Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

EVO One RFK441 2010 Hyundai Tuscon, regular key. Remotes only work every so often.

Everything programmed correctly as per the guide, no issues there. The remotes, even though they are one way, seem like they are acting as a 2 way remote. Both remotes programmed correctly on initial setup. Sometimes one of the remotes will work correctly to lock and unlock the doors, the LED on the remote giving one initial flash, then 5 quick flashes and the function works on the car. Other times, you push the lock or unlock, and all you get is a single flash, and no response from the car. It is very random, sometimes it's one remote, sometimes it's the other. Sometimes when I pick up one of the remotes, I see the LED give a single flash, but I haven't pushed a button. After a period of time, they both seem to start working properly to lock and unlock the car. Once that happens, you can remote start it once. Sometimes you can shut it down with the remote, sometimes you cannot. After that, neither one of the remotes will work at all. They go back to a single LED flash when the lock or unlock is pressed. Eventually one of them will start to work, then the other.........This has to be the strangest behavior I've seen from an RF remote.

0

Where to start?

Ok, fighting this thing for months. I bought a new module, programmed it, installed it, get the same no start as I did with old unit. I took the new one and reset. Reprogram and tried again and still nothing. I can't even get it to allow me to program the remotes to test the start function. So pulled it out, put the old one in and it tried to start after I pulled the OBD wire. Plugged it in and it started and ran for a few minutes and I tested everything. Great it works again...next morning, doesn't work. Single light flash and nothing. I started it with the key, did a remote start transfer and it took over. I pulled the key out and it stayed running for about a minute, then stopped. I tried again, nothing. So after 8 hours, I tried to remote start and it did, ran for about 10 seconds and shutdown. What's going on? Do I have a wire gremlin on the vehicle side? I disconnected all the harnesses wires, plugged them all back in and still nothing. Is there an alternative wiring?

03/12/2023

Kia Mike Wes (160Pts.)

0

Remote Programming RFK441 to Evo One

I installed Evo-One with THAR-ONE-KHY1 Harness on 2009 Kia Borrego. No immobilizer. Used FlashLink to update, configured the EVO One and all seemed to go well. I dont have any factory remotes so I bought the RFK441 remote kit and RF-A2A Harness. When I plug the anntannae wire into EVO one I get one LED flash on the anntanae end. Then nothing. Turn key on and anntanae LED does not light up, Hit brake pedal 4 times and no LED lights up on anntanae dongle. I have anntane wire plugged into the evo one (blue plug). Im not using the RF-A2A harness. Am I supposed to use the harness? None of the RFK441 remotes do anything when buttons pressed. It appears the unit wont go into programming mode to allow me to connect the remotes to the unit. Any ideas? Thanks,.

0

How to I flash Evo One with RFK441 and Evo Start LTE?

Just purchased an Evo Start LTE all in one kit. I'm installing in a 2008 Cadillac CTS, and ran into trouble when setting it up with FlashLink. Stepping through the steps for an initial flash, I come to "RF Kits" and it asks me to select a RF Kit or a smartphone app. I plan to use both the Start LTE and an RFK441 setup, but the software only allows one selection. What should I select and flash? The instructions for the start say to program the RF Kit first, disconnect, then do the Start LTE, but no mention of what to select in FlashLink. Thanks in advance for your help!

0

the range is very bad RFK441

Installing RFK441, but the range is very bad. The factory remote control for the car has a better range. I placed the antenna everywhere and even placed it outside the vehicle to no avail. Please, I need a solution and advice. Is there a way to solve the issue or a guaranteed replacement device? The range is all I need: 150 meters to 200 meters only.

Please see the video attached to the link

https://photos.app.goo.gl/5Wq9mcG8W9JfhPi48

0

Cannot lock/unlock doors from RFK441

Hi, I installed an Evo All with NIST1 to an Infiniti G35 2007 with PTS and an RFK441 kit. The car will remote start with the RFK441 remote, but I cannot get it to unlock or lock the doors. Any ideas what is going on or what I could check? I can see the lights on the Evo and RF Antenna light up when I press the lock and unlock buttons, and the Parker lights also light up as well. S/N of Evo: 001A07391493

0

Rfk441 and Evo one no pairing

I just installed an Evo one on my crv 07. Everything works fine. Can remote start the car with the oem remote pushing lock x3. now I'm trying to pair the rfk441 with no luck. I followed the guide start in on then off then on again press the pedal x4 but the led on the antena never flashed solid. do I need to activate any function with the flashlink before I can pair the remotes? If so? Which functions? thanks in advance

0

RFK441 not starting vehicle

Installed an EvoOne with THAR-TOY9 harness in a 2019 4Runner Standard Key. Added RFK441 remote kit. the EVOOne was flashed to the vehicle, turning off A11, and selecting RFK441. The RFK441 receiver blinks when you plug it into the EVO module. But does nothing after while clicking the remotes and trying to start the vehicle.

28/03/2021

FAQ Jim (850Pts.)

0

Programming EVO-ONE to use MyCar telematics and RFK441

Is it possible to have the MyCar and the RFK441 coexist? It seems the answer is no. I can have both the MyCar and the RFK441 programmed to the EVO-ONE. And inidivually they will work and operate the EVO-ONE. But if I plug in the RFK441 into the harness of the MyCar to have both of them attached to the EVO-ONE, only the RFK441 controls the EVO-ONE. If it is possible, what steps can be taken to make this happen. Or do I need a different remote kit for this to work? Thank you. Jim

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue