Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

27/02/2024

 Subaru Joshua Swenson (1660Pts.)

0

2020 Subaru Forester install questions

1. In this thread from a while ago, it was said that enabling 3x lock is not recommended for a 2019. Does this still apply? https://fortin.ca/en/qa/90775/LockLockLock-Forester-Sport-2019/ EDIT: May have been fixed in firmware 1.24 AKA 0.60? 2. Guide 98941, page 7. I'm probably over analyzing this, but I assume for the Yellow/Red and Yellow/Green wires, the illustration is saying to connect the respective wires together. Is that correct? I figured there would be a black circle on it if that was a case. I initially thought this was a spliced wire from the factory. 3. Will there be issues if I use an Omega RF kit and have to use firmware 0.44? Thanks all!
Login to reply View 1 answer(s)

24/04/2020

 Subaru Brandon Chew (210Pts.)

0

T-Harnes for 2014 Subaru Push to Start

Is there any T Harness that suits 2014 Subaru push to start? Every other make and model seems to be using them and it's a much easier install.
Login to reply View 1 answer(s)

20/10/2019

 Subaru serge robillard (130Pts.)

0

LockLockLock Forester Sport 2019

When an update will be availbale to have the LockLockLock option for
Forester Sport 2019 (Push to Start)

My system is installed since close a year and still waiting for this function.

Thanks

Login to reply View 1 answer(s)

22/10/2018

 Subaru Mark Serfass (130Pts.)

0

2012 Subaru Forester Manual Trans. Evo-One OEM key fob

2012 Subaru Forester Manual Trans. Evo-One OEM key fob.
setup according to #54711 guide, except hood pin is not used.
Flashed to 79.49 & 1.24 ran the decrypter, then set the standard settings in both tabs. 83.2 C1 & D5 enabled
When I press the lock 3x times the horn beeps, the parking lights flash 3 times the radio & Dash lights flash. but it does not start. In reading the help guide, it says the EVO-One red light should turn on, it does not.
Any help would be much appreciated. 

Login to reply View 1 answer(s)

27/09/2018

 Subaru Gaetan Roussel (260Pts.)

0

Which Start wire to use on Forester 2009 ?

I recently acquired a 2009 Forester. Using a Fortin Evo-All and a Crime Stopper RS2-G3 remote starter I cannot figure out which Start wire to use. 1) Your installation guide suggest the use of Start wires Ter 1 (White/Black) and 2 (White/Red) while the RS2-G3 connector only has one Start wire (Brown). How should I make the proper connection(s) ? 2) As well, the remote starter has two (2) Constant 12V (+) Input Red wires on its 6 pin power harness. Should both of them be connected to the RS2 (+) 12V white wire of the Forester Ignition harness ? PS. I see that on the Evo One installation you use a relay on the Start Ter 2 wire.
Login to reply View 1 answer(s)

27/09/2018

 Subaru Gaetan Roussel (260Pts.)

0

Which Start wire to use on Forester 2009 ?

I recently acquired a 2009 Forester. Using a Fortin Evo-All and a Crime Stopper RS2-G3 remote starter I cannot figure out which Start wire to use. 1) Your installation guide suggest the use of Start wires Ter 1 (White/Black) and 2 (White/Red) while the RS2-G3 connector only has one Start wire (Brown). How should I make the proper connection(s) ? 2) As well, the remote starter has two (2) Constant 12V (+) Input Red wires on its 6 pin power harness. Should both of them be connected to the RS2 (+) 12V white wire of the Forester Ignition harness ? PS. I see that on the Evo One installation you use a relay on the Start Ter 2 wire.
Login to reply View 1 answer(s)

05/02/2016

 Subaru Steven Coffey (180Pts.)

0

2014 Subaru Forester EVO One Dcryptor programming problem Step 5

I wired up the EVO One with the T-harness, updated the firmware, enabled C1 and 3X remote start. When I attempt to program it, I can get the Red/Blue, lights flashing 5x times per second, but as soon as I turn the key to start the lights go straight to red/blue. If I press the lock button 3 times the car will start, but then shut off immediately.
Login to reply View 3 answer(s)

05/02/2016

 Subaru Steven Coffey (180Pts.)

0

2014 Subaru Forester EVO One Dcryptor programming problem Step 5

I wired up the EVO One with the T-harness, updated the firmware, enabled C1 and 3X remote start. When I attempt to program it, I can get the Red/Blue, lights flashing 5x times per second, but as soon as I turn the key to start the lights go straight to red/blue. If I press the lock button 3 times the car will start, but then shut off immediately.
Login to reply View 3 answer(s)

05/02/2016

 Subaru Steven Coffey (180Pts.)

0

2014 Subaru Forester EVO One Dcryptor programming problem Step 5

I wired up the EVO One with the T-harness, updated the firmware, enabled C1 and 3X remote start. When I attempt to program it, I can get the Red/Blue, lights flashing 5x times per second, but as soon as I turn the key to start the lights go straight to red/blue. If I press the lock button 3 times the car will start, but then shut off immediately.
Login to reply View 3 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue