EvoAll Regular installation without takeover. GUIDE # 83841
Programmed Flash-Link4 with latest firmware, and EvoAll updated to latest version as well.
As a first time installer, I've installed this to the best of my abilities. Here are the EXACT steps that i took;
1- (-)start/stop TO EvoAll A19
2- (-)lock TO EvoAll A20
3- (-)unlock TO EvoAll A10
4- EvoAll B4 TO (+)12V ***I didnt, but must I install a 7.5 Amp fuse???***
5- EvoAll B3 TO Ground
6- EvoAll A1 TO (+)Ignition ***I didn't but must I install a 1A Didode???***
7- (-) Steering Lock TO EvoAll D6
8- (~)Can High TO C3
9- (~)Can Low TO C4
After programming the EvoAll, 3xLock will turn on the ignition, then turn off, and make a second attempt to turn on, then off again with no engine crank at all.
AM I MISSING SOMETHING(S)???