Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

evo one compatible with 2001 mdx ?

Fortin EVO-ONE EVO-ONE All-in-One Remote Start, Security & Data Interface compatiblity with acura mdx 2001

0

evo one compatible with 2001 mdx ?

Fortin EVO-ONE EVO-ONE All-in-One Remote Start, Security & Data Interface compatiblity with acura mdx 2001

04/10/2021

Toyota rey g (300Pts.)

0

anyone knows 2001 toyota echo wiring diagram?

hi...is there anyone know whats the wiring diagram for 2001 toyota echo..thanks....

29/03/2021

Toyota Jim (850Pts.)

0

Hardwired EVO-ONE in 2001 Tacoma with RFK411 unable to send two unlock pulses to unlock all doors.

My EVO-ONE is hardwired into a 2001 Tacoma. I seem to be unable to send two quick unlock pulses with the RFK411 remote to unlock all doors. There has to be a slight pause between presses in order to get two unlock signals. Unfortunately, if you wait too long, you will not unlock all the doors. Consequently, it is hit or miss to get all doors unlocked. Is this a property of the remote to have this refractory period or a property of the EVO-ONE. If it is the remote kit, is there another one you recommend that does not have this refractory period. If it is a property of the EVO-ONE, can new firmware correct this or is there an older firmware that corrects this. I have tapped into the driver side key switch that will open all doors when the key is turned twice. My plan was to put a relay to control the actuator so that the first press opens the driver door and the second press opens all doors. Before I install the relay, I wanted to see if the two press unlock will work.

0

3 X Lock engine start on 2001 lexus ES300

Working on a 2001 Lexus ES300 and using guide #58481. Is there an updated version of the software which will support the 3 x lock to start the car without using an additional fortin remote kit? 

 

Thanks.

 

0

wich wire for tach on 2001 silverado duramax?

i have a silverado 2001 6.6l duramax wich i install a remote starter but i need a tach signal for the duramax, in the wirecolor diagram the engine shown is a gas model with tach on coil, where should i take my tach signal on a diesel? or should i go tachless with a 20second timer before start programmation?

0

can evo All 3x start a 2001 town and country van?

Hi, Can the evo-All do stand alone 3x lock start with the oem remotes for the 2001 town and country? I programed the unit and it stated 3x start option that I loaded, but I'm not sure what guide to use to wire into van. Guide # 3317 shows a remote start unit used to wire up? Is there another guide to use for stand alone 3x evo All? Thanks, Steve

0

What is the wire diagram for a 2001 toyota avalon

I am looking for the wire diagram for a 2001 Toyota Avalon.

0

Installing a new evo one on an 01 F150 and wire color for the TX Data wire does not match what you say it should be.

I was able to find a wire matching the RX Data Grey/Orange so hopefully that wire is the correct one. but the TX Data wire is supposed to be white/lt green and there are no wires that color there. The alt color is purple but can't find that one either so hopefully you have something updated that can help me with this installation. Thanks, Dwayne

0

OEM key fob does not work after car is remote started

Installed EVO-One and 642W long range remotes. Programmed  using 1 OEM key and Decryptor. The remote start works with the long range remotes, but when remote started the OEM key fob does not work. I must use the key to manually unlock the door after car is remote started. When I use the OEM remote the blue led on the EVO-One does not blink. 3X Lock on OEM remote will not start the car. The long range remotes are not able to lock or unlock the doors.   Also sometimes when remote starting the car the starter stays engaged after the car starts and the starter will continue to grind until I press the brake and disengage the remote starter.  

1

What option is best for Viper 5706V?

I am trying to figure out what the best route forward is for doing an install of a Viper 5706V in my 2001 Silverado. I looked at what your site states but am really at a loss as to which is the best option and which is compatible with the Viper alarm. I am confident that I should be able to handle the install I just want to be 100% certain I get all the required bits up front. Any advice you could share would be much appreciated. Cheers, -Stephen

29/01/2017

Toyota Jim (850Pts.)

0

Can EVO-ALL be used as an alarm for a 2001 Tacoma and if so what guide.

I am wanting to use the EVO-ALL in a 2001 Toyota Tacoma as an alarm with an external RF Antenna to control the door locks and an Avital 4113 remote starter I plan to integrate with it. The vehicle does not have an alarm or remote natively with it. The Avital remote start will be hard wired to the EVO-ALL since I am using an RF kit. The question is what guide and what firmware should I use for the unit to make this is possible. Thank you.

09/04/2015

Toyota Jim (850Pts.)

0

Evo-One install guide 2001 Toyota Tacoma

I am planning to do an install in a 2001 Toyota Tacoma. The Evo-One with the Thar-One-Toy2 harness is what is recommended from your web site but I am unable to find a corresponding install guide. What are your recommendations.

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue