Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

User

luc ostiguy

Joined on the:

Jan. 11, 2013

Score

910

Comment(s)

11

Voted question(s)

0

Voted answer(s)

2

Votes up

0

Votes down

2

Votes up received

3

Votes down received

0

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

0

Not able to use evo-start2 with evo-all

i use THAR-MAZ1 with evo-all and evo-start2 on a Mazda CX-3 2018 pts automatic. i'm programmed the antenna , i programmed the evo-all . the 3x lock button start and shutdown the car. But the evo-start2 will blink green when receiving a command from my phone but will flash amber just after without starting the car. I tried to reprogrammed a second time. still no luck. What did i forgot ?

0

bcm unit in audi q5 2018

i don't find the bcm unit in the 2018 q5 technik

0

limite de flash atteinte

Je passe mon evo all de mon audi a5 a mon nouveau audi q5. Le module de programmation me dit limite de flash atteinte. Qu est ce que cela veux dire. est-ce qu'on peut le debloquer Merci Luc Ostiguy

0

Ou acheter EVO-START

Ou puis-je me procurer un EVO-START pret de longueuil, ou online. Merci

0

Fortin Evo-All 2011 Audi A3

I'm trying to do a standalone installation of the EVO-ALL on a 2011 Audi A3. All of the wires are connected correctly and I made sure they are making a good connection. I held the prgramming button down and the lights started alternating. I relaesed the button when only the blue LED was lit. I then plugged in the 20 pin, connector, followed by the 6 pin connector, followed by the 5 pin connector. The LED remained blue throughout this process. I then turned the ignition to on. The bule LED went out, then started flasing after a few seconds. I turned the ignition off and the blue LED went out. When I press the factory remote 3X to start the vehicle, the lights flash and the dash lights come on, but it doesn't try to start. It does the same thing a second time and then the EVO-ALL turns off. However, if I sit inside the vehicle and press the brake, it will start the car, but it only runs for 1 or 2 seconds before shutting down. On this particular vehicle, although it uses the regular keyed ignition switch, you still have to press the brake to start the vehicle. Is there another connection that needs to be made for this to work properly? Thank you, Jason

0

Manette Intelligente Audi 3X Lock remote start

Est-ce que je pourrai debarrer les porte en utilisant ma manette OEM ? ou devrais-je utiliser la cle proprement dit?

 

 

La télécommande d’origine du véhicule sera fonctionnelle pendant que

le véhicule est en marche, toutefois, le déverrouillage des portes par la

clé d’accès Intelligente ne sera pas fonctionnel.

1

Stop working Audi A3 2011

I install evo-all and a remote starter in a 2011 Audi a3. It works fine. 2 days after the remote doesn't work anymore. I tried it and manage to make it works with the key near the cylinder. Can the evo-all loose its key programation ? Can i see what is wrong looking at the colored led on the EVO-ALL. Should i reset it and reprogrammed it? Do i need to plug it back to the flash-link programmer? Thank you

0

Audi A3 EPC warning

Depuis que j ai branché le Evo-all dans la audi a3 2011 manuelle le tableau indique une erreur EPC. Quoi faire ????

0

Audi A5 PTS

Est-ce que l'Option 3X Lock va etre disponible sur les Audi A5 2012? je sais que idatastart l'offre. Merci

0

EVO-ALL FirmWare

Hi, On your web site it is note under firmware need for Audi A5 2012 is ALL. In your installation guide it is wrote  Minimum 5. I bought a EVO-ALL and the firmware is 4.18, will it work?

 

Thank you

0

Logiciel pour Flash Link updater

Est-il possible de telecharger et d'installer le logiciel sans avoir le module ? J'aimerais naviguer et voir les options. Merci

0

Is INT-BMW2 needed ina 2005 BMW 325i without PTS

I will use an Python remote stater / alarm combo with Fortin EVO-ALL. I know i have to use the INT-BMW2 with PTS car. But with what about without PTS ? Thank you

1

La voiture s'arrete un fois sur deux quand j'appuis sur le frein.

Mon demarreur fonctionne bien. Quand je m'ntroduis dans mon vehicule, j'inserre ma cl

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue