Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

Sequence

Bonjour, J'ai un démarreur model FTX 94 installé sur une Nissan Sentra 2021 manuelle avec bouton poussoir. Lorsque je descends temporairement du véhicule (par exemple pour la poste) si j'applique le frein à main, le moteur s'arrête automatiquement lorsque j'engage la première vitesse lorsque je veux repartir. Si je n'engage pas le frein à main, aucun problème. Quelle est la séquence que je dois faire pour pouvoir redémarrer sans que le moteur ne s'arrête lorsque je quitte temporairement le véhicule de façon sécuritaire (avec frein à main) ? Merci à l'avance et Bonne fin de journée

0

what's the best setup for a 2010 370z manual push button start

I'm looking for a remote start alarm with LTE functions for a 2010 370z

0

Will this work with a 2013 Nissa Versa with Manual Transmission?

Will this work with a 2013 Nissan Versa with a standard transmission? I noticed that most of your instruction sheets have a section for compatible vehicles that have a manual/standard transmission but I do not see that with this vehicle. Regular Key start.

0

2011 Juke push to start manual trans, procedure for "ready mode" please

0

Will not go into ready mode 2011 Juke push to start, manual trans

Vehicle will not go into ready mode, not sure where my settings were when it did, the vehicle would shut down when drivers door closed, after this I received instructions for the clutch bypass so i connected the yellow wire from the main harness to the brown at the clutch switch and it seems that since then can't get it to go into ready mode. Vehicle will not shut down when drivers door closed, detects fob left vehicle. It's likely a settings thing but not sure. s/n 002B04 227820

0

Micra 2015 manual transmission problem

I wired everything exactly like the diagram with the tharness. Programmed the evo-one correctly. After that i plugged the evo start 2 antenna in the evo-one (i dont have other transmitter remotes). Programmed it but nothing is working on the app i can't interact with the vehicule at all. Not sure what to do? Here's my questions: Do i need to do anything else for the evo-one to work on my manual transmission? Can you program the evo-start 2 without having other transmitters? (In the guide it shows that you need to press something on a transmitter)?

0

Versa 2009

Je trouve pas le guide pour nissan versa 2009 manuel avec le EvoOne bien sur merci

0

2018 qashqai manual transmission support reg key

On the website it lists the 18 Qashqai manual transmission as supported with the evo one, but in wire color it is noted that the vehicle is not supported. The 2019 also lists as "automatic only " So is the quashqai regular key with manual transmission actually supported? Thanks

0

2005 xterra manual transmission

Got a customer interested in a remote starter for his xterra maunal transmission. Was wondering if the EVO-ALL will work and does it come with instructions for the maunal transmission set up as well?

0

sentra nismo 2017 pushstart shutdown after 3 sec

Nissan sentra nismo pts 2017 programmed fine, manual sequence also works fine. Probem is when remote started car shutsdownn 3sec after cranking. Checked data with testone, brake tach and door trigger is fine...but i notice that handbrake light(on testone) shuts off a fraction of a second 3 sec after started. tried firmware 72.29 also tried 72.28. if i put the remote starter in automatic it always works fine ( but handbrake light also shuts off but starter does not mind in automatic if handbrake is on or off)so that is way i think its either handbrake or door input in data that is lost. any info on this? oh yes im using Thar niss1. I also have the 12v and gnd on the evo-one remote side connected( big harness 6pin plug)

0

sentra nismo 2017 pushstart shutdown after 3 sec

Nissan sentra nismo pts 2017 programmed fine, manual sequence also works fine. Probem is when remote started car shutsdownn 3sec after cranking. Checked data with testone, brake tach and door trigger is fine...but i notice that handbrake light(on testone) shuts off a fraction of a second 3 sec after started. tried firmware 72.29 also tried 72.28. if i put the remote starter in automatic it always works fine ( but handbrake light also shuts off but starter does not mind in automatic if handbrake is on or off)so that is way i think its either handbrake or door input in data that is lost. any info on this? oh yes im using Thar niss1. I also have the 12v and gnd on the evo-one remote side connected( big harness 6pin plug)

0

Will EVO-NIST1 support a manual transmission in a 2010 Nissan Altima?

I'm wondering if the EVO-NIST1 will support remote start on my 2010 Nissan Altima with PTS since I have a manual transmission. I heard an EVO-ALL with the harness would possibly work as well. I want to install it as a starter using the OEM intelligent key 3x lock button. Thanks in advanced

0

Will EVO-NIST1 support a manual transmission in a 2010 Nissan Altima?

I'm wondering if the EVO-NIST1 will support remote start on my 2010 Nissan Altima with PTS since I have a manual transmission. I heard an EVO-ALL with the harness would possibly work as well. I want to install it as a starter using the OEM intelligent key 3x lock button. Thanks in advanced

1

Remote Start for Manual Transmission. 2007 Nissan Altima

Is the 3x Remote Start compatible with a manual transmission 2007 Nissan Altima?

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue