Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

20/11/2024

 Nissan Nikola Malicevic (130Pts.)

0

Nissan Frontier factory fob 3x lock to start?

Is there a special process for enabling lock x3 to start for a Nissan frontier? It's offered by competing remote start vendors (probably using Fortin system). I found a guide for enabling via Link software 3x lock to start but the NIS5 guide does not mention it. If enabled via link app in the module, is that all that needs to be done alongside the wiring instructions? The module should have the inputs internally to work it out from what I can see in the diagram. It would be down to the module logic which I don't know the details of.
Login to reply View 1 answer(s)

03/11/2024

 Nissan Tu Le (440Pts.)

0

what is the option to set for the car to locked and shutoff the parking lights after the remote start timeout (15mins).

Vehicle: 2018 Nissan Rogue Sport SN: 001a07 531903 Problem: remote start the vehicle (3x locks), car started with no issue. However if I don't make it to the car after 15mins, vehicle shutoff as expected, but the vehicle has unlock and parking light kept stay on and kill the battery. Is there setting on this unit to prevent this 2 issues. (locked after shutoff and turn off the parking light) Appreciated your help!!!
Login to reply View 1 answer(s)

17/11/2024

 Nissan cary ostgard (130Pts.)

0

Dcryptor limit has been reached on this car. Can i have it reset?

SN: 001A07526844
Login to reply View 1 answer(s)

13/11/2024

 Nissan Green (130Pts.)

0

Could this remote start make body control module failures?

I had this remote start since 2018, Last week I went to local nissan dealer for a extra key and key programming, after they attempted, the technician told me the body control module was failure because the after market fortin remote start, so I needed replace BCM, were they correct? And can I put remote start module back?
Login to reply View 1 answer(s)

08/11/2024

 Nissan mobilesolutionsar (280Pts.)

0

2016 Nissan Altima PCM humming sound and park lights staying on

Installed compustar alarm with remote start using a EVO-NIST4 and diagram75491, d2d cable being used. For some reason the PCM is humming and the park lights are on, what can be the issue? Do I change out the power wire fuse to a 1 amp since it comes with a 30 but I am not using those, just the D2D as the diagram says.
Login to reply View 1 answer(s)

19/10/2024

 Nissan drrckh1 (130Pts.)

0

what's the best setup for a 2010 370z manual push button start

I'm looking for a remote start alarm with LTE functions for a 2010 370z
Login to reply View 1 answer(s)

08/10/2024

 Nissan Stephane s (130Pts.)

0

refus de demarrer

Bonjour, je possede un Altima 2009 Manuel. MA batteries est timber vide. apres une recharge complete , Mon vehicle ne demarre plus, et ne reconnais plus MA pedale d embrayage, malgre que j appuie dessus
Login to reply View 0 answer(s)

27/10/2023

 Nissan Moike (580Pts.)

0

rf 442 programming guide for evo one

I've been trying to add rf442 to my nissan rogue , Once the atenna starts to flash I press the [+] button follow by the lock button, but the remote doesnt program. Am I pressing the wrong buttons? Thanks
Login to reply View 2 answer(s)

02/06/2024

 Nissan Michael Matthews (210Pts.)

0

2015 Titan horn chirp

I am trying to get the horn to chirp on remote start, as well as locking. 2015 Nissan Titan EVO-ONE Ser 002b04275287. I measured the orange/black for a -ve pulse, and do not see anything. Am I missing an option?
Login to reply View 1 answer(s)

20/03/2024

 Nissan Jpbforex (130Pts.)

0

evo-one-nis5

Bought from a ebay seller selling your stuff. I contacted them an they said plug and play so i bought. Well i got it hooked it up tried to program and i get yellow light on and turn key and the red light dont come on to program. I did hook it up to my computer with the flah device and programmed it and flashed it. Still nothing. Ebay seller has been giving me a run around saying its your problem not theres. I just need some troublshooring help toi get it to work. The ebay seller then told me i needed a rf so i got one of them from them and re flashed the device for it installed it back in and still does nothing. Whats best way to get help troublshooting
Login to reply View 1 answer(s)

12/03/2024

 Nissan Devin Stites (160Pts.)

0

Nissan 2020 NV2500 20 pin connector location

The purchased wiring plan does not have a location or picture for a 20 pin connector which has the emergency brake, dome light and truck pin, please help with location and any other knowedge. Thanks
Login to reply View 1 answer(s)

10/03/2024

 Nissan ERIC M (430Pts.)

0

2019 Qashqai vehicle has no crank no start when the module is plugged in.

2019 Nissan Qashqai, automatic, key-start. Installed Evo-all with T-harness. Stand alone install. Evo-all programmed fine. Got the correct lights when programming, dcryptor went through fine. Installed the module back in the vehicle after dcryptor, the vehicle will not crank / start. Unplugged module, left the t-harness connected, vehicle starts fine (with a bunch of codes). Cleared the codes, re-installed Evo all module, no crank / no start. Also, the evo-all module does not light up / respond to the vehicle FOB (I.e. no light flashes when pressing lock or unlock) Things I have done so far: checked t-harness (pin location, made sure plugs are seated properly). Removed t-harness, vehicle starts fine, re-installed t-harness, vehicle starts fine, re-installed Evo all module, same issue, no crank / no start. Downgraded firmware to minimum, no changes. SN 001A07 284515 Current firmware loaded - 72.52 I have not tried to replace evo-all with a different one. Could the evo-all module be bad? Thanks.
Login to reply View 1 answer(s)

06/02/2024

 Nissan Rick Whitfield (360Pts.)

0

EVO ALL GUIDE #105331 - Confusing Language

Installing stand-alone on a 2020 Nissan Frontier PTS. The Frontier has a factory hood switch for alarm functions. The config / options section of the guide states to set A11 to OFF if no hood pin. Does this imply to set A11 to ON in this circumstance? And I assume the blue hood pin wire is moot in this situation, or does it require grounding as the full diagram illustrates? A little confused on the intent.
Login to reply View 1 answer(s)

22/01/2024

 Nissan RomanoDood (130Pts.)

0

Fortin EVO-ALL 2015 Nissan Rogue - Locking/Unlocking While Driving

Just installed an EVO All with the Nis3 Harness last night. While driving the car the unit unlocks and locks while flashing the turn signals every few seconds. I am curious as to what this could be. I've updated all firmware and enabled all unit options that were in the install manual. What could this be?
Login to reply View 1 answer(s)

18/01/2024

 Nissan Hasse Blom (130Pts.)

0

R35 GT-R 2015 push to start only lights turn and no engine start ! I have EVO -NIST1 !

Hello

We have problems installing EVO-NIST1 on a Nissan GTR 2015 and we have followed what fortin said on the instructions and it dont work and also the the instructions fortin has for finding out whats wrong but i dont work as it should !

Between this 2 instructions there is different diagrams with the 2 instructions and that do not make it easier and when plugging in the box should the button be push down or not ?

When programing folloving the lights and the instructions the lights jumps over steps !?

What flash should be used standalone or the other one !?

when pushing the button 3 times only lights but no engine start it never even try to start !?

When disconecting the box every thing works normal.

EVO-ALL number SN: 001A07 535353

Can any one help us in any way to sort this out !

Login to reply View 1 answer(s)

13/01/2024

 Nissan Nite Rider USVA (130Pts.)

0

please reset my flashlink 002505 112508

which version should i be using for my 2020 Nissan Frontier push to start?
Login to reply View 1 answer(s)

04/01/2024

 Nissan Justin Lundy (130Pts.)

0

Stuck on Step 4

2012 Nissan Rogue Intelli-key using T harness NIS 2. I cannot get passed step 4. The yellow light never flashes it doesn't change at all after pushing button any amount of times. I went through the troubleshooting guide and I don't have power on yellow wire, I also reversed the can-bus wires which didn't help. The fob was placed 40 feet away inside the house next to the spare keys we have for this vehicle.
Login to reply View 1 answer(s)

02/01/2024

 Nissan pointzeroautosound (130Pts.)

0

2015 NISSAN ROUGE PTS ALARM SETS OFF AFTER STARTER SHUTS DOWN

T-HARNESS was used with an EVO-ALL. After 15min run time the vehicle shuts down and the factory alarm sets off. Is there a setting that can avoid the factory alarm triggering?
Login to reply View 1 answer(s)

24/12/2023

 Nissan donney harry (130Pts.)

0

hi my dcryptor limit reach on evo all NIST4 SN:001A07 466615 how do i reset ,thanks in advance

my evo one dcryptor limit reached error is showing .please help reset
Login to reply View 1 answer(s)

09/12/2023

 Nissan Markwilkinson (130Pts.)

0

Need help selecting an alarm for 2019 Nissan NV 200 Cargo Van

Hello Tech Support, I am in need of your help, kindly assist me with select an alarm that will be Plug and Play for my 2019 Nissan NV200 Cargo Van. I would like to have 4 buttons on the remote ( Cargo door, unlock , lock and remote Start/panic), remote start can also be accepted. Thank you in advance. My email is markwilkinson805@hotmail.com
Login to reply View 1 answer(s)

09/12/2023

 Nissan mobilesolutionsar (280Pts.)

0

Does the lock and unlock wires go into the listed empty slots on a 2019 Nissan Armada using the Evo-Nist1?

The guide says that the lock and unlock wires go into an empty slot.
Login to reply View 1 answer(s)

09/12/2023

 Nissan jamesedwardmunroe2@gmail.com (130Pts.)

0

Site states they are "not accepting consumers" so I cannot login after having registered.

Site does not allow me to login after selecting consumer. The harness is installed, but I cannot program now. Thanks, Jim
Login to reply View 1 answer(s)

08/12/2023

 Nissan jose colon2 (190Pts.)

0

2018 NISSAN TITAN XD PRO DIESEL sn 001A07349178 FIRMWARE 72(54) FLASH LIMIT

please i need EVO ALL master reset SN 001A07349178
Login to reply View 1 answer(s)

06/12/2023

 Nissan alexonti (130Pts.)

0

evo-one will not save new change settings

evo-one will not save changed settings to module. I click save options and get confirmation and updating bar to 100% complete. but when I check current settings. the changes made are not selected and I have repeat the process. Then I uninstalled and reinstalled the flashlink manger and completed the programming a few times.Still no luck of the changes being saved to the module. How do I change and save setting to module.
Login to reply View 1 answer(s)

04/12/2023

 Nissan albert arroyo (130Pts.)

0

compatibility of EVO -All with 2007 NIssan Pathfinder with regular key

According to your Site it shows as an option to use the EVO rs4 with Evo-All module. is that correct ? and can i use it as a remtote start or will i need to use the other Version which i think is a EVO ONE?? i also purchashed the T harness NIS5
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue