Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

2012 Infiniti EX35 Heater Not Blowing Hot Air

I have Linkr LTX LT3 paired with Evo All NIST1, everything is connected correct vehicle starts with 3x lock or using App. My question is where in the flash settings do I got to enable heater to work. Because when starting the car all i get is air but heater not working until i press the brake pedal then you can feel hot air coming. Please advise thanks!

0

After following procedure for bypass on Evo-all correctly decryptor says empty key data?

Tried multiple times and every time after getting the rapidly flashing blue light and after the alternating red and yellow when I go to decrypt it says key data is empty?

0

My Remote Start Stopped Working in my G37 Sedan for the RF Controller and OEM controller

My Remote Start has been working just fine since 2017. Lost Remote Start on my oem controller and rf controller. Lock and unlock work fine. Do I need to do an update? Refresh?

0

EVO ALL Decryptor Reset

Hello would you mind resetting the decryptor limit on my EVO ALL 2020 Infiniti Q50 SN: 001A07465602

0

infiniti m35x evo all does not program

hello, I just installed an evo all in an infiniti m35x 2006, I have made all the corresponding connections but at the time of programming I find a problem, the instructions say that at the moment the blue light of the evo there is set flashing (last step) press the start button to turn off the vehicle and at that moment the blue light should turn off, but the problem is that it turns off but immediately the yellow and red light start to flash intermittently without stopping and so the evo remains all alone until I completely disconnect, what can I do, i checked the cam hight the cam low and the other connections and I notice all of them well.

0

Crimestopper TELE-connect not working

Hi there, I'm trying to install the Tele-connect to an evo-one using the T-harness on a 2006 Infiniti G35x with intelligent-Key. I'm using Guide # 33131 I've enabled the following so far but no luck.

32. mode 3

2. mode 3

8. mode 2

RF Kit Compatible has been set to "Fortin 2"

 

0

EX35 EVO-NIST1 and T-harness won't remote start without foot on brake

I have a 2008 Infiniti EX35 PTS with the EVO-NIST1 and T-harness installed for a standalone remote start system. I used the most current firmware, turned on D1 and C1 options, and the module was successfully programmed. The vehicle will not start with the 3x lock signal, it will only go to on and then acc modes. In troubleshooting, I pressed the brake pedal and then tried the 3x lock which started the car. Further, I tried switching the RL1 to RL2 connector, but this did not work. Next I put a voltmeter on the white/red wire on the brake connector harness, during the startup sequence the voltage seemed to be constant but only 11 volts and occationally dropped to 0 during the sequence. I re-installed the firmware and reprogrammed the EVO again to make sure there wasn't any issues, but it still work work. Do I have a bad EVO, harness, or something else?

0

2008 infiniti qx56 intelligent key wont remote start evo one with t harness

Will remote start when I unlock all doors before remote or when remote is in vehicle but won't remote start when all doors are locked

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue