Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

HELP DECRYPTOR HAS REACHED LIMIT FOR THIS CAR

PLEASE RESET FOR MY EVO-ONE MODULE. I THINK I HAVE ISSUE RESOLVED NOW MODULE S/N 002B04 689431 THANK YOU

0

Help I get this message. DCryptor's limit has been reached for this car.

I had troube getting my keys to program the in the Evo-all. Finally figured out the problem and now it says "DCryptor's limit has been reached for this car" and I can't program my Evo-all. I have the tb-vw, thar-vw1, Evo-start and Evo-all

0

Flashlink not allowing me to program Evo One for Lock/Lock/Lock start up

I have Toyota Venza 2011 with G-Key FlasLink is forcing me to use RFkits while I need to remote start with OEM G-Key (Lock/Lock/Lock) EvoOne with T-Harness Please advise

0

Ford Focus + Evo-One clicking when driving

Hi, I completed the install of the evo one in my 2012 ford focus manual. Everything works in terms of remote starting, but when I’m driving ever time I hit the brake pedal the evo one click 3 times. This can become quite the annoyance in traffic. Is this due to programming, my manual ready mode is set to activate with foot brake and parking brake as I did not purchase the RF kit. If I purchase the RF kit would this stop the Fortin from clicking while driving as it would only start the ready mode sequence after I hit the remote starting button? Thanks

1

Sequence

Bonjour, J'ai un démarreur model FTX 94 installé sur une Nissan Sentra 2021 manuelle avec bouton poussoir. Lorsque je descends temporairement du véhicule (par exemple pour la poste) si j'applique le frein à main, le moteur s'arrête automatiquement lorsque j'engage la première vitesse lorsque je veux repartir. Si je n'engage pas le frein à main, aucun problème. Quelle est la séquence que je dois faire pour pouvoir redémarrer sans que le moteur ne s'arrête lorsque je quitte temporairement le véhicule de façon sécuritaire (avec frein à main) ? Merci à l'avance et Bonne fin de journée

1

Decryptor Limit Reset

I reached my decryptor limit accidentally as this is my first time installing the device and I wasn't instructed that my Q50 would shut off if I didnt press the push to start button twice before putting it in drive. Which caused me to try decrypting multiple times over and over which knocked me over the limit. service #001A07623207

0

2022 Nissan Armada restarts on its own after 5 seconds after turning off!

The car starts fine now with the remote start. But after turning the car off using the button on the dash, the car restarts on it's own after about 5 seconds. Then will turn off and stay off after pushing the dash button again. And now I also have a key fob error on my screen.

0

2015 jeep grand Cherokee PTS using evo all climate shuts off with remote start

Installed an evo all a while ago but customer noticed the climate is off when she starts with evo all 3x lock and start 2 When she uses factory remote start or manual start climate turns on no problem It’s turning the climate off the screen says climate off even though she turns it all on before she shuts Jeep off 2015 jeep grand Cherokee diesel PTS

0

Could you please reset me fortin evo all?

SN: 001A07 610229 Flash limit has been reached and I'm unable to flash a different firmware or go through the dcryptor process.

0

PLEASE RESET EVO-ONE PROGRAMMING REACH LIMIT: SN : 002B04 676425 AND I CANT START BY REMOTE

PLEASE RESET EVO-ONE PROGRAMMING REACH LIMIT: SN : 002B04 676425 AND I CANT START BY REMOTE

0

06 Dodge Ram evo-one with t harness remote starts then locks and shuts off

I have an evo-one with t harness on an 06 ram, having an issue where it’ll start then lock the doors and it’ll shut off then my dash and everything will stay on as if it’s running, if I unplug it and plug it back in it’ll start again then die after relocking the doors then unplugging it and plugging it back in it will let me start with the key. Will provide firmware and review settings tomorrow to see if I have something set wrong

0

2016 sierra 1500 truck wont 3x start

2016 sierra 1500 truck wont 3x start fortin unit is flashed and encrypted i did not wire the on star side of the unit but i do have on star however i dont pay for it . went through the system options and turned on the standalone function still no start .

0

2015 Scion xB Evo-One, no transponder

Installing an Evo One for remote start with t-harness Toy1, vehicle has canbus, but is not equipped with a immobilizer system. Installed per guide #92261, but am not hung up on programming/key sense. Obviously I am going to use a different sequence because it will not get to the flashing blue led, there is no immobilizer (verified key has no transponder chip). Is there another quide for 2015 xB with Canbus but no immobilizer?

0

2009 ford fusion evo all thar for4 vehicle take over

Just installed a evo all thar for4 kit on my 2009 ford fusion the install went well and the unit remote starts but will not turn off with the brake pedal and allow vehicle take over,the only way that I can turn it off is via the button press sequence used to start it. Looking at the wiring diagram i think the only wire that I had to splice together was the 2 yellow wires unless im missing something which is entirely possible.

1

CANNOT ENTER PROGRAM MODE AFTER CHANGING ANTENNA FROM FMH2W TO FM3

Bought a used car that came with an Evo One installed, but no remotes. The car came with an FMH 2-W antenna. I can get in programming mode with this setup using the valet button and get to the quick flashing blue led state. I can do the sequence to forget the remotes and reset the settings. I have bought a remote kit (RFK3641) that came with an FM3 antenna. I disconnected the FMH2W and connnected the FM3 (I know it goes in a different connector on the Evo One). With that installed, I cannot enter programming mode for the remotes. I get the horn after turning the ignition on and holding the valet button. Then I get the horn again after pressing the button once. I hit the brake, but never get the quick flashing LED on the FM3 antenna. Do I have to do anything special when changing from one model of antenna to another?

0

Doors setting for Mazda 6 2016

How can make Mazda 6 2016 in the D mode doors lock and the parking mode doors unlock and I want to close the doors when the car still running support me

0

Mazda-3 2010 Manuel

Bonjour, j'aimerais savoir si ce serait possible d'avoir le guide d'installation d'un Evo-One pour un mazda-3 2010 manuel svp? Ça fait déja plusieurs année que je n'ai pas installé de démarreur dans cette voiture et c'est effacé de ma mémoire! Merci beaucoup !!

0

How can I find out what info should appear on my app and what the different icons do?

I finally got my Evo one and Evo start setup but had a couple of questions. Above the lock/unlock and start buttons are a row of icons that I don't know exactly what they do. Also my fuel shows 0% and my milage shows 0.7m. Any ideas? Thanks.

0

Nissan Frontier factory fob 3x lock to start?

Is there a special process for enabling lock x3 to start for a Nissan frontier? It's offered by competing remote start vendors (probably using Fortin system). I found a guide for enabling via Link software 3x lock to start but the NIS5 guide does not mention it. If enabled via link app in the module, is that all that needs to be done alongside the wiring instructions? The module should have the inputs internally to work it out from what I can see in the diagram. It would be down to the module logic which I don't know the details of.

0

Why do doors show open on Evo start app? Evo one

Starter seems to be working properly and starts when using factory remote 3 clicks with sacrificial key inside the vehicle. The app is showing voltage and temperature from the vehicle but it also shows that all 4 doors are red as if they are open.  Start function and lock/unlock work but I cannot stop the engine from the app screen.  Am I missing something? 

Thanks.<!--/data/user/0/com.samsung.android.app.notes/files/clipdata/clipdata_content_241119_181735_746.sdocx-->

0

RFK912 and RFK942 2way Remotes Responds how?

Hello People RFK912 and RFK942 2way Remotes Responds how? Please clarify (flash&beep) Thanks

19/11/2024

FAQ Chitos (380Pts.)

0

EVO Start LTE what Evo RF kits will work together

Hello people: What EVO RF kit can be combined with EVO Start LTE on an ALL or ONE unit with no issues in the operation in both APP and remote. Thanks,

19/11/2024

FAQ Chitos (380Pts.)

0

EVO Start LTE what Evo RF kits will work together

Hello people: What EVO RF kit can be combined with EVO Start LTE on an ALL or ONE unit with no issues in the operation in both APP and remote. Thanks,

19/11/2024

FAQ Chitos (380Pts.)

0

EVO Start LTE what Evo RF kits will work together

Hello people: What EVO RF kit can be combined with EVO Start LTE on an ALL or ONE unit with no issues in the operation in both APP and remote. Thanks,

0

VW Jetta 2015 - No Key even after Decrypt seems to have worked fine

I have installed a EVO ALL on a Jetta 2015 TDI (Push Start - Automatic).  I have the EVO ALL, THAR-VW1 and TB-VW installed as per instructions (I decided to skip the trunk release wiring as I didn't find the feature useful for me case).   The EVO All is programmed with Diesel Option enabled and it went through the Decryptor without any issues.  

When I press the 3 lock sequence,  the dash lights up (I had a previous problem that now brought me up to this point) but the dash says 'NO KEY'.   The car starts if I get the key in the car,  but not if the key is not in the car.   I was wondering what could be the problem.  The only item that I was wondering is that I reprogrammed (changed options) on the EVO ALL but didn't run the decript after,  would this cause this issue?   The car is store off site so I will drive in the morning and try this.   But what other issues could this be?

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue