Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

2016 Kia Soul. Remote start isn't engaging. Fortin Evo One

Having problems with the Evo One not kicking the remote starter on. Programming was did right Im assuming, the can connections are correct assuming becuase i was getting the flashing blue led and such when programming. I do not have the EMS wire so i did use option 2 in the installation diagram. Hit the oem remote 3 times but nothing. Not sure what needs to be checked in the firmware updater though. Kinda stumped and help would be appreciated.

0

Starter engages across ACC with key after remote start

Remote start ok, door unlock ok, key in ignition, roll past ACC to run, starter engages, roll back past ACC, starter engages, Fortin ignition harness-2 way remote Evo one,

0

2016 kia soul canbus

On the evo one remote start is hooked up through can bus but seems to have a hard time with lock and unlock function . My question is if I have the can bus hooked up can I also hard wire the triggers in or is it one or the other when being installed

0

2016 kia soul evo one alarm options settings not saving when taping save .

I was going through the alarm settings on the evo one and when i hit save it dosent seem to save it .The setting im talking about is option 24 i click on disable hit save and it goes back to 24.3.. tried it a few times keeps doing it.Im also trying to enable option 37.2 also saved to device . Unplugged device reinstalled tested it out. Are these 2 options related in some way or is there something on the bypass side that needs to be done .. on the remote start / alarm side of the evo what options would work well together or is it some option you cant have on or actived at the same time. Basically what i was tring to do is this . If the door was open by key fob car would stay running.By option 37.2 enabled. if someone opened the door by inside handle car would shut down . I have changed setting back and fourth a few times and not to sure what options should be on or off at this point any help is greatly appreiated

0

2016 kia soul standard key evo one unlock does not unlock trunk at all times

All locks work priority unlock drivers side double tap unlocks all doors except trunk it seems it has a hard time is this a settings issue program issue

0

2016 kia soul standard key aux wire placement for rear defrost and programing options.

Looking for wire placement for the aux function for the rear defrost. wire color says White Dash fuse box, plug (E) pin 16 . But no picture on wire color .To verify i have the right connector .Could i just tap into the switch itself or is it at this pin because its after a relay.The aux wire on the evo one is a neg output does that mean it has to go on the neg side of the wire or does this need a relay to change output to correct trigger. Also what programming setting would be the best to use. Testing rear defrost to see if latched or pulsed is itbest to check at switch or from the rear defroster itself.

0

2010 Kia Soul Programming problem

Having an issue with 2010 kia soul with normal key, wired up correctly but has no immoblizer wire, do i need to connect red connector to white connector wires still. Instructions aren't very good on this point. It says "US models: if the (~) Data wire is not present the vehicle is not equipped with an immoblizer. For CAN functions use programming #2.  I have tired programming to #2 and blue light is on then wihen I turn the key on blue light goes out and doesn't flash at all but when I turn the key off blue light comes back on.  It does not flash at all.  Please Help. No remote start installed. Using as standalone.  CAN Bus wires good 2.5v on each at all times.

25/09/2016

Kia SC (160Pts.)

0

Evo-One not programming door locks on 2013 Kia Soul (key start - uses a key)

I've installed an EVO-One in a 2013 Kia Soul (has a normal Key to start vehicle). The install was very simple, I did not that there is an error in the guide regarding the can bus. In this car, pin 6 (can high) is a blue wire, pin 14 (can low) is a red wire. Initially I had only followed the color code and the unit would not learn the can bus at all. I reversed the wires when I noticed the wires where reversed and the unit was able to learn the red (brake signal). It is not able to learn the door unlock / lock from the can bus, and during the programming sequence, I never had the flashing blue sequence to learn the door locks. I'm unsing a Fortin RF KIT 2W (RF642W). I'm able to remote start the car, but once started, the OEM remote is unable to unlock the doors ( I need to use the key in the door cylindre). The fortin RF kit is also unable to unlock / Lock the doors. I also can not stop the vehicle remotely, only by letting the time expire or pressing the break. Appreciate any help.

1

2016 Kia Soul EX base

I was not able to see any information with regards to the 2016 Kia Soul, I am looking for information on compatible products and installation. I am looking at the EVO-ONE with the THAR-ONE-KHY2, Will this product be compatible with the 2016 Kia Soul EX? It is my understanding that this unit with the T Harness would basically be plug and play without splicing any wires to the vehicle. This would allow me to wire an remote starter to the EVO-ONE that would allow for remote start/Alarm without any additional modules needed. Please advise

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue