Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

2015 Malibu will not shut down after remote start

2015 Malibu flip key. Evo all gmt1 installed. Vehicle starts correctly with 3x lock. Then will not shut down and will shift and drive without key in the ignition. It will then run indefinitely. Does not shut down after the 15 minute run time. Can not stop the engine from running unless I actually unplug the evo module from the vehicle. While running the red light is on on the evo and does not respond to the key being inserted into the ignition, the brake pedal or the fob. Brake lights function correctly on the car. sn: 001A07 065502

0

CX9 not completely turning off.

I have a 2019 CX9 with an EVO-One installed everything works pretty well with the remote start but every so often I have an issue when I park and push the button to turn off the car. The engine stops but the car says the ignition is still on.Pressing the button a few more times usually fixes this but, this morning I had to disconnect the battery on the car because the ignition tamper alarm was set. Any ideas of a fix for this?

0

Remote starter wont shut off

When adding 0.50 firmware to enable Drone installation the car wont start with the remote start. It just cranks but wont start. When starting with the key, it will start but then not shut off. All dash MIL's stay lit. In order to shut off I have to initiate a start via the remote while it is still running. That shuts the car off but begins to start it again until I hit the unlock bitton.then the system disable. These episodes only arose about 5 months after the install and worked great daily. I re-flashed the unit and it works fine until i add the 0.50 firmware to enable drone install. I would like to keep the Drone add-on. What are my options?

1

Engine won't shut down, now red/blue flash at last step

CHRT-5 with T harness installed in 2012 Jeep Wrangler auto as stand alone. After 2 days, engine would not shut down when key removed or 3 push on remote. Reset, flashed and reinstalled, when I get to last step, blue and red led alternate and engine will not shut off with key removed. Can only stop engine if unplug evo. I tried Master reset, I have flash link , updated and flash options again. What do I do next?

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue