Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

Fortin EVO-ALL 2015 Nissan Rogue - Locking/Unlocking While Driving

Just installed an EVO All with the Nis3 Harness last night. While driving the car the unit unlocks and locks while flashing the turn signals every few seconds. I am curious as to what this could be. I've updated all firmware and enabled all unit options that were in the install manual. What could this be?

0

2022 Nissan Rogue remote start push start

I am installing a remote start to a 2022 Nissan Rogue, the installation guide says that 1 key will be sacrificed in the installation and the key in a box, I don't understand what that means, nor about sacrificing the key, nor about the key in the box, I need if someone could help me with that, thank you very much

0

2013 Rogue with standard key will not remote start

I bought this Rogue used with the the Evo-All and Pursuit Pro9776C remote starter installed. It worked perfectly for a week or so then stopped. Now when locked, remote starting will trigger the alarm. If it is unlocked with the remote, it starts the start sequence and all lights on the dash light up and the doors do an unlock sequence, but then nothing. I can leave key in the barrel and disconnect all but red connector on the Evo-All and it will go through the start sequence 3 times and it will start for a secord or so and shut down. I have successfully made sure that the tach sense is working properly. What other connections should I take a look at?

0

fuse size for 12v | Nissan rogue 2023

the wiring diagram shows a fuse on 12v green wire. the fuse is written in a lime green box on the diagram. does that mean a 20amp fuse is to be used? that sounds odd for low current wiring. can someone advice what size fuse is to be used

0

Nissan rogue 2021

Bonjour, j'ai installé dans un nissan rogue 2021 push un EvoOne avec l'application Cellulaire MS3G et mon client m'avise que le démarreur ne fonctionne presque jamais et que lorsqu'il fonctionne il à rarement une confirmation de retour. J'ai utilisé la sortie inition auxiliaire du EVOONE comme indiqué sur le plan Est-ce que j'aurais due allé me branché sur un inition directement dans la voiture?

0

2015 Nissan Rogue- EVO-NIST3 Won't program

Just installed today and when I plug in the unit all 3 lights continue to flash. What now? 2015 Key system

0

2014 Nissan Rogue EVO-ALL Parasitic Drain

I installed and programmed an EVO-NIST3 on a 2014 Nissan Rogue SL.

The remote start functionality works on the car, and it doesn't bring up any errors, but after installing the system, the car battery keeps going dead within hours.

A parasitic draw test reveled the EVO to be the culprit, adding 600-750mA of load on the battery even after the car has been sitting for 15-20 minutes, locked with all doors closed.

The problem seemed to be fixed after unplugging each harness connector from the BCM and replugging them, as the current was reduced to under 50mA total, and the battery survived nearly 8 hours without losing charge, but the next morning the battery was dead, and after charging, the battery had a parasitic load of nearly 800mA (again confirmed to be mostly from the EVO)

0

2014 Nissan Rogue EVO-ALL Parasitic Drain

I installed and programmed an EVO-NIST3 on a 2014 Nissan Rogue SL.

The remote start functionality works on the car, and it doesn't bring up any errors, but after installing the system, the car battery keeps going dead within hours.

A parasitic draw test reveled the EVO to be the culprit, adding 600-750mA of load on the battery even after the car has been sitting for 15-20 minutes, locked with all doors closed.

The problem seemed to be fixed after unplugging each harness connector from the BCM and replugging them, as the current was reduced to under 50mA total, and the battery survived nearly 8 hours without losing charge, but the next morning the battery was dead, and after charging, the battery had a parasitic load of nearly 800mA (again confirmed to be mostly from the EVO)

0

2009 nissan rogue, Do I need to hook up wire A8, if i don't have auto-lights.

1

2012 Nissan Rogue Standard key. EVO-1- NIS2

Can i use this standalone to remote start the vehicle? or do i need an external starter also, and if so what would you reccomend

0

I need your help. Nissan Rogue 2013 intelligent remote start Installation

Hello Fortin Support, I have a Nissan Rogue 2013 with Intellegent key. I have the following questions A. is it possible to do stand alone installation using evo all? B. I already programmed my evo all using flash link to do 3x start, and I fully programmed it in my vehicle but the car won`t start!!! .Would you please provide me with a link for evo all stand alone installation? C. I do not have any diaods. would it be okay to do my instalation without a diaod? D. Is it neccessay to install PARKING LIGHTS, and DRIVER DOOR PIN or it is optional? E. I`m lost I don`t know what diagram to use for stand alone installation. I`v been trying to install my remote starter for two weeks :(

0

Yellow light stays solid 2008 Nissan Rogue

I installed this Fortin one kit on my wifes Rogue as per the instructions and it is hung on the 4th step of the programing instructions. AS I dig into the troubleshooting manual it keeps going back to make sure tx and rx are hooked properly. Well everything has been installed per the instructions so what have I missed. Also the guide number that was sent with thi kit is a #79451 which does not show up doing any search for this vehicle. I already regret my purchase of a fortin remote start kit.

0

Nissan Rogue 2014 Push to start - Blue light does not flash when start pushed

Following the steps. Program button pressed when data plug in. Stop on blue. Blue stays solid. Plug in rest of plugs. Press start once (no brake pedal) and all Evo-all module lights turn off. Nothing else happens. This is where the blue LED should flash three times, but it does not. When I press stop again (after waiting a bit) blue light goes on solid. Testing remote start (press 3 times) nothing happens. Blue light stays on.No remote start occurs. On a side note, it did flood the Car with gas, as I heard the feul pump run and had to hold hte starter down for almost a minute to clear it. Bought as part of T-harness kit Evo-NIST3. Also, Do I need to install Hood switch and valet lock if I have an Evo-all and Fortin T-Harness?" Service # 001A06 859857 Firm v 4.18 Hardware ver 6 Date 10/2018

0

2011 Nissan Rogue Diode and Relay

Evo-One for 2011 Nissan Rogue Intelligent Key without T-Harness calls for "2x Diodes" and "1x Relay (Parking Lights (+))" but does not mention any specifics on the type of diodes and relay required. I am looking for the amperage and voltage for both pieces.

0

Evo-All on 2014 Nissan rogue causing check engine and 4WD error lights

It is a 2014 Nissan Rogue with the flip key. Installed using guide 75221 back in March of this year. Install was done by soldering. There was no issues during install, and no issues programming the module. I remote started the vehicle for 5 cycles before customer picked it up. No error lights. Customer called last week (8 months later) and said the check engine light came on, and the 4WD error light came on. They took it to the Nissan Dealership and they said the remote start is causing the issue because it was installed incorrectly. #1 I have done this exact install over a dozen times this past year and no one else has has an issue. #2 why would all of a sudden after 8 months it suddenly cause an issue? #3 is it possible there is a lag in the CAN Bus that is causing the error similar to some of the Chryslers where I need to change the firmware? #4 Why would this install be done 13 times on 14-18 Rogues and only this one have an issue?

0

Remote start works, but heat/air does not come on

2011 nissan rogue with intelli key standard installation (yes yellow loop is cut) remote start works fine, but the heat/air does not come on. when I turn the key on to takeover, the heat/air turns on. checked the configuration and wiring, all looks good.

0

Evo-All on 2014 Nissan rogue causing check engine and 4WD error lights

It is a 2014 Nissan Rogue with the flip key. Installed using guide 75221 back in March of this year. Install was done by soldering. There was no issues during install, and no issues programming the module. I remote started the vehicle for 5 cycles before customer picked it up. No error lights. Customer called last week (8 months later) and said the check engine light came on, and the 4WD error light came on. They took it to the Nissan Dealership and they said the remote start is causing the issue because it was installed incorrectly. #1 I have done this exact install over a dozen times this past year and no one else has has an issue. #2 why would all of a sudden after 8 months it suddenly cause an issue? #3 is it possible there is a lag in the CAN Bus that is causing the error similar to some of the Chryslers where I need to change the firmware? #4 Why would this install be done 13 times on 14-18 Rogues and only this one have an issue?

0

EVO ONE NISSAN ROGUE 2015 HAZARD LIGHTS FLASH

Is it normal for my hazard lights to flash once every couple seconds after the car has been started with the Evo one remote starter?

0

NIssan rogue 2012 intellikey - programmed fine but won't start

Hi ,

I'm using guide 34741 
everything is connected and programmed however when I try to do 3x lock the blue led flashes while I press lock button but nothing happens after.

 

doors are closed A8 is connected to the door pin , do I have to connect the hood pin ?

 


 

Anything else that I should check ?

 

Thank you,

Service Number : 002B07213904

0

2011 Nissan Rogue Parking lights don't turn on

I connected it to the red wire with silver dots on the harness going to the back of the vehicle as listed in wirecolor.. There were a number of red with silver dots, but only one that had 12v + when the parking lights were turned on. I even manually fed 12v+ to the wire and they would not turn on. Is there any other way to power up the parking lights? is there any possible connection at the parking light switch?

0

2008 Rogue Remote Start

Looking to add remote start with factory key on 2008 rogue with Intelligent key. I wanted to confirm what is required with the EVO - One and T Harness? Thank you.

0

Diode installation question

On the stand alone installation instructions it shows 3 diodes being used on 3 ignition wires. So all 3 diodes need to be combined together and then soldered to -Ignition wire from the evo all?

0

Looking for two car Starters Chevy and Nissan

I am looking for two systems with a cell phone start both vehicles have remotes i just want to make sure i order all the right parts 2014 Nissan Rogue select intellgent Key 2016 Chevy Silverado 1500 WT

0

Looking for two car Starters Chevy and Nissan

I am looking for two systems with a cell phone start both vehicles have remotes i just want to make sure i order all the right parts 2014 Nissan Rogue select intellgent Key 2016 Chevy Silverado 1500 WT

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer