nothing. I can't even get it to allow me to program the remotes to test the start function. So pulled it out, put the old one in and it tried to start after I pulled the OBD wire. Plugged it in and it started and ran for a few minutes and I tested everything. Great it works again...next morning, doesn't work. Single light flash and nothing. I started it with the key, did a remote start transfer and it took over. I pulled the key out and it stayed running for about a minute, then stopped. I tried again, nothing. So after 8 hours, I tried to remote start and it did, ran for about 10 seconds and shutdown. What's going on? Do I have a wire gremlin on the vehicle side? I disconnected all the harnesses wires, plugged them all back in and still nothing. Is there an alternative wiring?
Login to reply View 1 answer(s)

12/12/2022

 Chevrolet Munito (1500Pts.)

0

2007 Chevy Silverado

Hi there. Derek I need you help. Vin Number: https://drive.google.com/file/d/12jf0GUEf2NYWnjO6kO761FTO_eqRumyY/view?usp=sharing S/N: https://drive.google.com/file/d/1CrUHW5cP2gR-a7bjHh2uQ8ecnvFx-mxD/view?usp=sharing Error: https://drive.google.com/file/d/12j-8NUcFIbYOHyYIBQNFwrSWbxaVwIOt/view?usp=sharing Now the problem is with the car not with the can bus. Could you reset the Dcryptor limit please? Thanks you so much.
Login to reply View 1 answer(s)

24/03/2022

 Chevrolet crispyrp69 (420Pts.)

0

Runs for 20 seconds then stalls

06 Impala standard key and regular install. Runs for about 20 then stalls out. Dosent seem to shut down, more of a stall out.Only starts once and then light flash 3 times
Login to reply View 2 answer(s)

24/03/2022

 Chevrolet crispyrp69 (420Pts.)

0

Runs for 20 seconds then stalls

06 Impala standard key and regular install. Runs for about 20 then stalls out. Dosent seem to shut down, more of a stall out.Only starts once and then light flash 3 times
Login to reply View 2 answer(s)

18/12/2021

 Chevrolet Randy Norris (130Pts.)

0

what all do i need for a 2006 chevy silverado 1500

what parts do i need to install a remote start in my 2006 chevy silverado 1500 standard key
Login to reply View 1 answer(s)

14/11/2021

 Chevrolet R & P Electronics (280Pts.)

0

2019 Chevy Trax Won't RStart after install

So we have installed a Evo All in this car, Using it as a stand alone RS, The Car will light up everything after 3X on factory remote, but then the dash goes dead, with a CEL light (radio playing) Turns off.... EVO ALL tries agian, and fails... 4 Red light flash on unit... Checked my cables... Everything hooked up correct - Hood Disabled in programing, (Parking lights NOT hooked up at the moment) Removed the flash, and tried to reflash a couple times, and ended up locking myself out (I need cleared please Fortin) Any advice here please help out... Thank you
Login to reply View 1 answer(s)

16/03/2021

 Chevrolet Raymond A2 (260Pts.)

0

evo one remote start doesnt crank after ignition on?

will not remote start out the blue one day. updated the firmware and still doesnt start. red light on module and rf light is constant 2016 silverado standard key
Login to reply View 1 answer(s)

23/12/2020

 Chevrolet brad boyd (130Pts.)

0

evo all 2015 chevy trax step 4 yellow only blinks 4 times then goes yellow and red solid

teck support says the brown wire is not making a good connection so i checked and everthing is making good contact and from the obd2 port terminal one (green wire i am curenly plugged rite into it to make sure that is not the issue. checked with meter and the connection is reading .5 of an ohm. so that is not an issue any more if it was. just seeing if anyone know where to go from here thanks
Login to reply View 2 answer(s)

23/12/2020

 Chevrolet brad boyd (130Pts.)

0

evo all 2015 chevy trax step 4 yellow only blinks 4 times then goes yellow and red solid

teck support says the brown wire is not making a good connection so i checked and everthing is making good contact and from the obd2 port terminal one (green wire i am curenly plugged rite into it to make sure that is not the issue. checked with meter and the connection is reading .5 of an ohm. so that is not an issue any more if it was. just seeing if anyone know where to go from here thanks
Login to reply View 2 answer(s)

02/10/2020

 Chevrolet james giegler (130Pts.)

0

2011 Silverado entered Theft Mode, help.

I connected the Evo All remote start to my 2011 Chevy Silverado Crew Bad. I was finally able to get it to fire up once by hitting lock three times on my manufacturer key fob. Then when I went to try again it didn't work, and so I tried the key and it went into theft mode. I have been trying to get it out of theft mode all morning. I killed my battery but am charging it now. I am wondering is there a detailed setting I overlooked? I am pretty sure I have a chipped key, should I have selected premium instead of standard key? Do I have to try to restart the whole process once I can fire my truck back up? SN 001A07 093223
Login to reply View 1 answer(s)

31/12/2019

 Chevrolet Anthony Martin Martin (130Pts.)

0

Do I need a separate remote starter module for 3x remote start on my 2005 silverado 2500?

Do I need a separate remote starter for 3x lock on my 05 silverado 2500 standard;key. not sure how to wire it with standalone application as my schematics show an additional remote start module.
Login to reply View 1 answer(s)

16/12/2019

 Chevrolet Juan Becerra (390Pts.)

0

2001 Chevy Silverado 3500

On the website it says remote start is only supported for years 2003 and older. Would remote start work on the 2001 using the EVO ONE and the 2003 guide and just hooking up the wires as found on here? 

http://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.aspx

I also researched about the OBD wire and it appears to be the same.

Login to reply View 1 answer(s)

16/12/2019

 Chevrolet Ed Andre (380Pts.)

0

2004 Corvette with EVO ONE, programs correctly but will not remote start

Hello everyone. Working with a 2004 Chrevrolet Corvette. Have an EVO-ONE with the recommended 70.18 firmware installed. The bypass programs correctly... However, when commanded to remote start with the RM942 fob, it attempts to start, but it wont crank. Parking lights come on, ignition and accessories turn on, everything's great.. just no crank. As a test, I left he key in the ingition and arttempt to remote start.. It starts fine! Is the EVO not bypassig correctly before it attempts to turn on the car ? If it helps... 002B07336612
Login to reply View 1 answer(s)

21/11/2019

 Chevrolet Brian Kells (220Pts.)

0

12v wire on evo all 2018 silverado

In the instructions for a stand alone install on a 2018 Silverado it shows to cut the 12v and ground wires and connect them to the vehicle source if no RF kit is used. Is this necessary? I intend to use a fortin 2 way rf kit in the near future. Also there are not clear instructions on hooking up the valet switch. Where does this go? Also can i setup the rf kit function when i first flash the module and then hook up the rf kit later or will that prevent the 3x lock function from working on the factory remote? Thanks
Login to reply View 1 answer(s)

08/11/2019

 Chevrolet Kid Ratits (470Pts.)

0

evo one programming can't get out of step 1-4 yellow led don't flash 2014 chevy silverado

evo one programming can't get out of step 1-4 yellow led don't flash 2014 chevy silverado i check all my wires and i think they are in the spot. how do i know if vehicle is in the right firmware why programming is complicated for all in one universal module.
Login to reply View 1 answer(s)

08/11/2019

 Chevrolet Роман Елецких (250Pts.)

0

Module EVO

Good afternoon, you can reset the module 002Е02 023760

Login to reply View 0 answer(s)

05/11/2019

 Chevrolet Kid Ratits (470Pts.)

0

evo one flash limit reached. is any posible to reset so i can use it to my truck and flash to dryptor

flash limit reached
Login to reply View 1 answer(s)

14/07/2017

 Chevrolet Dywane Russell (130Pts.)

0

2014 Chevy Cruze won't start with evo-gmt1

The car won't start using the evo-gmt1 with the T harness
Login to reply View 1 answer(s)

20/12/2015

 Chevrolet Clint Kiser (310Pts.)

1

If the Flash-Link Updater does not recognize my module, is the module defective?

I just bought a brand new EVO-ALL and Flash-Link Updater 2. I followed the instructions exactly on the Flash-Link Updater manual in order to get the latest updates for my device prior to install. The Flash-Link powers on and lights up red but the module never lights up and the Flash-Link light does not come on showing a link to the module. Any option I attempt to choose results in a message that the device was not found. Is this brand new module defective? Is there any other way to test it or reset it? Thanks!
Login to reply View 2 answer(s)

22/12/2015

 Chevrolet Chris Graux (190Pts.)

0

2007 Silverado won't start with key evo gmt4

2007 Silverado evo gmt4 stand alone with rf kit (fortin2) won't start with key or remote . Intermittent problem, I've tried differant remote starters (as1774 and 1272) differant gmt4 and differant evo all's same problem . Tried firmware 70.16 and 70.17 problem still there. Everything programs fine and seemed to work but later stops . Any suggestions would be great
Login to reply View 1 answer(s)

20/12/2015

 Chevrolet Clint Kiser (310Pts.)

1

If the Flash-Link Updater does not recognize my module, is the module defective?

I just bought a brand new EVO-ALL and Flash-Link Updater 2. I followed the instructions exactly on the Flash-Link Updater manual in order to get the latest updates for my device prior to install. The Flash-Link powers on and lights up red but the module never lights up and the Flash-Link light does not come on showing a link to the module. Any option I attempt to choose results in a message that the device was not found. Is this brand new module defective? Is there any other way to test it or reset it? Thanks!
Login to reply View 2 answer(s)

20/12/2015

 Chevrolet Clint Kiser (310Pts.)

1

If the Flash-Link Updater does not recognize my module, is the module defective?

I just bought a brand new EVO-ALL and Flash-Link Updater 2. I followed the instructions exactly on the Flash-Link Updater manual in order to get the latest updates for my device prior to install. The Flash-Link powers on and lights up red but the module never lights up and the Flash-Link light does not come on showing a link to the module. Any option I attempt to choose results in a message that the device was not found. Is this brand new module defective? Is there any other way to test it or reset it? Thanks!
Login to reply View 2 answer(s)

10/11/2015

 Chevrolet Scott St.Denis (430Pts.)

0

EVOALL GMT1 won't program on 2014 Malibu

Sevice#001A06440829 yellow light comes on, I pushed the program button, red light stays on solid, turn key on red light goes off and comes back on then I shut key off take out of ignition put the key in turn to on position red light flashes 4 times stays on solid nothing else happens. Programmed to decrypt the key, reset EVO ALL, tried all kinds of software from 4.18 all the way to newest. Nothing works. Tried to call waited on hold for 2 hours with customer waiting. What are my options now?
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue