Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

15/03/2020

 Mitsubishi Braden Fennell (180Pts.)

0

Ready mode wont enable

2015 Mitsubishi Lancer Evolution (manual trans). Using an EVO-ONE, I checked all wires and made sure everything was correct the only thing I didnt connect was the motion sensor, I cannot seem to find it in the driver side footwell unless the plug has been changed in later year models. Anyway when trying to remote start the parking lights flash three times, indicating ready mode is not enabled. I have tried all 3 different ways as described in the installation instructions but still does not work.
Login to reply View 1 answer(s)

07/05/2019

 Mitsubishi Tim Vanderwouden (180Pts.)

0

Remote start doesn’t do anything

I have a 2017 Mitsubishi Mirage Hatchback manual transmission with the standard key. I have an Evo-One installed according to the wiring diagram listed on this site. After a firmware update was performed on the bypass, I updated the firmware on the remote start portion of the unit. I then programmed it into the vehicle, went back to the computer and sent the information through to generate a key code. I reinstalled the unit in the car and when performing a remote start, nothing happens. The vehicle only reacts as if the car was not equipped with an additional device. I only hooked up the wires as shown in the install guide, nothing additional. Should I have hooked up others? Please help. Thanks.
Login to reply View 1 answer(s)

25/11/2015

 Mitsubishi Saul G. (130Pts.)

0

EVO-ONE Ready mode issue 2008 Mitsubishi Eclipse / AUX Output

I have an Evo-One installed on a 2008 Mitsubishi Eclipse, Manual Transmission. The car is equipped with the factory alarm. I have function 32.5 (Ground out - Arm/Rearm) enabled as the installation guide states. It is connected to the Lt. Green driver door pin wire. However, after I put the car in “ready mode” when the car shuts off after I close the driver door and the pulse gets sent to the door pin (to arm/rearm factory alarm) it disables my “ready mode” as well. When I figured that out, I disconnected the (-GWR) wire from the door pin wire and the remote start works perfectly. Only thing is now the factory alarm doesn't arm after shut down of the remote start. Is there anything I can do? Or should I just keep that wire disconnected since everything else works fine. Also, what wire do I use to connect an AUX output? I’d like to wire in my rear defrost to activate when I press Aux 1 on my remote.
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue