English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

10/03/2023

 Honda KaPa (320Pts.)

0

Honda CR-V 2016 PTS AT Does not start with cold EVO-ONE

Hi My CR-V 2016 PTS diesel automatic transmission does not start when temps are cold outside. Fortin tries 3 times as programmed, lights turn on, but car wont start. I think issue is that when temps are cold, car usually takes 3-5 seconds depending of temps to prime something before igniting car and i think its not enough for Fortin and it cancels and tries again. When programming Fortin what parameter should i change to wait it out?
Connectez-vous pour répondre Voir 1 réponse(s)

19/01/2023

 Honda KaPa (320Pts.)

0

Honda CR-V 2016 PTS AT starts moving when Evo_One remote started

Hi Great product and super easy installation, thank You. But when I remote start my Honda CR-V 2016 i-Dtec (N16A4) car sometimes does a half wheel turn forward. My model has push button parking shift and it automatically engages when i turn off engine. I guess when it is remote started it remembers settings just before turning engine off as A/C has same temp as when i turned off engine and seat heaters also and if parking gear automatically shifted it will start with same in drive mode and moves until parking shift automatically engages. Should i change some off the settings to get it to start with set parameters and not last used settings? FYI i didnt connect parking lights and horn, because i didnt need them.
Connectez-vous pour répondre Voir 2 réponse(s)

19/01/2023

 Honda KaPa (320Pts.)

0

Honda CR-V 2016 PTS AT starts moving when Evo_One remote started

Hi Great product and super easy installation, thank You. But when I remote start my Honda CR-V 2016 i-Dtec (N16A4) car sometimes does a half wheel turn forward. My model has push button parking shift and it automatically engages when i turn off engine. I guess when it is remote started it remembers settings just before turning engine off as A/C has same temp as when i turned off engine and seat heaters also and if parking gear automatically shifted it will start with same in drive mode and moves until parking shift automatically engages. Should i change some off the settings to get it to start with set parameters and not last used settings? FYI i didnt connect parking lights and horn, because i didnt need them.
Connectez-vous pour répondre Voir 2 réponse(s)

19/08/2022

 Honda Munito (1500Pts.)

0

HONDA CR-V 2018

Hi dudes. HONDA CR-V 2018 wire colors doesn't match. Can I use this colors order instead? Cuz in the scheme only the ignition connector match. Please and thanks you.   https://ibb.co/rsk37g3 https://ibb.co/JkSF2Wv https://ibb.co/vJnQbNR https://ibb.co/5KqkYB5  
Connectez-vous pour répondre Voir 1 réponse(s)

29/01/2021

 Honda Ketch Samson (130Pts.)

0

honda CR-V 2017 LX won't start after installing the module after decryption

iI followed the guide for honda cr-v 2017 lx key start option. and done all the pairing process and the decrytion process, then after that i installed everything back all the pins to car. there is no light on the module awhen all pins were connected back, i went outside my car and tried to remote start my car while looking inside to the module while i press 3 X lock no lights on the module everytime i press the 3X lock start procedure. my car won't start at all. please help thank you!
Connectez-vous pour répondre Voir 1 réponse(s)

17/12/2019

 Honda Timothy Schultz (150Pts.)

0

2005 Honda CR-V evo-one won’t program

2005 Honda CR-V: Evo-one will not program. I completed the flash link with the evo-one and everything is said to be correct. I'm using for both bypass and remote start from factory key. I installed wiring based on the online manual for the 05 crv following connection #2. main 6 pin harness: red to 12v (white) yellow to starter (black/white) Pink to ignition (black/yellow) with the added yellow wire from ignition A plug black is grounded orange accessory to accessory (black/red) white to blue parking lights A plug: yellow to pink ignition, light blue data to white wire on pin two of cylinder harness, and foot brake wire to foot brake (white/black) right above the brake pedal. D plug: the five pin at the key cylinder (blue/orange) was cut. The white green was attached at the key side and white red attached toward hood side as shown. I have power to the evo-one and following the manual to enter program mode by pressing and holding down program button and plugging in power I get the lights going through the flashing sequence, however I do not get the solid red. Am I doing something wrong here or not waiting long enough? Is wiring right? All wiring is soldered connections. I appreciate any help.
Connectez-vous pour répondre Voir 1 réponse(s)

14/02/2019

 Honda Jasminko Corbic (130Pts.)

0

Help with evo one that programs successfully but does not start the vehicle

I have 2015 honda crv push to start. I installed evo one with t-harness THAT-ONE-HON3 rev.2. Followed the guide #57131. Everything programed correctly. I wanna use oem remotes by pressing 3x lock to start my car. However it does not work. Blue light comes on evo one every time I press lock on the remote but does not start the vehicle. No red light. When I start the vehicle manually by pressing the brake and pushing the start button I have a yellow light on the evo one. I hoppe somebody would help me to figure this out. Thanks in advance
Connectez-vous pour répondre Voir 1 réponse(s)

23/01/2018

 Honda Mohammad Odeh (420Pts.)

0

Honda CR-V 2014 Evo one

i have honda crv 2014 standard key , and i am installing evo one with T-harnes 2 and RF2W antina fob , i connect same what is show , i and i follow the instruction solied red then push twich flash red , then pust the key to ignition fast red falshing but the blue light will not show after 10 flashing and even at all all the wires are connected by the T harnes and the orand wire and the pink wire are connected for each connecter 12 pin and the 20 ping , the ground is connected , the only wire is not connected is the fuesed wire which is pin 1 white or brown in the T harness which is said it is output , i never touch the programming yet for the interface of the unit which is still the default setting from the manfacure , any advice or suggestion . ?

 

is the E1 wire with the Fuse should be connected or not , the installation manual it is show 2 diffrent way , i am using the Rev 2 Thar hon 2

 

Service NO 002b07228755

Connectez-vous pour répondre Voir 1 réponse(s)

22/01/2018

 Honda Mohammad Odeh (420Pts.)

0

Honda CR-V 2014 Evo one

i have honda crv 2014 standard key , and i am installing evo one with T-harnes 2 and RF2W antina fob , i connect same what is show , i and i follow the instruction solied red then push twich flash red , then pust the key to ignition fast red falshing but the blue light will not show after 10 flashing and even at all all the wires are connected by the T harnes and the orand wire and the pink wire are connected for each connecter 12 pin and the 20 ping , the ground is connected , the only wire is not connected is the fuesed wire which is pin 1 white or brown in the T harness which is said it is output , i never touch the programming yet for the interface of the unit which is still the default setting from the manfacure , any advice or suggestion . ?
Connectez-vous pour répondre Voir 1 réponse(s)

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer