Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

User

Darren hynes

Joined on the:

Nov. 20, 2009

Score

2950

Comment(s)

15

Voted question(s)

1

Voted answer(s)

5

Votes up

0

Votes down

6

Votes up received

5

Votes down received

0

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

1

Outlander GT Canada

I used the guide 28911 and blue light will shut off during the programming.. I doubled check all the wiring and they are all good. I used Crime stopper LC pro as my remote starter. Update (3:12pm) I tried to disconnect the red connector and can connector to see if thats the one that causing the problem. The only connector left is the data (4 pin) and the main harness which it use only 3 wires (yellow - ignition, dr blue-GWR and Orange black for grn). I tried to disconnect the dr blue and orange black just to see if that two wire is causing the problem and still the same. SO basically it's just the data and the ignition wire plug (yellow). Still the LED (Blue) shut off everytime I turn the car to ignition. Any advice? Note: I also tried to downgrade and updgrade the module if different firmware version and still same result.

0

Programming EVO-ONE for 2012 Toyota Rav4, Won't recognize key

I'm installing an EVO-ONE with the THAR-TOY1 T-Harness into a 2012 Toyota Rav4 and I believe I have followed the wiring diagram to set it up correctly. When I go to do the key bypass programming, I get to the step when I put my key in and turn the ignition to ON. Instead of the blue AND red light flashing, ONLY the red light flashes rapidly and doesn't stop. PLEASE HELP!

0

2014 grand caravan T harness

I installed a 2014 grand caravan with evo all T harness and compustar cm 800. after programming, I can lock and unlock. but I tried many times to learn tach but failed. I changed seting from tachless to tach in starter brain. connection I made are +12v parkling light and ground. ignition and +12v connected in harness according to the diagram. D2D mode. the light was correct when programming. I read cm800 install manual again. it says it support idata protocol. is that the means that cm800 doesn't support fortin 2 way d2d mode? it can tell evo all of door lock and unlock. but doesn't read foot brake and tach stauts?

17/10/2015

Toyota P T (50Pts.)

-3

Unlock keys only work for 48 hours?

That's pathetic. I shouldn't have to pay to be able to access instructions to install a product I purchased, I haven't even started the install and this activation key is expired.

-2

Locked account

Wish I never got this unit not worth the problems website act like your trying to steal something from them, I got my unit months ago but wasn't ready to install went to website to check it out put in code and now I'm screwed so guess unit gets trashed and my money goes to waste. Fortin won't ever get my business again.

2

evo-all locking up

Hi Working with a 2011 ford F250 super duty diesel, installed an evo-all and T-harness with a cm6000as. I used guide 32121. Seems like the evo locks up with i connect the data link cable from the compu. During the start sequence the ign on the brain powers up but does not turn on the evo yellow led. I am going to reflash and reporgram the evo again. can you check my service number to ensure that i have the evo currently configured correctly for my aplication: 001A06254869. I am using the diesel timer on the brain. My data link option is set to fortin. Any ideas on the reason for the malfunction?

1

is RF kit required? for stand alone instal?

For ford escape 2012? Or I can start/shut the car with its oem remote? Will it need TBGM2 too?

0

Fuel Injector's wire

Hi Fortin: I just received my EVO-ALL along with TBGM2. I am installing the device as a stand alone. I registered with wirecolor.com to get the wiring for my car which I did. My only question here is, the fuel injector wire, it says "Fuel Injector, Opposite Pink/Black" Opposite of what? is it on the BCM? or somewhere else? Car is: Chevy Impala 2007 LS 3.5L Please advice where is the connector for the fuel injector. Also, will EVO-ALL be required to connect to the fuel injector? Thank you very much, Yazen

1

TB-Subaru3 transponder bypass dealer tool?

Planning on doing a 2015 Subaru WRX STI soon. When you say "dealer tool required" is it the Subaru Dealer or a Fortin Dealer? Also, if it is the Fortin dealer, is this the same tool as the firmware tool or a different one and do you sell it? I saw that I can wrap the wire over the key but I want a cleaner install. Thanks.

2

Is there a page/note outlining that older firmware is required for succesful connection?

I've noticed many older vehicles actually require older versions flashed on the EVO.

1

How to use the key dcryptor?

Hi,

I have a 2014 Subaru WRX STi hatchback and am installing the EVO-ALL along with the Advanced Keys keyless entry and push start button system. I'm still in the planning stages to do the actual install and have been unable to find the documentation for the process of learning the key code that is mentioned on this page. I have the TB-SUBARU2 transponder bypass as well.

I couldn't see in the documentation or in the flash link manager on how to do this.

Is Fortin able to outline the steps needed to perform this.

Thanks,

Greg

0

cadenza 2014 PTS what do i need for remote start

i want to remote start my car so is evo all is enough or i have to buy stand alone remote start? will it enable me to use the oem remote? do i need to cut and split wires?

1

Where can i find the diagrams for adding xl202 or smart start to evo modules

recently I saw that you can add aftermarket remotes or smart start/drone to a standalone evo module. Just wondering how to add both if possible?

0

how can i hook up reverse polarity trunk release

how can i hook up reverse polarity trunk release

2

Where do I get a parking light relay to add to the evo-chrt5 in a 2014 Wrangler?

The Wrangler starts and stops using the evo-chrt5, but I want the parking lights to come on while it's running

2

2014 Ford Explorer Sport PTS

I have purchased a cm6000 and evo-all. I noticed the guide only goes up to 2013. I entered the vehicle info in the flash link updater and updated the evo firmware. Wondering if the latest recommended firmware will support this vehicle. Build date 01/14. Or should I wait for a definite install guide to be released. Thanks

1

EVO ALL standalone starter on a PTS, which wire can be grounded on unlock to prevent shut down when door is opened?

I did this on a 2007 Infinity G35 in the past and got an answer from your phone tech support and it worked. I just forgot which wire it was on the EVO ALL and if it is compatible or can be applied to other vehicles with PTS and RFID... lets say a 2007 and a 2013 Lexus ES350 Thanks

1

what RF kits do you recommend using with the evo all?

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue