Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

My FTX64-2W battery dies after 2 days.

Hello my ftx64-2w batteries dies on both remotes after about 2 days roughly after 2 remote starts and unlock, then nothing.This has been a while and have been through lots of batteries thinking they were faulty but that's not the case. Also on checking the batteries every time, one is always higher than the other and not evenly discharging. I have the EVO FORT1 installed and it's been working but the remotes are draining very quickly. Also I cannot get to remote start from the car remote with the three lock presses. It used to do it but haven't since I had the other remotes. But now I need it it's not responding. Some help please, thanks

1

Where can I buy a replacement case for the FTX64-2W?

Looking for replacement case for the FTX64-2W remote due to worn keypad

0

how to you replace the battery for ftx64-2w, it seems to be sealed for some reason ...?

how to you replace the battery for ftx64-2w, it seems to be sealed for some reason ...?

0

Remote stopped working FTX64-2W

Remote stopped working for no reason. one day it was fine, the next day i get a red light (one blink) after i press the start button. whats the problem and solution ? I have a Jetta 2021 remote was installed at the dealer when i bought the car. Model FTX64-2W FCC ID 2ACKU-R2W01FM IC: 12084A-R2W01FM

0

Civic 16' (Manual) w/FTX64 2W - Ready mode no longer saving my dashboard preferences

Hi, I Have a Honda Civic 2016 (Manual). I bought an aftermarket remote starter in 2019. The controller is an FTX64 2W. I used it without issues up until this winter. I would stop the car, leav it in neutral put the park brake on, and then press the ON button on the controller to start the Ready Mode. With the exception of the rear-window defroster which never worked, any preferences that I had on my dashboard would turn on when I activated the remote start later on (seat heaters, front window defroster, temperature, etc). This winter I noticed that when I get out of the car after activating my ready mode (after about 3-5s) the remote emits a red light and makes the descending noise (same on as if I remote stopped the car). When I then remote start the car, it will turn on, but none of the preferences on my dashboard will be on (cold seats, no defroster, no temperature, etc). The only thing that has changed is that one of the remotes (I have two) is dead. I will be replacing the batteries this week and trying that one out too. Anyone know what could be causing this? As I said, it worked well up until this winter and then stopped out of nowhere.

0

FTX-64-2W Can I configure the original car key to start the car, instead of the remote device?

I had the VW dealer install a FTX-64-2W in my 2021 Jetta a few months ago but i can only start the car with the remote device. is it possible to configure the original car key to start the car . Can this unit handle it? and if so, where do I do to have these addiitonal features configured?

0

Can the FTX-64-2W turn heated seats and defrost with the car start command?

I had the VW dealer install a FTX-64-2W in my 2021 Jetta a few months ago. the remote only turn the car on but I would like it to turn the heated seats and defrost at the same time the car starts. can this unit handle it? and if so, where do I do to have these addiitonal features configured?

0

Is it possible to install a FTX 64-2W to remote starting at Ioniq 2019 Electric ?

I don't care if it will not activate when the vehicule is charging.

0

ftx 64 remote will not unlock 2013 f150

Ive installed the evo all with the t-harness and the ftx 64 remote. I can remote start the truck with the fortin remote. The module locks the doors after the remore start. It monitors the door pin. It will shut the truck down with the fortin remote. I can un lock the doors with the fortin remote but the truck will not lock with the fortin lock button. It arms the factory alarm but does not move the locks.

0

FTC 64-2 with EVO-One in a Mistubishi Outlander - Won't perform

I have a FTC64-2 Module with an EVO One. The systems seems to operate correctly with the OEM remote (3x) It is unclear if I should use the T-Harness or plug the antenna directly into the blue port on the EVO One. If I go directly into the blue port I can't seemed to get it programmed, when I get in program mode, the antenna never goes to a rapid blink. If I go into the black data port, it seems to program per the instructions, but when I hit the unlock button, it won't unlock the doors, but the blue light on the Evo One will blink once. The remote seems to give confirmation with a green light, but the doors don't unlock, lock or get a remote start.

0

RF kit FTX 64-2way won't pair with evo one

I have a 2006 corolla, automatic, and with standard key. Installed evo one and programmed, the rf kit that i have is FTX 64-2way remote could not be paired, no lights at all as soon as I start programming nothing is going on. I enabled rf kit unit option and cut yellow loop.

0

RF Kit 64-2W added to EVOALL for 2012 Nissan Maxima, Locking /Unlocking not working via Fortin

I successfully installed the EVO-ALL in my 2012 Nissan Maxima. I also added the Fortin FTX 64-2W RF kit to the EVO-ALL. The factory key fob remote starts, lock/unlock. All functions work as they did before the EVO-ALL install. The 4 button remote from the RF kit does remote start the vehicle but doesn't lock/unlock the doors. I get a green confirmation on the remote that it sending/receiving the signal. While in the vehicle I can hear activity from the EVO-All. Thanks in advance!

0

FTX-64-2W Pairing

I have an EVO-One That I just installed on my 2007 Tundra. I am now adding the FTX-64-2W remotes, but there are no programming instructions with them. I do not wish to use the valet switch and the instruction guide 33201 for the remotes link on this website is broken. Ant help?

0

Ftx64-2w with eco-all lock unlock car Altima 2008 PTS

I Did add RF kit to my evo-All successfully i can start and shut the car remotely with no issues, but I need also to use the FTX64-2w remote to lock and unlock the car and also to release the trunk, please help on how to configure

1

RF Kit FTX64-2W won't pair with EVO One

I installed the evo one on a 2015 subaru legacy PTS and everything works as directed, including the oem remote 3x start. I'm trying to program the 2way RF kit and it won't even pair. Are there specific settings in the flashlink program to enable this kit to work?

1

RF Kit FTX64-2W won't pair with EVO One

I installed the evo one on a 2015 subaru legacy PTS and everything works as directed, including the oem remote 3x start. I'm trying to program the 2way RF kit and it won't even pair. Are there specific settings in the flashlink program to enable this kit to work?

0

2006 Toyota tacoma won't lock and unlock with RF KIT RF64-2W

RF KIT will remote start the truck but wont lock and unlock the doors,only works with the oem remote.

1

2008 Silverado WT not remote starting with EVO-GMT & RF Kit

I Installed a Fortin EVO-GMT in my 2008 Chevrolt Silverado WT. The lock/unlock function works, but attempting to start results in the dash lights and accessories turning on for several seconds, turning off momentarily, turning back on for several seconds, then the red light flashing 3 times before failing to start. (The starter does not crank). I know this unit is capable of starting the truck - I initially misprogrammed the RF (FTX-64-2W) as H1 rather than H2 - which caused the unlock to not work, and a strange combination of buttons on the remote would start the truck. After reprogramming it to H2, the symptoms above became aparent. *Kit is being used as stand-alone, truck does not have factory remote. Any help is appreciated.

1

2008 Silverado WT not remote starting with EVO-GMT & RF Kit

I Installed a Fortin EVO-GMT in my 2008 Chevrolt Silverado WT. The lock/unlock function works, but attempting to start results in the dash lights and accessories turning on for several seconds, turning off momentarily, turning back on for several seconds, then the red light flashing 3 times before failing to start. (The starter does not crank). I know this unit is capable of starting the truck - I initially misprogrammed the RF (FTX-64-2W) as H1 rather than H2 - which caused the unlock to not work, and a strange combination of buttons on the remote would start the truck. After reprogramming it to H2, the symptoms above became aparent. *Kit is being used as stand-alone, truck does not have factory remote. Any help is appreciated.

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer