Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

25/12/2023

 Dodge Mark Day (130Pts.)

0

MODULE LED'S DON'T DO ANYTHING WHEN PLUGGED INTO VEHICLE

USED FLASHLINK, MODULE HAS CORRECT FIRMWARE, PLUGGED INTO VEHICLE CORRECTLY, HELD DOWN BUTTON AND ATTATCHED 4 PIN CONNECTOR TO MODULE, NOTHING HAPPENS. NO LED'S LIGHT UP AT ALL. evo-all standalone
Login to reply View 1 answer(s)

10/08/2019

 Volkswagen John Perry (130Pts.)

0

Cluster stopped working after install [EVO-ALL Standalone/Volkswagen Tiguan 2015]

I got everything installed and had it all working. Once I knew it was working, I disconnected the module so that I could clean up the wiring. When I got everything reconnected, I realized that the cluster had lost all power. Now I can't turn the car on using the key let along the FOB. I cannot figure out how this could happen so any tips or advice would be greatly appreciated.
Login to reply View 1 answer(s)

05/10/2018

 Toyota Greg Crowser (130Pts.)

0

No LED's when plugging in Data-Link wire

I'm using a Crimestopper RS7 with an EVO-ALL. Installation was working for a few weeks, then stopped. Now, when inserting the Data-Link connector while holding the button, no LED's light. When disconnected, the Crimestopper is putting out 12.0 Volts on the red wire, and 3.6 Volts on both the white and blue. After connecting to the EVO-ALL, the 12.0 Volts drops to 0.8. So I hooked up this EVO-ALL in a different vehicle with the same setup (Crimestopper RS7), The same voltage drop occured, with no LED's. In this different vechicle, I then replaced its original EVO-ALl, and everything worked again. So I assumed I had a bad EVO-ALL. Fast forward to today . . . I have a different EVO-ALL that I plugged in. But the same problem with no LED's. Any suggestions?
Login to reply View 1 answer(s)

27/12/2017

 Volkswagen Marquie Board (580Pts.)

1

VW Tiguan with T Harness gets no power when data link plugged in

Installing EVO all on 2014 Tiguan per guide #65501. When I go to plug in data link connector I get no power in order to try and program module. There are only 2 wires to connect, besides the harness connector itself, for the brake and ignition so Im not sure how to get power for the module? Any ideas.
Login to reply View 1 answer(s)

22/01/2017

 Chevrolet JR Grennell (130Pts.)

0

Why is there no power to evo with key off in a 2015 Silverado??

Kit says gmt1 under the gmt3 sticker. Do I have wrong kit? Cannot get any lights on unit unless key is in run position.
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue