Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

2012 Dodge Caravan blue led doesn't flash

2012 Dodge Grand Caravan Stand alone install with CHR4. yellow wire connected but module still doesnt see ignition (no blue led flash) Hardware 7.0 Firmware 59.02 S/N 001A07 219238

1

2018 Caravan bypass option A4 compatibility.

Is the 2018 caravan compatible with the A4 option to automatically engage the rear defrost upon remote start? The Flashlink user guide says " Will only work on vehicles that support heated seats and Rear defrost control trough the vehicles CAN-Bus." The install instructions for this vehicle dont specify any wiring for CAN Bus. ( as the 2017 ram 1500 does )

0

Which unit works for the 2016 dodge grand caravan (tipkey)

I just want to make sure i think its the chrt4

0

2011 Grand Caravan, RFK912 will not activate remote start on EVO-ALL

I installed an EVO-ALL on a 2011 Dodge Grand Caravan. Standalone with T-harness. Remote start works correctly when pressing the lock button 3 times on OEM remote. Added a RFK912 antenna kit, and it will not activate remote start. The antenna recognizes the key press on the remote, but the van will not start. Only thing it does is unlock the doors twice, ignition never even turns on. Both modules have the newest firmware available.

0

the leds do not flash they stay lit???2016 dodge grand carvan

0

Starter wire on evo all 20 pin to 2003 dodge grand caravan.

On 2003 dodge grand caravan evo all connection diagram there are three connections fron ignition connector to remote starter not to evo all. Are they necessary because i am using a compustar revo witch has only 4 pin data link connection. So where do I connect the starter wire from my car to evo all 20 pin. Thanks

24/10/2019

Dodge M S2 (130Pts.)

0

Vehicle won't stay running after the Evo-All start the van, it runs for about 2 seconds. 2011 Dodge Grand caravan

Vehichle won't stay running. I have updated it and used C1 and D1 enabled. If I bypass the key it will stay running but that would be a annoying having to lock the van two times to turn the engine off. I have the hood part installed and the yellow wire hooked up too. The OEM key does everything else I just wanted the remote start.

0

Dodge Grand Caravan 2015

The remote start works good, 2 times on 3 the engine stop when i insert the key.

0

Will the EVO CHRT5 work on a 2014 Dodge Grand Caravan?

I bought a EVO-CHRT5 from amazon (package is not here yet.) but just realized that it may not be the correct one for my 2014 DODGE GRAND CARAVAN when I was searching around on this site.

0

Crimestopper with Evo All - not working on 2007 Caravan

I am trying to setup my crimestopper RS4-G5 to have a second start wire to control my relay and mux resistor. I can not get my crimestopper to go into program mode. I turn the key on and hit the program button 5 times with no success. Any ideas?

1

Can I use EVO-ONE with 2003 Dodge Caravan?

Being the EVO-ALL can not be used as a Stand-Alone unit it requires an additional remote start system to start the vehicle. Can I use the EVO-ONE to accomplish the immobilizer and start feature on a 2003 Dodge Caravan?

1

2012 Dodge Caravan will not start with correct programing

I have installed a EVO-CHRT4 on my 2012 Dodge Grand Caravan. I did not connect the lights or the hood switch. Yellow wire have been joind together from the harness to the 20 pin. All steps of the program went good. When I hit the lock remote 3x nothing happens. Thanks in advance

0

2016 Dodge Grand Caravan Headlight Switch Issues.

I installed the EVO-CHRT4 unit in my 2016 Grand Caravan with no issues, but now my Headlights are always on when the car is running. The Headlight Switch does not work and does not even light up as it should at night. My install was just the T harness with no additional modifications. Never even touched the Headlight Switch. Any idea what's going on? All help is greatly appreciated.

0

evo-all not programming on 08 Dodge Grand Caravan

I have a 2008 Dodge Gand Caravan SE and I am following the guide #5131 Most of the wires are connected to from the remote starter to the evo-all. (Without Data Link) wires that are not connected to the evo-all are: Pink/black-hood status (not connected, remote starter hood status wire and switch connected directly to vehicle hood, vehicle does not have a factory hood switch) orange/black- sliding door right (not equipped on vehicle) orange- sliding door left ( not equipped) white- trunk status ( not available on remote starter) Everything else is connected! I got the wiring colors from wirecolor.com, and the Can High wire has different colors compared to the guide? I followed the fortin guide NOT the wirecolor.com. starter wire red/blue (evo-all) connected to purple (starter output-starter side) thicker guage wire from my remote starter wire. ignition-yellow wire (evo-all), Comm2-yellow/red (evo-all) connected to remote starter ignition 1 wire (thick guage wire) connected to cut wire red/white vehicle side immobilizer connecter. grey/black-Can 2 Low (evo-all) connect to white/light blue vehicle immobilizer wiring harness grey-Can 2 High (evo-all) connected to white/grey vehicle immobilizer wiring harness Yellow/blue-NO2 (evo-all) connected to light blue/ red of the vehicle immobilizer harness yellow/green NC2 (evo-all) connected to cut wire connector side of vehicle immobilizer harness I followed the programming procedures in the guide, the blue led does not flash after step 3 ( IGN ON RUN) the blue led just turns off . when I proceed with step 4 (IGN OFF) blue led turns turns back on like in step 1. i have tried to remote start, the remote starter works and hear its internal relays, with confirmaton on remote key fob. Vehicle does not start? I do not know if the Evo-All is programmed or not? Evo-All hardware Vr. 6 firmware Vr. 4.18 how many tries do I get to program the evo-all for the immobilizer on the vehicle? do I need to buy the flash link updater, ot reflash the evo-all? please help!

