English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

11/06/2023

 Toyota G M (15380Pts.)

0

2015 Yaris

On 2015 Toyota Yaris (Hybrid) can I put evo-one (standalone)?
Connectez-vous pour répondre Voir 1 réponse(s)

05/12/2022

 Toyota Munito (1500Pts.)

1

2015 HIGHLANDER CHECK SMART KEY SYSTEM LIGHT

Hello community. Dereck here I am again needing your help, the installation was perfect, the programming was perfect but I'm getting the warning for check smart key system. I've changed battery's in the keys. It is Push to start. I am trying to install an evo all. Thank you very much in advance.
Connectez-vous pour répondre Voir 1 réponse(s)

21/08/2021

 Toyota JEREMY ABBOTT (230Pts.)

0

2015 Toyota Tacoma EVO-One, parking lights always on when running, and stay on after time out.

I have the EVO-One wired in with RFK942 RF Kit and everything functions, but I have three issues. First the parking lights are always on when running. Is there a way to fix that? Second, when the remote start times out the parking lights did stay on until the drivers door was opened, so I wired the blue wire to the door pin switch wire Green w/ yellow, and programmed Option 32 mode 3. Now the door open dash light is on all the time, acting like a dead short insted of pulsing. Did I program this wrong? I was following the advice of two other posts I found. Three, the lights never flash when I lock or unluck the doors. Any idea why? Please advise, thanks.
Connectez-vous pour répondre Voir 1 réponse(s)

12/07/2021

 Toyota Francis D\'Anna (190Pts.)

0

2015 Toyota Yaris Hybrid (EURO) H-key

Hello, I'm trying to install the Evo One on a non supported vehicle. I assume all risk here. I'm using the default configuration for the North America Yaris with the only change being Hybrid Mode D4 enabled. Programming is successful (flashing blue with key turn). When I try to start the vehicle with three pushes of the OEM lock, I get as far as accessory, but not the final ready light, so the final step "start" isn't happening. If I put the key in and turn all the way myself, everything comes on as expected. I'm using: EVO-One w/harness. I did not cut the TPMS wire yet (waiting to see if this works). The only difference I see so far is that the ignition connector on this model is black, not green like the instructions. No errors are reporting and system shuts down as expected with a single flash of parking lights. Are there other settings (besides D4) that need to be changed to accommodate for this being a hybrid? Any suggestions would be appreciated. SN: 002B04 175604
Connectez-vous pour répondre Voir 1 réponse(s)

23/03/2021

 Toyota Francis D\'Anna (190Pts.)

0

Fortin Evo-One on EURO Yaris Hybrid

Does anyone know if this Evo-One will work on the European MY2015 Yaris Hybrid (key, not push button)? I can't find a solution in Europe for remote start, it's practicially inexistent. My key doesn't have an H or a G, it has some writing which I can't read.
Connectez-vous pour répondre Voir 1 réponse(s)

24/01/2021

 Toyota Chris Reeve (130Pts.)

0

EVO-ONE-TOY9, Remote open sliding doors when vehicle is running

I recently installed the EVO-ONE-TOY9 in my 2015 Toyota Sienna and it is working great! I have just one question: is it possible to enable the use of the open sliding door buttons on my factory keyfob when the vehicle is running?
Connectez-vous pour répondre Voir 1 réponse(s)

11/12/2020

 Toyota MICHAEL DONINI (370Pts.)

0

2015 Toyota Corolla H-Key Without Smart Key Remote Start will start but won't keep it on.

Hi I have an Evo All updated to the lastest firmware as of today (12/11/2020) 79.65 I believe, with all preset options, meaning i did not turn on or off any feature on the Evo All through the FlashLink Manager. To pair with the Evo All I have an Encore E1. My vehicle is a 2015 Toyota Corolla L H-KEY without smart key (no lock or unluck button on it) Evo All Installation Guide with Remote Start Unit https://cdn02.fortin.ca/download/31711/evo-all_ig_reg_bi_toy-corolla_2014-2016_hkey_h_31711.pdf Encore E1 Installation Manual. https://encoreautomotivesystems.com/content/pdf/one_sheet_E1_install_manual.pdf So I have all the Evo All cables connected to the car which are A20 to 30-pin connector position 16; A18 to E3 White 40-pin connector position 34; A10, C3, and C4 to OBD-II connector in its respective positions 7, 6, 14; Also I have the Encore E1 connecting to the Evo All which are 10 Pin Encore E1 connector -> 20 Pin Evo All connector White/Red Tachometer -> A12 White/Black Hood Pin -> A15 Black/White Brake Shutdown -> A11 White Ground when Runing bypass output -> A8 Pink Security Disarm Signal -> this is connected to Lt. Green wire in the Driver Kick white connector. So its missing couple wires to be wireout such as: Encore E1 10 pin connector White/Blue Instant Start Input (+) -> which i have no idea what is the purpose of this wire and where to connect. Gray Channel 3 Trunk Output -> i didnt do it because i dont have a eletronic trunk release, mine is manual pull up type. Blue/Black ACC2 -> because my vehicle doesnt have a second ACC Yellow Ignition 3 output -> again because the car doesnt have it. So, to summarize, the vehicle locks and unlock just as it should through the Encore E1 4-Button remote control, however, the remote start function will turn on the car in the first try but it will only stay on for 5 seconds, then it shut itself off. After, it tries to start it again, and the cycle repeats 1 more time after that, totaling 3 tries. It starts but wont keep on after 5 seconds. What am i doing wrong? what am i missing here? I have no idea whats missing or why this is happening. If someone has an idea, please share with me. Thank you so much.
Connectez-vous pour répondre Voir 1 réponse(s)

19/11/2020

 Toyota ken nguyen (290Pts.)

0

Why the dashboard light turn off after about 20 minutes?

Installed evo one on 2017 Tacoma Tundra with T-harness everything works fine, but at night the dashboard lights turn off after about 20 minutes since the vehicle is running. So the dashboard completely dark not unless I turn off the lights and turn it back on again. I know for sure is the evo one causing the problem. When I completely disconnected the module everything seem to be fine. Please help.
Connectez-vous pour répondre Voir 1 réponse(s)

18/01/2020

 Toyota Greg Berbig (130Pts.)

0

2015 Sienna PTS No Ignition

I am not using a T harness. I have double and tripple checked my wires and even tried reversing the TC and RX wire but when I do the 3x lock it flashes and clicks on the bypass but it does not power the ignition. The yellow light does not illuminate on the bypass. I was able to get the car to start 3 times out of 20 attemps. It was typically right after either programming the module or starting the car, shutting it down and then immediately remote starting it but I cannot consistantly replicate this. Im wondering if there is an issue with the module. I do not have another to swap it out with to try.

I have tried to see if there is a factory remote starter by pressing the lock button 3 times and on the 3rd holding it for 3sec and the car does nothing leading me to believe there is no factory remote starter on it.

The 12 digit service number on mine is 001A06846569

Connectez-vous pour répondre Voir 0 réponse(s)

09/12/2019

 Toyota Mark Spicer (130Pts.)

0

Sienna 2015 Push-to-Start tx - rx wires?

No specs on Tx and Rx wire location for 2015 Sienna Push-To-Start
Connectez-vous pour répondre Voir 1 réponse(s)

05/05/2018

 Toyota John Du (240Pts.)

0

Can Evo-all by itself use remote starter for Toyota Tundra 2015

Dear technical support, I bought an Evo-all and installed on my 2013 Lexus RX350(push start/stop button) the remote starter work awesome. Now I bought one more and going to use for my Toyota Tundra 2015, G-key as remote starter. I just wondering if this unit will work by itself with an option D2 just like my Lexus mentioned above. Thank you for all your help! Regard, Hung
Connectez-vous pour répondre Voir 1 réponse(s)

26/02/2018

 Toyota David Doss (130Pts.)

0

2015 Toyota Tundra alarm triggered on start and won't unlock with keyfob during remote start session.

truck starts with factory keyfob lock press 3x. after it is running, it will not unlock with the keyfob. also, if given time for the alarm to activate, triggering a remote start with factory keyfob lock x3 sets off the alarm. i received unit pre-programmed from a seller. thanks in advance for your help!
Connectez-vous pour répondre Voir 1 réponse(s)

15/01/2016

 Toyota Gram Lockling (190Pts.)

1

2015 Sienna H-Key (as of Jan 2016)

Hi, I'm buying a 2015 Sienna with H-Key (no push button). Will the EVO-ONe (with T Harness) be all that is required to remote start this vehicle or is additional hardware required? Will an H-Key need to be hidden inside the vehicle? Will the LOCK LOCK LOCK function be able to used to start the vehicle remotely? Thank you.
Connectez-vous pour répondre Voir 1 réponse(s)

13/01/2016

 Toyota Brian Eaton (180Pts.)

1

2015 Highlander Autolight and factory disarm issues

We are installing an Avital 5303 with an EVO ALL module. When the vehicle is remote started, it works great, but the factory alarm honks while the vehicle is preparing to remote start and then stops, obviously due to ignition and smart key = factory disarm. Even with D2 programmed on the EVO ALL, it does not stop this. If I use the factory alarm disarm wire during remote start, the vehicle unlocks and remains unlocked. I guess I will have to hardwire the factory alarm disarm wire, even though the EVO instructions say that this issue will be corrected by enabling D2. In addition, the customer always leaves their auto lights on. If you shut down the remote start, the lights stay on indefinitely, until a door is opened and closed. Does anyone know how to correct this?
Connectez-vous pour répondre Voir 1 réponse(s)

12/01/2016

 Toyota patrick coté2 (210Pts.)

0

toyota corola 2015

jai poser un demareur sur une corola 2015 manuel tous mon fillage est bon la sequense de programmation marche et le moteur arret a la fermeture de la porte conducteur mais le demareur flache 3 fois pourkoi?
Connectez-vous pour répondre Voir 1 réponse(s)

03/01/2016

 Toyota Waldemar Dlugozima (130Pts.)

0

How to program 3XLock on Evo One for 2015 rav4?

When the key is in ignition (on), remote on Toyota key not working. How to change function 38 for option 2 with out using remote? Evo One 3XLock for remote start on 2015 Toyota Rav4.Thx
Connectez-vous pour répondre Voir 1 réponse(s)

04/11/2015

 Toyota Rene Laplaine (280Pts.)

1

Sienna 2015 H-Key Doit laisser une clé ?

Bonjour ! Je vais être bientôt proprio d'une Sienna 2015 et j'aimerais y installer un demarreur à distance. Partout ou j'ai appeller on me dit qu'il est necessaire d'avoir une 3ième clé a puce qu'on laissera dans le vehicule pour faire marcher le démarreur. Est ce que le Evo one ou Evo All permette d'éviter de laisser une clé. J'ai regarder les plan et je vois qu'a un moment de l'installation on doit wrapper la clé à puce avec du fil ... est ce que c'est seulement pour la configuration ou bien la clé doit rester wrapper comme sa pour toujours ? Cela doit semblé banale comme question mais je suis un néophyte en automobile :) Merci !
Connectez-vous pour répondre Voir 2 réponse(s)

04/11/2015

 Toyota Rene Laplaine (280Pts.)

1

Sienna 2015 H-Key Doit laisser une clé ?

Bonjour ! Je vais être bientôt proprio d'une Sienna 2015 et j'aimerais y installer un demarreur à distance. Partout ou j'ai appeller on me dit qu'il est necessaire d'avoir une 3ième clé a puce qu'on laissera dans le vehicule pour faire marcher le démarreur. Est ce que le Evo one ou Evo All permette d'éviter de laisser une clé. J'ai regarder les plan et je vois qu'a un moment de l'installation on doit wrapper la clé à puce avec du fil ... est ce que c'est seulement pour la configuration ou bien la clé doit rester wrapper comme sa pour toujours ? Cela doit semblé banale comme question mais je suis un néophyte en automobile :) Merci !
Connectez-vous pour répondre Voir 2 réponse(s)

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer