Hello,
I am having some problems with a StandAlone Installation on a 2014 Ford Explorer with standard key. I am using the THAR-FOR4 kit with a RF-642W remote kit.
Installation was simple, found the 2 wires I needed for lock/unlock and decided not to hook up the parking lights. This vehicle doesnt have a OEM factory alarm, I tested by locking doors with factory remote and opening the car door from the inside via a rolled down window, no alarm sounded.
I can not get this kit to start my vehicle or do anything along those lines. Here are the problems I am having and how it is acting:
*Programming of remotes went fine
*Programming of module seemed to go find (after programming I started vehicle with factory key and it would not shut off until I unplugged the module power)
*When trying to remote start with keyfob the red light on module turns on, then the yellow turns on and nothing happens.
*No lights on module turn on when trying to start with keyfob and the parking break is pushed in
*Module does not respond to lock-lock-lock with factory fob, no lights at all
*Vehicle will unlock with the lock button is pressed on keyfob
*Nothing happen with unlock button is pressed on keyfob
*Blue light on RF antenna constantly blinks while driving now.
I tried to install this kit on 10/24/19 and gave up when I started having these problems, very simple install. I tried the current firmware and I also tried 1 version back with no success. Any idea what could be going on?
Thanks
Jake
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