1

EVO-CHRT4 Questions

Installing 2 units on a 2012 & 2016 Dodge Grand caravan, i am using guide #12971 1) do I need the relay when connecting the siren, can I just tie the siren +12v to the battery and use A4 - output to activate the siren, the way the horn does/ 2) for an armed led i can use A5 ? 3) does the valet switch prevent the alarm from arming, or only prevent remote starting? 4) I want to use the EVO all as a starter and alarm so any programming steps I need to do would be helpful i hope to get the 2 units next week but I am trying to get everything I need for programming, any guides would be appreciated.

0

2011 Grand Caravan won't stay started.

I cut the yellow wire on the T-harness and splced the yellow-green wire to it. Unit appears to program prperly. When I try and start it runs for 2 to 3 seconds and then shuts down. It does then try and re-start. Also to clarify, does 2010 or less mean 2010 and newer models? The verbage is very confusing. Any ideas?

0

Blue light not flashing on Evo-chrt4 setup in 2012 dodge grand caravan

Blue light goes out but does not flash when turning on ignition. Yellow wire connected together. Directions from other troubleshooting say the bus wires are are reversed. Do I modify the t-harness to fix this problem? I have the programmer and ref lashed the unit.

0

2015 grand caravan i get to step 6 blue light goes out but remote wont activate start when pressed 3x

I have the evo chrt4 tee harness i conected the yellow wires and installed I get 20 step 6 blue light flahsing ihit the lock button and blue light goes out but key wont activate start aaaaaaIs there more power conections or other conections i should have done and missed

0

My grand caravan 2015 sensor Gate on and all the lights on after the installation of evo-all

After the installation of the Evo-All CHRT4, my Dodge Caravan 2015 have the GATE indicator on on the dashboard and all the internal lights on too. What can I do?

0

2014 caravan, firmware 74.24

Just a heads up,I was using a Evo-chrt4 with a compustar 7000 on a 2014 caravan with firmware 74.24 and something from the evo-all was latching the ignition output on the compustar: Yellow wire from t-harness functions properly as ignition. with only the evo and harness plugged in ignition funtions normally. with only the compustar and harness plugged in everything functions normally with the evo plugged in and only the main harness (not the 4 pin data cable) on the compustar plugged in everything functions normally, plug in the 4 pin data cable and as soon as ignition is turned on it latches and theres a single click coming from the compustar at regular intervals and would require disconnecting starter brain to stop it, tried a 7200 brain with the same results. roll evo frimware back to 74.22 and everything functions perfectly

0

seems to have programmed, won't remote start

Hi, I was installing my CHRT-4 today and followed the instructions to the letter as well as a video on youtube (which matched the directions) once installed and programming, I got the rapid flashing blue LEDs as if all was programmed. I then tried to remote start the van but it doesn't do anything. I tried repeating the process with the same result... suggestions?

0

why will my Dodge Caravan not start?

I recently purchased EVO-CHRT4 for my 2011 Grand Caravan. Unit programmed but will not do anything except beep horn when i hit lock x3. Blue light flashes on unit. What could be the issue?

1

I purchased an EVO-CHRT4 for my 2010 Dodge Grand Caravan will I need a bypass for the Sentry Key Imobilizer?

Before tearing into my Dash I've been cautiously reading about the connectors and bypasses and everything and not sure I have evertying I need. I've got the harness fixed with the proper wires cut and spliced. (yellow from the 20-pin to the yellow coming out of the harness and yello/green from the red connector to yellow between the T) so I think I'm ready. But now I'm reading about the Sentry Key Imobilizer that will shut off the engine if the key isn't detected and see in the owner's manual that it states "The Sentry Key Immobilizer system is not compatible with some after-market remote starting systems. Use of these systems may result in vehicle starting problems and loss of security protection." Will this product bypass that Sentry Key Immobilizer system and allow the remote start to work?

0

INT-SL+ and protection mode on DODGE Caravan 2007

Hi, I have a question about programming INT-SL+ on DODGE Caravan 2007. Every connection made as per instruction, remote starter Crimestopper RS2-G3. As I started programming, the LED became solid, after turning ignition ON it started to flash very quickly and didn

0

2013 Dodge Grand Caravan - Factory Horn Trigger

Is the factory horn trigger from the horn switch data on this vehicle now? Wirecolor.com only shows positive (+) to trigger the factory horn right off the horn(s) or TIPM. Could you please verify that there is really no negative (-) horn trigger from the steering column on this vehicle at all? My next question then is... could the EVO-ALL (Alarm Enabled) horn output (green wire) be set to constant instead of pulse to be able to hook up an aftermarket siren? I Didn't see any options on the flashlink program.

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer